real-time ammonia monitoring Articles

  • Real-Time Control Optimizes Extended Aeration Processes

    The population of Hillsborough County, Florida has doubled since the Valrico advanced wastewater treatment plant (AWTP) was built in 1990 to treat the sewage of several small communities west of the City of Tampa. When it began operation, the Valrico AWTP capacity was only 4 MGD; small when compared to Tampa's 96 MGD Howard F. Curren AWTP located not far to the east. But Valrico serves as a very ...

  • Detection of moisture in ammonia gas

    Problem Statement As technologies advance, so does the request for ultra high purity ammonia. Ultra high purity (UHP) ammonia is used in the semiconductor industries, production of flat panel displays, and a number of other applications. Due to this rising interest in UHP ammonia, manufacturers are having to battle ammonia’s most prominent and damaging impurity--moisture. For ...


    By CIC Photonics, Inc.

  • Real-time monitoring of membrane bioreactors with 2D-fluorescence data and statistically based models

    The application of membrane bioreactors (MBR) for wastewater treatment is growing worldwide due to their compactness and high effluent quality. However, membrane fouling, mostly associated to biological products, can reduce MBR performance. Therefore, it is important to monitor MBRs as close to real-time as possible to accelerate control actions for maximal biological and membrane performance. ...


    By IWA Publishing

  • Ammonia Vent Line Gas Detector

    The LPT-A Vent Line Ammonia Transmitter (P/N: LPT-A-VLT-NH3-S) is designed for continuous monitoring of ammonia levels in the vent lines of refrigeration systems caused by equipment failure or system over pressurization. Slow leaks of refrigerant can be costly over time and a dangerous situation could present itself if a high pressure release were to occur. The VLT provides continuous, ...

  • Mohawk Laboratories has acquired Strathtox providing greatly improved `real-time` studies

    Mohawk Laboratories, the research and development arm of NCH Corporation, has acquired Strathkelvin’s latest respirometer, StrathtoxTM, resulting in greatly improved ‘real-time’ bioremediation potential efficacy studies for its BioAmp system. This allows NCH to provide quick study results to its customers and potential customers in determining whether or not the bacteria ...

  • A short-term investigation using In-situ ammonia monitoring at a WWT, M Keown Severn Trent Water

    Summary: Two separate inlet streams are received for treatment at this works, one being predominantly domestic in origin and the other being predominantly industrial, arising from a local dye works. Their treatment is kept completely separate with municipal stream being subject to preliminary treatment, primary settlement, and secondary treatment in surface aerated activated sludge ...


    By Envitech Ltd.

  • Low-pH Ammonia Oxidation at a Biological Nutrient Removal Facility

    ABSTRACTMcAlpine Creek Wastewater Management Facility (MCWWMF), owned and operated by Charlotte Mecklenburg Utilities (CMU) of Charlotte, North Carolina, is permitted to treat 64 million gallons per day (mgd). Along with MCWWMF, three CMU treatment plants discharge effluent into the Catawba River just upstream of the South Carolina border. CMU worked with North and South Carolina regulators ...

  • Major waste management company and cleveland biotech combine resources to resolve a breach of ammonia consent in a large wastewater treatment plant case study

    The WWTP itself is located in the East Midlands, and treats dairy waste from a large processing plant, treating c1,500m3 of effluent per day. On 30th July the ammonia (NH3) levels in the permeate from the MBR at the plant began to increase. The effluent plant discharges to a river and as such, the consent limit is stipulated by the Environment Agency at 4mg/l. Within three days, the ammonia ...


    By Cleveland Biotech Ltd.

  • Major waste management company and cbio combine resources, to resolve a breach of ammonia consent, in a large wastewater treatment plant case study

    The WWTP itself is located in the East Midlands, and treats dairy waste from a large processing plant, treating c1,500m3 of effluent per day. On 30th July the ammonia (NH3) levels in the permeate from the MBR at the plant began to increase. The effluent plant discharges to a river and as such, the consent limit is stipulated by the Environment Agency at 4mg/l. Within three days, the ammonia ...


