sample gas Articles

  • Case study - Monitoring the oxygen content in bio-methane-to-grid supply

    Since 1984, Orbital has provided advanced technology solutions for the natural gas industry. Orbital’s customers, including the National Grid and the UK's gas distribution networks, rely on its crucial engineering support and specialised knowledge. Its value-added services and innovative products reduce the time it takes to identify, design and begin cost-effective delivery of new ...


    By Systech Instruments Ltd

  • Choosing the Right H2S Analyzer for Your Specific Application

    Not all H2S analyzers are created equal, and certain H2S analyzers work better on different applications than they do others. Significant amounts of time, money and headaches can be saved by learning about the different H2S analyzer principles of operation and choosing the correct analyzer for your ...


    By Analytical Systems Keco

  • F4 Spill In Situ Bioremediation Applications

    F4 Completed an in situ water bioremediation program of Bio-ReClaim in northern Alberta; a pipeline leaked crude oil over a 14 hectare area in muskeg. Alberta Environment (AEP) allowed the in situ water application of Bio-Reclaim by F4 Environmental. Keeping in mind the application was performed without any ground disturbance and extremely cost effective compared to the ...


    By F4 Environmental Inc.

  • Using Electromagnetic induction to characterize soils - Case Study

    Electrical conductivity measurements have been used for years to determine salinity and moisture in soils. Probes were inserted directly into the soil to determine how well the soil conducted an applied current. This process was slow and labor-intensive and was usually reserved for scientific studies. A more recent technique for measuring conductivity is electromagnetic induction (EM), a ...


    By Geonics Limited

  • Sampling VOCs with Supel™-Inert Film Gas Sampling Bags

    Sampling VOCs with Supel™-Inert Film Gas Sampling Bags with Thermogreen™ LB-2 Septa as an Alternative to Tedlar® For 10 years, Supelco has provided our customers with high quality Tedlar gas sampling bags. Recently, we expanded our gas sampling bag line to include an alternative to Tedlar for sampling VOCs that incorporates our low-bleed Thermogreen™ LB-2 ...


    By Sigma-Aldrich Co., LLC

  • Evaluating Leaks in a Soil Gas Sampling Train

    ABSTRACT The current advisory for active soil gas investigations in California requires leak tests to be conducted at eveiy soil gas probe while taking a sample. A leak may allow ambient ak into the sample train thus diluting the soil gas and underestimating the results. Also, the leak check compound itself may have impurities thereby contaminating the sample. The advisoiy suggests leak ...


    By Eurofins Air Toxics Inc

  • Impact of Sampling Media on Soil Gas Measurements

    Abstract To evaluate the vapor intrusion pathway for a building and to assess the associated human health risks, soil gas samples near the building site and under the building foundation may be collected. In order to meet risk assessment goals, the analytical laboratory is often required to report compounds of concern for these soil gas samples down to the part per billion ranges or lower. ...


    By Eurofins Air Toxics Inc

  • Ambient Air Sampling Methods

    Pollutants are nothing but any substance that may present in an atmosphere in such a concentration that it may harmful to surrounding, living organism or human being. Sampling and analysis of air pollutants is known as Air quality monitoring and it is major part of environmental monitoring. There are many advanced types of ambient air Sampling methods. we will learn here only which are most ...


    By Perfect Pollucon Services

  • Area Monitoring: Diffusion Sampling

    Indoor and outdoor gas hazards that exist in open areas are usually monitored using diffusion-type sensors. A diffusion sensor has no active sample-drawing system; diffusion sensors rely on the ambient air movement and pressure to deliver the sample to the sensing element. Diffusion-type sensors are a reliable and cost-effective way to monitor open area gas hazards. When installing diffusion ...

  • GC/MS analysis of a complex sample in DCM using hydrogen carrier gas

    Labs worldwide have recently found that helium has been in short supply, leaving a number of labs without carrier gas. Added to this, helium prices have doubled over the past 10 years causing a number of labs to look into alternative carrier gases for GC, such as nitrogen and hydrogen. As well as lower price and unlimited availability, hydrogen has a number of potential advantages over helium, ...

