self-cleaning strainer Articles

  • Condenser Tube Cleaning System Custom Design & Fabrication

    Dominion Power is one of United States’ largest producers and transporters of energy, with a portfolio of approximately 25,700 megawatts of generation and 6,500 miles of electric transmission lines. Dominion serves more than 5 million utility and retail energy customers in 14 states. ...


    By Innovas Technologies LLC

  • Don’t Let Your Control System Control You

    Regular maintenance ensures valves remain healthy. If your system is operating properly, you should physically inspect all valves at least every 12 weeks to check for tubing leaks and other abnormalities. Pressure gauges should be checked to ensure each valve is performing as designed. If you find something wrong, refer to the appropriate instruction manual, which may be available online. Because ...


    By Singer Valve Inc.

  • Keeping Your Control Valves in Good Health

    Whether that brand new control valve in your system is the first one you have ever had to look after or if you are an old hand at valve maintenance with tens of valves in your system, there are a few simple guidelines and reminders for keeping it operating at optimal performance. It’s important to physically check valves at least every 12 weeks or so, assuming everything is running fine in ...


    By Singer Valve Inc.

  • Healthy Control Valves

    A simple maintenance routine can help ensure trouble-free valve operation. Whether the control valve in your system is the first one that has required maintenance or if you are experienced with maintaining multiple valves in your system, some simple guidelines can help keep them operating at optimal performance. Physically checking all valves at least every 12 weeks is important, assuming that ...


    By Singer Valve Inc.

  • Pump Performance Checklist

    Keeping your pump in shape will help reduce costs and boost profits! Cut fuel consumption, reduce replacement parts costs and minimize pumping time on every job! A PUMP THAT LETS YOU DOWN when you need it most causes obvious losses of time and money. Not so obvious, but every bit as costly, are losses you can incur with pumps that operate at less-than-peak efficiency. A pump ...


    By Gorman-Rupp Co.

  • Top 10 Valve Considerations for Pressure Management Zones/DMA’s

    For basic pressure management or more advanced modulating pressure management, water suppliers create a network of District Metered Areas (DMA’s) or smaller, more manageable pressure management zones. The DMA or pressure zone gives the ability to measure flow and control pressure, when a Pressure Reducing Valve (PRV) ...


    By Singer Valve Inc.

  • Spray Painting Industry: Wynnum Car Renovators Panel Beating & Towing

     Background Wynnum Car Renovators Panel Beating & Towing (WCR) is a medium sized spray painting and panel beating workshop which employs eight staff. Over the years, Peter Watson (Manager of WCR) has been continuously thinking of ways to improve his business productivity, reduce operating costs, and help protect the environment. He has to date introduced a number of waste ...


  • Pump Maintenance Know-How

    It’s no secret that a pump that runs at peak efficiency uses less fuel, experiences less downtime and costs less to operate. The time you spend maintaining your pump is actually an investment in its lifetime performance and value. In fact, there are many ways that a diligently maintained pump can reduce your costs, while increasing efficiency. For instance, by ensuring your pump investment ...


    By Gorman-Rupp Co.

  • Magnetic filtration used in a candy manufacturing plant

    Candy ManufacturerPt. Mayora Indah Tbk.IndonesiaPROBLEM: High levels of finished product being rejected due to ferrous contamination.SOLUTION: Beny Hermawan of PT. Sinarmentari Indoprima the Indonesia distributor for OEI installed an OEI magnetic filter rod (3RNC5812) in an existing T-Strainer on the finished product line (photo A).RESULTS: Photo B: contamination captured 44 grams ...


  • Preventing Rust Formation with Electronic Water Treatment

    The growing demand for water for industrial applications, power production and water supply has resulted in an increasing need for water treatment. The water used in industry comes from a range of sources such as rivers, lakes, wells and oceans and contains dissolved and suspended solids.  In addition the industrial world has to reuse water which in turn causes it to be highly concentrated ...

  • Wastewater engineers go with the flow

    The efficiency of maintenance work has been improved by water treatment engineers employing Intellisonde monitors in their final effluent. Designed primarily to measure water quality, the Intellisondes also measure flow, and this reading is being used to detect the accumulation of debris that necessitates a maintenance visit. Wastewater treatment efficiency is often measured by the analysis of ...


    By Intellitect Water Ltd

  • Phosphorus control protects surface waters

    Phosphorus is the decisive factor for excessive algae and plant growth in water bodies, that’s why quality standards require reductions in the amount of phosphorus released from wastewater treatment plants into rivers and lakes. In recent years, the outlet limit values have not only been reduced on national levels. Depending on the vulnerability of ecosystems, especially low target values ...


    By Endress Hauser

  • Top 8 things to check when maintaining a Pressure Reducing Valve

    Like every other piece of mechanical equipment we use, a control valve does require some maintenance. As budgets are stretched and time is tight, it can be tempting to ignore checking on valves that are often located in underground vaults and give years of operation without complaint, but eventually like everything else, they will fail. This article looks at 8 simple steps that if undertaken ...


    By Singer Valve Inc.

  • Improving and maintaining the performance of your Heat Exchanger or Condenser.

    The usage of Heat Exchangers or Condensers is common in many processes across a wide range of industries. The Energy sector is no different, either in the Thermal Power Generation, Upstream and Downstream of the Oil and Gas including Petrochemical and Chemical plants; Heat Exchangers are used to cool of the steam or to pre-heat different liquid needed in the processes. The recurrent problem of ...

  • Regeneration of used oil

    Used oil regeneration technologies Over time, oil accumulates oxidation products, contaminants and impurities which drastically reduce its quality. Contaminated oil can no longer meet quality requirements and must be changed. Waste oil is collected and regenerated to retain valuable basic materials. Oil cannot be recycled at petroleum processing plants with ...


    By PC GlobeCore

  • Effective Removal of Zebra Mussels with Amiad Screen Technology

    Introduction The zebra mussel, native to the Black and Caspian Seas, has spread in the past few decades to waterways throughout the world mostly via ballast water. Zebra mussels, when non-indigenous to the environment, pose a serious threat to intakes of facilities that rely on fresh and brackish surface water. The mussel colonies obstruct the flow of water through the pipelines eventually ...

  • Top 5 Causes for AODD Pump Failure

    1.       Air Valve Stalling, Clogging or Leaking: Stalling of the air valve often has to do with the design of the airways inside the valve. If the design in less than optimal it will stall under certain conditions. Same can be said about leakage of air where the air mostly blows through the valve instead of being redirected to push the diaphragm. Clogging on the other hand ...


  • Nitrogen and Nitrous Oxide – the differences you need to know

    We’ve previously posted blogs about the confusion between carbon dioxide (CO2) and carbon monoxide (CO) as these gases are regularly mixed up. However, ...


    By Analox Sensor Technology

  • Scale removal - Case Study

    Water Cooling Towers Operate at Better Efficiency and Lower Maintenance Costs with KDF Water Filter Media "As Seen in Water Quality Products" At TowerKlean™ LLC... KDF Water Filter Media Help with Scale, Algae, Chlorine and Heavy Metal Removal from Water Scale... it's a vicious never-ending problem that can kill the overall efficiency of water-cooling systems or ...


    By KDF Fluid Treatment, Inc.

  • Whole Life Costs and pumping Technology – Peristaltics Increasingly Out on Top

    Untitled Document Whole life costs are playing an ever-more important role in pump selection by the water and wastewater industry. Interestingly, energy use is no longer the ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you