single point gas sensor Articles

  • A Comparison of Point Sensors and Open Path Monitors For Toxic Gas (esp. HF) Monitoring

    Point Sensors Ion Mobility Spectroscope (IMS) – a gas sample is ionized by a radioactive source (Ni63). Differences in ion drift under the influence of an applied electric field produce a spectrum that is dependent on the mass, charge, and shape of the component ions. The detector signal and strength is tuned to the drift time of the ion of interest (in this case HF) and signal strength is ...


    By Boreal Laser Inc.

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Oil & Gas Leakage Detection Contractors

    RADS (Remote Aerial Detection Systems) teamed with market leading vendors to supply state-of-the-art Intelligence Surveillance and Reconnaissance (ISR) and security equipment. RADS is a US-based top-tier Technology Integrator that serves international commercial and government customers across the world. Unlike the large US defense contractors, RADS is independent and can operate with agility ...


  • Gas Dilution With The Equal Capillaries Technique

    The advantages of the equal capillaries technique are surprising and leads to reach accuracy values of one order of magnitude higher than all the other dynamic dilution techniques. This comparison will be supported by analyzing the accuracy available with two different techniques. Nozzles (sonic or non-sonic) technique With this technique, a series of different size nozzles is used ...


    By Be.T.A. Strumentazione Srl

  • Gas monitoring and leak detection in underwater application for the offshore oil and gas case study

    With over 300 sensors and systems sold world-wide and over 35 scientific users publications, Franatech is market leader for underwater methane detection and monitoring. Franatech is a developer and supplier of sensors for detection of gases in water. The company has more than 15 years experience in subsea applications, working with all kinds of sensing technologies. Coming from a scientific ...


    By Franatech GmbH

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Fixed Versus Portable Gas Detection – Which Is Better?

    Did you know that workers are needlessly injured every year as a result of leaking toxic or combustible substances? Such incidents are known to involve a wide range of hazardous gases (including ammonia, carbon monoxide, chlorine, hydrogen sulfide, hydrocarbon vapors and so on). The sad reality is that most of these accidents are avoidable if only the workplace is adequately monitored. This leads ...

  • WIRELESS NETWORK PROVIDES MONITORING AND CONTROL OF SENSORS, PUMPS AND OTHER DEVICES AT UP TO 56 REMOTE LOCATIONS

    WIRELESS NETWORK PROVIDES MONITORING AND CONTROL OF SENSORS, PUMPS AND OTHER DEVICES AT UP TO 56 REMOTE LOCATIONS DX80from Banner Engineering replaces costly wiring in wide area installations A scalable wireless network that can monitor and control I/O functions or provide serial communication at up to 56 locations is available from Banner Engineering. The SureCross DX80 product line replaces ...


    By Banner Engineering Corp.

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Double benefit of monitoring Indoor Air Quality (IAQ)

    It is a difficult balance to save money and energy yet maintain a comfortable and healthy indoor air environment. A logical solution to controlling indoor air pollution is good ventilation coupled with IAQ monitoring using gas sensors. This can ensure healthy indoor air as well as a more efficient HVAC system.  Typical IAQ investigation and examination consists of taking single-point ...


    By PPM Technology

  • Capillary Tube Thermal Mass Flow Meters & Controllers - A User`S Guide - White Paper

    Abstract Capillary tube thermal mass flow meters directly measure the mass flow rate of clean gases and gas mixtures in lower flow ranges. A capillary tube thermal mass flow controller adds an integrally mounted flow control valve to the flow body of the mass flow meter and bom monitors the mass flow rate and controls it to be equal to a set-point value selected by the user. ...


    By Sierra Instruments, Inc.

  • Model 5100 Verification/Validation case study

    Background Many sensors used in gas analyzer systems come into direct contact with the process gas, and there is the potential for degradation over time especially with streams that contain contaminants like glycol, moderate to high levels of hydrogen sulfide etc. With sensor degradation, the analyzer response characteristics change resulting in inaccurate readings. In order to ...

  • Distributed Thermal-Acoustic Data Integration

    Silixa has developed a technique called Distributed Thermal Acoustics (DTA) to monitor simultaneously the thermal and acoustic profile along a hybrid optical fibre cable in submarine environments. Using its world leading distributed fibre optic technology (ULTIMATM DTS and iDASTM) Silixa deployed an optical fibre cable along the seabed and across the water column in an active gas seepage ...


    By Silixa Ltd

  • Reducing Costs of Steam Flow Measurement

    Traditionally, steam flow has been measured with a differential pressure device. This is typically an orifice plate. However, such devices are inherently volumetric flow measurements. As we have discussed in previous blog posts, changes in pressure and temperature ...


    By Sierra Instruments, Inc.

  • Case History - Ammonia Emergency Plan Calls on Packed Tower to Scrub Released Chemicals

    Croll-Reynolds designed the Union Camp packed tower scrubber for ammonia removal efficiency at 99+% for the minimum single valve release and well over 90% for the entire range of operation. A few years ago Union Camp turned a corner. Management decided that advance planning would take the place of reacting after the fact to an emergency or regulatory agency demands. At Union Camp's Dover, OH, ...


  • Tech update: Plant instrumentation - food engineering

    Sensors and other devices are the foot soldiers in automation architecture, but most food and beverage manufacturers still are looking for full value. You know an equipment category has arrived when it starts getting its own industry-specific center. For the food production sensors that do the heavy lifting in instrumentation technology, that day could arrive earlier rather than ...


    By Hardy Process Solutions

  • Chemical Industry: Ammonia Emergency Plan Calls on Packed Tower to Scrub Released Chemicals Case Study

    A few years ago Union Camp turned a corner. Management decided that advance planning would take the place of reacting after the fact to an emergency or regulatory agency demands. At Union Camp’s Dover, OH. facility, byproducts of the paper industry are converted into usable specialty chemicals for cosmetics, adhesives and other industries. Crystallization is a process used intensively with ...


    By CR Clean Air Group, LLC

  • Pulp & Paper: Ammonia Emergency Plan calls on Packed Tower Case Study

    A few years ago Union Camp turned a corner. Management decided that advance planning would take the place of reacting after the fact to an emergency or regulatory agency demands. At Union Camp’s Dover, OH. facility, byproducts of the paper industry are converted into usable specialty chemicals for cosmetics, adhesives and other industries. Crystallization is a process used intensively ...


    By CR Clean Air Group, LLC

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you