  • Biodegradation Tests for Wastewater Samples

    Biodegradation Tests for Wastewater Samples Biodegradation tests usually involve comparison of the oxygen uptake of a test sample – or gas production for anoxic or anaerobic tests – to that for a readily biodegradable control substrate (usually acetic acid, ethanol, or aniline). While biodegradation characteristics can vary among chemical types and wastewater sources, typical patterns are shown ...


    By Challenge Technology

  • Groundwater: Low-flow Purging and Sampling

    Significant timesavings, improved sample process integrity, quality assurance and minimal quantities of potentially contaminated purge water to manage - are attractive as the focus on groundwater quality sharpens and economics demand best cost-benefit based methods Water has become a vitally important resource.  Maintaining its quality and quantity and avoiding pollution are set to be ...


    By Geotech

  • Soil CO2 Flux Measurements -- Using the LI-8100 System to Collect Air Samples for Estimating Soil Trace Gas Flux

    Air samples can be collected from the same air stream used to measure soil CO2 flux with the LI-8100 Automated Soil CO2 Flux System, for estimating the flux of trace gas, such as methane (CH4), ammonia (NH3), nitrous oxide (N2O), isotopic species, etc. This application note describes a simple method for obtaining air samples from the LI- ...


    By LI-COR

  • Isolate & sample up to 7 zones in one borehole

    CMT Multilevel Systems isolate and monitor up to seven discrete zones in one borehole; monitor 7 zones in the 1.7" (43 mm) System; 3 in the narrow 1.1" (28 mm) System. Both options are low cost. The single tube design makes them fast and easy to drill and install in one day. System flexibility allows port locations and monitoring strategy to be finalized right on site. CMT wells are ideal for ...


    By Solinst Canada Ltd.

  • News on Air 2013, Volume 1: Products for Sampling

    For decades, Sigma-Aldrich has been a key supplier of innovative & high technology air monitoring products for various areas of gas/air sampling. Enclosed, you will find an overview on new and interesting devices to improve or simplify your air sampling. Supelco and Sigma-Aldrich offer a range of active and passive air sampling products, in addition to various analytical chemistry tools ...


    By Sigma-Aldrich Co., LLC

  • The 10 Key Factors in Selecting a Stack Sampling Firm

    Summary: This document is a summary of the key factors that you should take into consideration when hiring a stack testing firm.This has been prepared in conjunction with the ASTM criteria for standard practice of testing companies.The ASTM criteria has been supplemented, based on 125 years of direct testing experience, which is the combined years of experience of the individuals that contributed ...

  • Knotted in-tube and mini-column solid phase extraction of polycyclic aromatic compounds and nitroaromatics from aqueous samples for their determination by gas chromatography–mass spectrometry

    The selectivity of in-tube extraction by PTFE tubing vis-a-vis mini-column SPE has been evaluated for preconcentration and cleanup of PACs in their natural matrix, and has been found to effectively remove many polar analytes such as nitrogen containing aromatic heterocyclic compounds, anilines, phenols and certain organophosphorus pesticides. Knitting of tubings created a secondary flow pattern ...


    By Inderscience Publishers

  • Learn How to Implement a More Effective Emissions Monitoring Strategy with Our Application Note, “The Art of Emissions Monitoring and Sampling: Maintaining Gas Integrity”

    Over the past 15 years, all of us here at E Instruments have used our expertise to design, manufacture, and distribute quality emissions monitoring equipment, air quality monitors, and many other products to clients all over the world. Aside from creating many high-quality and reliable instrumentation solutions, something else we've always ...

  • Analysis of pesticide residues in drinking water samples using solid-phase micro-extraction (SPME) coupled to a gas chromatography-electron-capture detector (GC-ECD)

    The headspace solid-phase micro-extraction (HS-SPME) method with polydimethylsiloxane (PDMS, 100 μm) fiber is a cost-effective technique for the determination of different pesticide residues in environmental and biological samples followed by a gas chromatography-electron-capture detector (GC-ECD). In the present study more than 147 water samples collected in and around Lucknow city were ...


    By IWA Publishing

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you