process measurement Articles

  • Harmony’s Proven Process

    Many companies have a proven process that outlines their product development, testing, manufacturing, and quality control measures.  Some even go as far as to have these processes put under intense scrutiny by outside agencies.  Even with these processes documented and evaluated, very few are able to conform to high international standards like those set forth by ISO. What about the ...


    By Harmony Enterprises, Inc.

  • Closed Circuit Coolers: Design with winter in mind

    When outside temperatures fall below freezing, water inevitably forms into ice. Open cooling towers can be susceptible to freezing due to their inherent nature of operation. As a result, ice formation becomes a subject of management, not elimination. Fortunately, there are alternative solutions. Closed circuit coolers are used for a multitude of niche applications, but are ideal for evaporative ...


    By Evapco Inc.

  • Application Report - Process Measurement Technology

    Untitled Document ...


  • Digital sensors are revolutionising process measurement technology

    Summary Digital sensors connected to standard controllers simplify the installation and operation of process measurement technology and cut investment costs, as far fewer controllers are needed. Entry into this “digital world” is simplified by analogue input cards, which can be used to integrate existing measuring instruments. No matter how the demands on the plant technology change, the ...


  • New Process Gas Analyzer for the Measurement of Water Vapor

    KEYWORDS TDLAS, WMS, Laser Spectroscopy, Water Vapor Measurement, Gas Analyzer ABSTRACT A new analyzer for the measurement of water vapor concentration based on Tunable Diode Laser Absorption Spectroscopy (TDLAS) was developed. The water-vapor line at 1854-nm was selected for the measurement, and the performance of the system was evaluated on different ...

  • Real Time Measurments of Acetylene in Ethylene Manufacturing Process

    Keywords Tunable Diode Laser, Wavelength Modulation Spectroscopy, Analyzer, Acetylene, Ethylene, Acetylene Converter Abstract The analyzer, based on near infrared Tunable Diode Laser Absorption Spectroscopy (TDLAS), was developed for the measurement of acetylene in process streams. Measurements of acetylene were made as under laboratory conditions and in ...

  • Schedule performance measurement based on statistical process control charts

    In a job–shop environment, achieving a schedule that is on target is difficult due to the dynamism of factors affecting the system. In this paper the Shewart's Individuals control chart is applied to a scheduling process for the purpose of measuring schedule performance. The charts are applied to monitor the deviations of actual from scheduled process times for jobs on a process machine. Data ...


    By Inderscience Publishers

  • Comparing Functional Assessments Of Wetlands To Measurements Of Soil Characteristics And Nitrogen Processing

    Abstract: One beneficial service of wetland ecosystems is the improvement of water quality through nitrogen (N) removal. However, one important N-removal process, denitrification, can produce the atmospheric pollutant nitrous oxide (N2O). Wetland biogeochemical functions, such as N processing, can be assessed by the hydrogeomorphic (HGM) approach using a suite of simple field observations made ...


    By ENVIRON

  • Integrate noise measurements into your existing Process Monitoring and Control Systems.

    The ZE:908 is a small and lightweight power supply and acoustic conditioning unit for the Cirrus MV:200 microphone preamplifiers and MK:170 Outdoor microphone units. Many industrial plants have a variety of process sensors strategically placed around their site so that safety, environmental impact and efficiency can be monitored and managed, in real time, from one or more control rooms. The ...


    By Cirrus Environmental

  • A novel spectrometer design for process and handheld infrared spectral measurements

    Introduction Infrared spectroscopy offers many unique advantages for measurements within an industrial environment. Historically, the technique has been used for a broad range of applications from the composition of gas and liquid mixtures to the analysis of trace components for gas purity analysis. In cases where a well-defined method of analysis is involved, such as the measurement of ...


    By CIC Photonics, Inc.

  • Efficiency of Process Measurement Technology for Determining Nutrient Parameters – Yesterday, Today and Tomorrow

    Abstract The costs and benefits of process measurement instruments in sewage treatment plants were the subject of intensive debate in the 1990s. Cost-benefit studies, comparing the potential savings in energy, consumables and personnel with the additional costs of using the instruments, resulted in recommendations specifying the minimum sewage treatment plant size at which the use of such ...


  • Ultrasonic density measurement of uranium loaded organic phase in solvent extraction process

    The application of ultrasound technique in density determination of uranium loaded organic phase in solvent extraction can provide a unique solution for online density monitoring of process streams. Earlier various authors have investigated the density measurement of liquid by single ultrasound frequency. In general standard reference liquid (having low viscosity and density) is used for ...


    By Inderscience Publishers

  • Cellular ATP – A Superior Measure of Active Biomass for Biological Wastewater Treatment Processes

    Biological wastewater treatment processes harness the ability of microorganisms to break down and assimilate organic compounds that, if left untreated, cause detriment to the environment. Although this process occurs naturally, engineered systems are used to accelerate the process by optimizing bioreactor conditions to promote higher-than-typical biomass concentrations, thus increasing the rate ...

  • Analytical Devices for the Measurement of Water Vapor in the Natural Gas Process and Transmission Industry

    ABSTRACT The determination of water vapor (and water dew point) is crucial in the processing, custody transfer and transport of natural gas. High levels of water vapor in a natural gas stream can lead to a number of problems which include the formation of hydrates and the contribution to freezing and corrosion of plant and equipment. There are a number of ways of determining the water vapor ...

  • Measurement of Oxygen in CO Boiler of FCC Process – Case Study

    Background Fluidized-Bed Catalytic Cracking (FCC) is the most important and widely used refinery process for converting low value heavy oils into more valuable gasoline and lighter products. Application Description The catalyst is covered with carbon (coke) from the cracking reaction which lowers its activity. Therefore, the catalyst is fed to the ...

  • Processes that Bind

    The 'triple bottom line' (1) is rapidly gaining recognition as a framework for measuring business performance. In its broadest sense, the triple bottom line captures the spectrum of values that organizations must embrace - economic, environmental and social. In practical terms, the triple bottom line means expanding the traditional company reporting framework to take into account not just ...


    By Fluor Corporation

  • Deep Well Measurement

    Pulsar's superior echo processing was proven once again in this difficult very deep Welsh wet well application featuring a 23m 'shot' that needed to follow the level between the heads of two submersible pumps. The reliability and versatility of the advanced echo processing technology in Pulsars non-contact ultrasonic range has been utilised at the SwanseaWasteWater TreatmentWorks, in a 23m deep ...

  • Wastewater Level Measurement Techniques

    Level monitoring and control is a fundamental requirement in any wastewater treatment process. You will find level instrumentation installed at even the simplest treatment plants for pump control, chemical storage tanks and process level controls or alarms. Operators have only limited or emergency control over treatment plant influent, so level controls and instrumentation play an important role ...


    By Greyline Instruments Inc.

  • ppm Dissolved oxygen measurement

    Dissolved oxygen (D.O.) levels are used as a general indicator of water quality. Oxygen is essential to life and vital for countless aquatic forms. D.O. level control is critical in numerous applications ranging from the monitoring of industrial waste water to environmental surveillance. What is Dissolved Oxygen? Dissolved oxygen (D.O.) is the amount of oxygen gas dissolved in a ...


    By IC Controls Ltd.

  • Application notes - viscosity measurement

    Most laboratory viscometers employ the well-known principle of rotational viscometers to measure viscosity by sensing the torque required to rotate a spindle at a constant speed while it is immersed in the sample fluid. This is because the torque, generally measured using the reaction torque on the motor, is proportional to the viscous drag on the immersed spindle and thus the viscosity of the ...


    By Sensor Technology Ltd

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you