sampling pump Articles

  • Selecting the Right Air Quality Monitor

    There are many types of air quality monitors available, but which one is the best choice for measuring gaseous air pollutant concentrations? There are two classes of such air quality monitors: sampling monitors and in-situ monitors (“in-situ” = “in the original position”). Sampling monitors utilises a manifold through which the air to be analysed is pumped. A small air ...


    By Opsis AB

  • December BioCycle World

    Economic Impact Of Recycling In Texas The Texas Commission on Environmental Quality (TCEQ) released its recent study on the economic impact of recycling activities in the state. Approximately 9.2 million tons of MSW designated materials were recycled in Texas in 2015. Typical recyclables (paper, plastics, metal, and glass), organics (yard trimmings, brush, green waste, and food and ...


    By BioCycle Magazine

  • Train derailment prompts contaminated land investigation

    On March 30th 2015 a long freight train, transporting a variety of goods including lumber and chemicals, wound its way through the state of Mississippi. At around 5pm, part of the train failed to negotiate a curved portion of the track in a rural area near Minter City, resulting in the derailment of nine railcars, one of which leaked chemicals onto agricultural farmland and woodlands. Emergency ...


    By Gasmet Technologies Oy

  • Recent Federal Developments

    TSCA/FIFRA EPA Extends Comment Period For Draft Guidance For Pesticide Registrants On Notifications, Non-notifications, And Minor Formulation Amendments: On October 5, 2017, the U.S. Environmental Protection Agency (EPA) issued a notice of extension of the comment period for the draft guidance  ...


    By Bergeson & Campbell, P.C.

  • Use of Diaphragm pumps in Sampling systems

    INTRODUCTION Sample system design can take many forms, influenced by factors including cost, size, maintenance, source conditions, and analyzer requirements – to mention a few. The following discussion takes into account the operating characteristics of a diaphragm pump, and choices that will improve system performance, reduce measurement errors, and lower pump maintenance. Illustrated below are ...


    By Air Dimensions Inc

  • Decontaminating Groundwater Sampling Devices

    These studies are the second part of a two year project that examines decontaminating groundwater sampling devices. In the first year, the efficiency of various decontamination protocols was tested using small test pieces of materials that are commonly used in groundwater sampling devices. Those tests showed that a hot detergent wash and rinse followed by hot air drying (105°C) was the most ...


    By QED Environmental Systems

  • Oil Sampling Best Practices

    Obtaining a representative oil sample from a closed loop lubrication system is essential to any good oil analysis program. As oil analysis programs become more standardized for routine monitoring, especially within equipment warranty support programs, equipment makers provide more sampling points on new equipment. These ...


    By Spectro Scientific

  • Technical Bulletin: Multilevel Sampling

    The topic of this CL:AIRE Technical Bulletin is multilevel sampling systems for characterising contaminated groundwater. Contaminated groundwater can present considerable problems for landowners: it can occur at significant depth, sources of the contamination are not often obvious, it can migrate from one property to another, and groundwater flow directions can be altered due to seasonal ...


    By Solinst Canada Ltd.

  • Low Flow Groundwater Sampling Using RotaPump Inertial Lift Pump

    This article tells you how to perform low flow groundwater sampling using a portable, surface-mounted pump with no decontamination required before each use and  no chance of cross contamination between wells. An inertial lift pump moves a dedicated (stored in the well) pumping tube rapidly up and down.  A one-way valve on the bottom admits water on the down stroke and ...


    By RotaPump, Inc

  • Groundwater: Low-flow Purging and Sampling

    Significant timesavings, improved sample process integrity, quality assurance and minimal quantities of potentially contaminated purge water to manage - are attractive as the focus on groundwater quality sharpens and economics demand best cost-benefit based methods Water has become a vitally important resource.  Maintaining its quality and quantity and avoiding pollution are set to be ...

  • Building Services Management - Air Sampling -

    Untitled Document Maintenance professionals are often the first responders to mold complaints in their facilities. building occupants can be exposed to fungal (mold) ...


    By EMSL Analytical, Inc.

  • Industrial Hygiene: Quality Assurance In Air Sampling and Analysis

    Industrial hygiene is the recognition, evaluation, and control of chemical, physical, biological, and ergonomic stresses in the workplace. Of the stresses listed, chemical stresses in the form of air contaminants are the most common. Air contaminants, their PELs and TLVs, and how to sample for them, is Industrial Hygiene 101 for most industrial hygienists. However, as simple as sampling and ...


  • ITRC technology overview of passive sampling technologies

    This document presents technical overviews of 12 passive sampling technologies. It describes each technology’s basis of operation, intended applications, advantages, limitations, and development status. Contacts for additional information are provided. This overview is an outgrowth of interest and information generated in preparation of the ITRC Technical and Regulatory Guidance for Using ...


    By EON Products Inc.

  • Use of Eight Well Purging and Sampling Record

    This article describes a groundwater well purging and sampling form that can be downloaded at our website. A click on the articles button will take you to a list of Monitoring Tips and Procedures articles, one of which is the sampling form. The form can be used to record  indicator parameters pH, conductivity, temperature, etc., taken during ...


    By RotaPump, Inc

  • Concentration and solvent recovery of environmental samples in dichloromethane

    Environmental samples are usually extracted with an organic solvent which is then concentrated prior to final analysis. In this short note, initial conditions and evaporation settings for the parallel concentration of samples dissolved in dichloromethane (DCM) having different starting volumes are presented. These settings have been optimized for high analyte and high solvent recoveries. ...


    By BÜCHI Labortechnik AG

  • Oil Sampling Best Practices (Part 2)

    Understanding Dynamic Particle Equilibrium in Closed Loop Systems Dynamic Equilibrium Condition (DEC) is defined as a steady state condition where the normal wear rate in a machine results in no net gain or loss of particles. ...


    By Spectro Scientific

  • Residential Vapor Intrusion Evaluation: Long Duration Passive Sampling v. Short Duration Active Sampling

    Abstract Sampling indoor air for potential vapor intrusion impacts using current standard 24-hour sample collection methods may not adequately account for temporal variability and detect contamination best represented by long-term sampling periods. Mr. Henry Schuver of the U.S. Environmental Protection Agency (EPA) Office of Solid Waste staled at the September 2007 Air & Waste Management ...

  • Casella intrinsically safe TUFF personal air sampling pump and dBadge sound level meter are a hit down under with Australian department of defence

    Following a competitive tender process, the Australian Department of Defence has taken delivery of 180 TUFF personal air sampling pumps and 180 CEL-350 dBadge personal noise dosimeters from Casella CEL (www.casellameasurement.com; 01234 844100), leading global specialist in industrial hygiene and occupational health monitoring equipment. Ronald Azar, ...


    By Casella

  • Get high quality samples with your drive-point Piezometer

    The results from short-term and long-term groundwater monitoring studies have shown that samples taken from Direct Push wells are comparable in quality to those obtained from conventional monitoring wells (ITRC, 2006). Solinst offers the Model 615 Drive-Point Piezometers that can be driven into suitable soils for ...


    By Solinst Canada Ltd.

  • Evaluation of Sampling and Field-Filtration Methods for the Analysis of Trace Metals in Ground Water

    Selected ground water sampling and field-filtration methods were evaluated to determine their effects on field parameters and trace metal concentrations in samples collected under several types of field conditions. The study focused on conditions where traditional approaches may produce turbid samples, which often leads to filtration of suspended particles from the sample before laboratory ...


    By QED Environmental Systems

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you