safety equipment Articles

  • NEC Classifications and Divisions for Hazardous Locations

    Electrical equipment in hazardous (classified) locations present a serious threat for workers due to the existence of explosive dust and vapors. Examples of such facilities range from grain mills and gasoline stations to aircraft hangars and chemical manufacturing plants. To prevent devastating explosions that may occur from the ignition of combustible particles in the atmosphere, the National ...


    By Larson Electronics LLC

  • Comfort and safety

    Type HOFGAS® - Ready/C 300  Commissioning 2004Site Moncorneil (FR) Situation Moncorneil is a medium-sized landfill near Toulouse. A heating boiler is to be operated with landfill gas and the acquired heat is used for leachate treatment. In view of the complete landfill design the customer demands a container construction with remote monitoring of the plant.   ...


    By Hofstetter BV

  • Employee Safety

    Employee Safety The following is a summary of accidents that occurred and were documented by OSHA and city management. The average total cost for a common slip and fall accident is $41,000 and the average death reimbursement is $950,000 (NIOSH 2001 data): Multiple Deaths Caused by ...


    By GillTrading.com, Inc.

  • IAEA safeguards equipment

    The International Atomic Energy Agency (IAEA) operates a large diversity of equipment to verify nuclear materials, contributing to the confirmation of the states' compliance with their respective nonproliferation obligations. The variety of physical and chemical properties of nuclear materials, as well as their storage environment, requires an arsenal of instruments. Additionally, the IAEA ...


    By Inderscience Publishers

  • Equipment purchasing and leasing

    PURCHASING (or leasing) equipment for use in manufacturing compost (and/or soil products) can be one of the riskiest decisions compost managers must make. The obvious risks of equipment acquisition (i.e. paying too much, higher than expected operating costs, not having the cash flow to cover payments, etc.) are augmented by risks such as machines not able to keep up with the increased materials ...


    By BioCycle Magazine

  • Warehouse Optimization: Balancing Equipment Performance and Worker Safety Through Emissions Measurements and Air Quality Monitoring

    Successful warehouse functionality is dependent on both maximizing equipment performance and providing a safe and healthy environment for workers that encourages productivity. However, these two factors are often at odds with each other as warehouse equipment such as forklifts, burnishers and delivery trucks emit toxic gases that can have the potential to create poor indoor air quality which ...

  • Learn How to Better Balance Equipment Performance and Worker Safety with Our Latest Application Note

    Do you want to ensure the safety and health of the workers at your warehouse and maximize the performance of the equipment they use? Here at E Instruments, we know that having a successful, and fully-functioning warehouse is dependent on whether or not the equipment is being maximized, and if the workers are working in a healthy environment that encourages productivity. However, we also know all ...

  • What is Intrinsic safety and ATEX?

    What is intrinsic safety? Intrinsic safety (IS) is a low energy signalling technique that ensures the safe operation of electrical equipment in hazardous areas by limiting the energy – both electrical and thermal – available for ignition. ...


    By Hansford Sensors

  • Health and safety at work

    The challenge The production activities of equipment such as cooling towers, condensers and cooling installations in aid of air conditioning systems require a lot of metalworking and welding. Baltimore Aircoil concluded for itself that the extraction of welding fumes and hazardous gases in the production halls could be ...


    By Plymovent Group BV

  • Electric Safety in the Workplace

    Every day, in every business, there is one bill the employer will pay and that is the electricity bill. Electricity is used constantly, whether it is boiling a kettle, using a computer or equipment. It is intrinsic to our lives and is vital for our day to day activities. It is easy to take for granted; every now and then we are reminded of its importance. An example of this is when there is a ...

  • Compressed Gas Safety Guide

    Use and storage of any compressed gas under high pressure can be extremely dangerous if proper gas handling procedures are not observed. Moreover, chemical characteristics of specialty gases themselves can pose serious health hazards if containment is not tightly controlled. Paying close attention to a compressed gas product’s technical and safety information is invaluable for maintaining a safe, ...

  • Technical and safety practices

    Safety is absolutely paramount in the medical industry, with lives literally at stake if something were o go wrong. Regrettably, this was more than reinforced recently following the tragic news of a death of a newborn at a hospital in Sydney, Australia, after it was mistakenly administered nitrous oxide (N2O) instead of oxygen (O2) in July this ...


    By Geotech

  • Gas Safety in Confined Spaces

    Introduction An offshore worker ensures a vessel is safe to enter; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face common dangers, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited. A confined space ...

  • Safety comes first for nanotechnology

    Online guide provides innovative path to product stewardship. Earlier this year, the International Council on Nanotechnology (ICON), Houston, launched the GoodNanoGuide, which is available at http://www.goodnanoguide.org. To cater to all audiences, the guide provides basic, intermediate and advanced options to choose from to contribute to or search within the online ...


    By Bergeson & Campbell, P.C.

  • Weather claims and wind safety

    Anybody working in the construction industry either here in the UK or anywhere else in the world is likely to know that the weather can present us with particular hazards. While rain, ice and snow are particularly dangerous to work in, we must always be aware that the wind is also likely to make conditions unsafe, particularly for those who work at height and those who ...

  • Workplace safety in the economic slump

    As we progress through the current downturn in our economy companies are finding ways to cope with such effects as declining revenues, reduced workforces and tight-to-non-existent credit. With organizations facing new challenges in order to remain afloat and sustainable, many areas of operation have begun to experience some effects. One such area that is critical to an organization’s success but ...


    By Intelex Technologies Inc.

  • Safety Shares Benefit Everyone

    Have you ever attended a meeting in your workplace that began with someone informally presenting a Safety Share? If you typically work in an office environment, you’ve probably wondered why your organization even requires these for non-field ...


    By EHS Insight

  • The pied piper of safety

    Many of us remember the story of the Pied Piper, that mythical person who simply played a flute to get all the mice to follow him wherever he wanted them to go. Sometimes it doesn’t take a flute. It just takes a person who is so passionate about their cause that they make others want to follow. I’ve met such a person. His name is David Biderman, whom I respectfully dub the Pied Piper ...


    By Waste Advantage Magazine

  • Identify Bias. Improve Safety.

    Too much information too quickly can crash even the most advanced computers. Luckily our brains are equipped with a failsafe that guards against processing meltdowns. This failsafe is called cognitive bias, and it helps us make decisions based on past experience and knowledge. Cognitive biases can be characterized as the tendency to make decisions and take action based on limited acquisition or ...

  • Pipeline safety action plan

    According to Transportation Secretary Ray LaHood, more than 2.5 million miles of pipelines are responsible for delivering oil and gas to communities and businesses across the United States. Much of the pipeline network is old and in a state of disrepair. The Obama Administration launched on April 4, 2011, a national pipeline safety initiative to repair and replace aging pipelines to prevent ...


    By Bergeson & Campbell, P.C.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you