    By Cleveland Biotech Ltd.

  • Monitoring pH and ORP in a SHARON reactor

    This paper analyses the valuable information provided by the on-line measurements of pH and oxidation reduction potential (ORP) in a continuous single high ammonia removal over nitrite (SHARON) reactor. A laboratory-scale SHARON reactor equipped with pH, ORP, electric conductivity and dissolved oxygen (DO) probes has been operated for more than one year. Nitrogen removal over nitrite has been ...


    By IWA Publishing

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • Monitor Volatile Organic Compounds (VOC’s) with PPM Technology’s IAQ Monitor

    Volatile organic compounds (VOC’s) are emitted as gases from certain solids or liquids. VOCs include a variety of chemicals, some of which may have short- and long-term adverse health effects. Concentrations of many VOCs are consistently higher indoors (up to ten times higher) than outdoors. VOC’s is one of numerous sensor options that can be incorporated into PPM Technology’s ...


    By PPM Technology

  • Wireless monitoring for a safe indoor environment

    This article discusses the benefits of wireless technology for continously monitoring the indoor environment. In striving for the construction of energy efficient and cost-effective buildings, the imperative issue of the buildings Indoor Air Quality (IAQ) is often overlooked. This can often lead to a unhealthy indoor environment and even to conditions such as Sick Building Syndrome (SBS) or other ...


    By PPM Technology

  • Online Odors Monitoring in Waste Water Treatment Plants

    Odors are very distinct air contaminants as they generate nuisances (see note at the end). The factors playing a role in the determination of odor annoyance are : odor concentration and intensity, frequency, appreciation, duration, synergy and location. Chromatotec proposes an automated solution to well identify the origin and the level of odors. Technology Description We offer a ...


    By Chromatotec Group

  • Using UV Fluorescent Technology to monitor for organic pollutants

    For many years the water industry has relied on traditional sampling techniques to monitor water quality in a wide range of environments. Traditional tests such as BOD, PH, Dissolved Oxygen and Ammonia have formed the bedrock of monitoring parameters. There are however other ways to establish water quality and UV fluorescence offers an up to date solution for the investigation of ...


    By Safe Training Systems Ltd

  • Monitoring greenhouse gases from biofuel crops

    Global issues such as climate change and energy security have driven rapid growth in renewable energy production - wind, solar, tidal, geothermal, hydro, biofuels etc. However, logically, each of these methods should deliver a net benefit in terms of greenhouse gas (GHG) reduction, so researchers in the United States have employed portable FTIR analysers to study the GHG emissions of biomass ...


    By Gasmet Technologies Oy

  • Reliable silica monitoring supports power station efficiency

    West Burton B CCGT is a Combined Cycle Gas Turbine power station near Nottingham in the UK. It has three open-cycle gas turbines capable of generating enough electricity for approximately 1.5 million UK homes. In common with all combustion based power stations, the CCGT has a requirement to monitor silica levels in the Plant’s water and steam processes. Sean Todd, the Plant’s Control ...

  • Online Process Analyzer Installed at F.J. Horgan WTP to Monitor Chloramination

    Construction was completed on the City of Toronto's F.J. Hor-gan Water Treatment Plant in 1979, more than 60 years after chloramine had first been used to disinfect drinking water in an Ottawa plant. By then there was little debate about the benefits of chloramination and it was incorporated into the new plant's design as part of the disinfection process. Chloramine is more stable than free ...

  • Use of online nutrient monitoring for automatic aeration and nitrate recycle pump control

    The Northside Wastewater Treatment Plant (WWTP) in Kinston, NC was expanded and upgraded in 2006 for biological nutrient removal (BNR) to meet limits of 3 mg/L total nitrogen (TN) and 1 mg/L total phosphorus (TP). In addition to the traditional approach of controlling the blowers based on dissolved oxygen (DO) readings, the City decided to implement an aeration basin blower control system using ...

  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you