process plant emissions Articles

  • H2S Emissions Control at Geothermal Plants

    The LO-CAT® II process is used to control H2S emissions and reduce odors at geothermal power plants. Geothermal steam, considered to be a clean and environmentally friendly source of energy, is produced when water seeps into high temperature, high pressure formations below the earth's surface. The steam is brought to the surface through production wells and then expanded through a turbine to ...


    By Merichem Company

  • Methane Emissions From Terrestrial Plants

     In a recent issue of Nature Keppler et al. [2006] report the discovery that terrestrial plants emit CH4 under aerobic conditions. Until now it was thought that bacterial decomposition of plant material under anaerobic conditions, such as in wetlands and water flooded rice paddies, is the main process leading to emissions from terrestrial ecosystems. In a first attempt to upscale these ...


  • Controlling Pharmaceutical Coating & Drying Process Emissions

    Capturing and destroying harmful emissions from pharmaceutical processes can be challenging. It’s not because the volatile organic compounds (VOCs) are difficult to destroy using catalytic or thermal techniques. It’s because their concentrations can be so high. These process streams raise safety concerns, both when they’re collected in vents and when they reach the final ...

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Results of the Application of a New Laser Based Open-Path Spectrometer for the Measurement of Fugitive Emissions From Gas Processing Plants

    Abstract In this paper, we present results from field studies of the application of a new laser based spectrometer incorporated with real-time dispersion modeling techniques to measure fugitive emissions from gas processing facilities. While open-path FTIR spectrometers can measure a variety of gaseous species, they suffer from the drawbacks of being large, expensive and of limited range. Also, ...


    By Boreal Laser Inc.

  • Nitrous oxide emissions from one-step partial nitritation/anammox processes

    Measurements of nitrous oxide were made at pilot- and full-scale plants to evaluate greenhouse gas emissions from one-step partial nitritation/anammox processes applied in moving bed biofilm reactors treating reject water. It was found that 0.51–1.29% and 0.35–1.33% of the total nitrogen loads in the pilot- and full-scale reactor, respectively, were emitted as nitrous oxide. Between 80 and 90% ...


    By IWA Publishing

  • Modeling Greenhouse Gas Emissions From Activated Sludge Processes

    Dynamic simulation of activated sludge process is a common tool for wastewater treatment design and optimization. Most activated sludge models predict only the uptake of BOD and nutrients, however, they can easily be supplemented with further information regarding greenhouse gas (GHG) production to predict the generation of components such as CO2. Many published anaerobic digestion models contain ...

  • Wastewater treatment process impact on energy savings and greenhouse gas emissions

    The objective of this research was to assess the energy consumption of wastewater treatment plants (WWTPs), to apply a mathematical model to evaluate their carbon footprint, and to propose energy saving strategies that can be implemented to reduce both energy consumption and greenhouse gas (GHG) emissions in Greece. The survey was focused on 10 WWTPs in Greece with a treatment capacity ranging ...


    By IWA Publishing

  • Emission Control Strategies and Technologies for the Chemical Processing Industry: An interview with Chris Anguil

    AC: Could you please provide our readers with a brief introduction to the industries that Anguil Environmental works within? CA: Our thermal and catalytic oxidizer systems are applied on any industrial process that is regulated for Volatile Organic Compounds (VOCs), Hazardous Air Pollutants (HAPs) or Nitrogen Oxides (NOX). Some of these industries include chemical ...

  • The Use of Particulate Emission Monitors to Support Arrestment Plant Operation and Upkeep

    The operation of filtration type arrestment plant can be optimised by the effective use of Particulate Emission Monitors (eg Filter Leak Monitors and Filter Performance Monitors). Particulate Emission Monitors are installed throughout the broad spectrum of industrial processes to satisfy regulations (IPPC, Part B Guidance Notes, WID and LCPD) for emission limit enforcement. In addition, where ...


    By PCME Ltd

  • Wastewater Treatment Plant Installs Covers & Scrubber System to Control Odor Emissions

    Twenty-five miles west of Dayton, Ohio is the county seat for Preble county - Eaton, Ohio, population 8,000. As the only city in this largely rural county, Eaton finds itself the focus of residential and commercial development transforming it into a bedroom community for Dayton as well as Cincinnati 50 miles to the south. Participating in this transformation is the Eaton Wastewater Treatment ...


  • An Introduction to the Topic: Controlling Mercury Emissions from Coal-Fired Power Plants

    Untitled Document Mercury is a hazardous air pollutant (HAP) that circulates around the globe for a year before depositing back to ...

  • A new way to measure emissions from China’s Coal-Fired Power Plants

    To prevent the most severe impacts of climate change, it is essential to limit fossil fuel use—particularly coal use in power production. The share of coal in global energy consumption is increasing, with ...

  • The Whole Plant Approach to Air Emission Modeling for NESHAP Compliance

    ABSTRACTLong overlooked, the air emissions associated with biological treatment of process wastewaters continue to be further scrutinized and regulated. The common approach is to utilize EPA’s Water9 as a model to present findings and support permitting activities. It is essential when using a model that not only is the facility modeled appropriately, but also that the specific compound ...

  • The twin cities sludge-to-energy plant reduces greenhouse gas emissions

    ABSTRACTThe majority of Utilities and Agencies in the United States (U.S.) that incinerate sludge treat this practice as a disposal method and do not maximize the recovery of energy available in the sludge and hence, do not contribute to the reduction in greenhouse gas (GHG) emissions.  The Metropolitan Council Environmental Services (MCES) have used incineration at the Metro Wastewater ...

  • 5 Ways Minnesota Can Reduce its Power Plant Emissions

    As the U.S. Environmental Protection Agency (EPA) moves forward with standards to reduce emissions from existing power plants—which are due to be finalized in June 2015—many states are wondering how they will comply. WRI’s fact sheet series, Power Sector Opportunities for Reducing Carbon Dioxide ...

  • Economic evaluation for air pollution control technologies selection in power plants processes

    Air quality legislation is entering a transformation phase, shifting the concept of atmospheric emission control towards pollution prevention and emission minimization through a more integrated approach. This transformation, along with public pressure and increased foreign trade, is providing industries with incentives to consider their effect on the environment and to take action where required. ...

  • Making money by reducing emissions

    Efforts to reduce emissions are really about changing companies' behavior. Pressure on companies from various activist groups combined with daily headlines in national and international media are driving various agendas among federal, state and local regulators. The current financial crisis does not appear to have lessened this pressure, rather the opposite. Compliance is now a must; ...


    By VisionMonitor Software, LLC

  • Emissions reduction with Diesel blending

    Diesel technologies are develops by huge rates. Modification of cars with diesel engines make a half of the new cars sold in Europe. The black smoke, noisy engine operation and unpleasant smell remained far in the past. Today diesel engines present not only profitability, but also high capacity and worthy dynamic characteristics. Quality of fuel also is changed. The modern diesel blending has ...


    By GlobeCore GmbH

  • Tackling remediation emissions

    Organisations commissioning regeneration projects now have the option to substantially reduce the carbon emissions associated with any remediation project, while offsetting the remaining carbon impact of these works, says Joe Teer, operations director of QDS. QDS introduced a carbon neutral remediation (CNR) service earlier this year triggered at this particular time by the fact ...


    By Newzeye Ltd

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you