small incinerator Articles

  • Waste Incinerator Project

      Medical Waste Incinerator YD Model is our classic product for market. All series included burning capacity 10kgs per hour, 30kgs per hour,50kgs per hour,100kgs per hour,150kgs per hour,300kgs per hour,500kgs per hour. Up to now, all models sale to all over the world and have good feedback from end-customer. The YD Model medical incinerator have multi-combustion chamber and basic dry ...


  • Case study - Allburn Incinerators

    PROJECT 19 off containerised Allburn 3 Incinerators World Health Organisation—Ethiopia PROJECT DESCRIPTION Top loaded, diesel fired, low capacity incinera-tors, factory -installed within 20’ ISO shipping containers, for the disposal of bagged general/clinical waste from hospital and clinics, animal and industrial waste. To be ...

  • Conception of a Refuse-Derived Fuel (RDF) incineration plant and its environmental benefit

    Since landfill ban was realised in July 2009 in Germany, wastes that have a high and middle calorific value must be incinerated. Fossil fuels like oil and coal for the generation of electricity and/or heat can be substituted, so that approximately 4 million tons of CO2 could be avoided. Waste incineration is a possible partial solution for avoiding worst ...


    By Inderscience Publishers

  • Simulation of the plume emitted by a municipal waste incinerator in Madeira Island

    TAPM (The Air Pollution Model) was applied to Madeira Island to simulate the behaviour of the plume of a municipal waste incinerator that was constructed in the southern slope of the island at an altitude of 1380 m. TAPM simulates very well the atmospheric flow that occurs around the island and inside the inner valleys under strong synoptic forcing. Validation tools reveal the good agreement ...


    By Inderscience Publishers

  • Source contribution of atmospheric aerosols in Bangkok metropolitan area by CMB8 receptor model

    The CMB8 model was applied for source apportionment of particulate matter in Bangkok area. The 24 h of ambient data were collected and analysed for elemental composition during December 1996 to January 1997 by high volume air samplers at a station in Bangkok, Thailand. Seven source profiles and the average mass concentrations of 42 ambient data were used to run the chemical mass balance ...


    By Inderscience Publishers

  • Repeat business from Africa Yet another existing customer has come back to us for their next commercial incinerator

    It is always immensely satisfying (although not a surprise) when an existing customer comes back to us to tell us that he was so pleased with his previous commercial incinerator from Matthews Environmental Solutions that he wants us to build his next one.  It is also rather pleasing when, after launching a new and innovative range of incinerators, we find that more and more customers are now ...

  • Large volumes compressed into small volumes saves costs case study

    Vöhringer GmbH with its 120 staff and ultramodern machine park in Trochtelfingen each day processes up to 40,000 m2 of sheeting. This is mainly used for manufacturing specialist furniture parts up to complete furniture sets – especially for caravans and mobile homes but also for exhibition stand construction, for doors and the furniture industry. Chippings and dust accumulating during ...


    By WEIMA

  • Heavy metals in wet scrubber residue from a medium–sized (32 MW) municipal district heating plant incinerating wood and peat in a fluidised bed boiler

    Due to the low total concentrations of heavy metals and extractable compounds, it is recommended that the wet scrubber residue be used as a construction agent instead of being disposed of in landfills. According to five–stage sequential extraction, the highest concentrations of most of the heavy metals occurred in the residual fraction (i.e., HF + HNO3 + HCl), which means that ...


    By Inderscience Publishers

  • Comparison between different dispersion models using wind-tunnel small-scale measurements

    In this paper, the results from a plume diffusion experiment on a small-scale model of a two-stack waste incinerator, carried out in a developed boundary-layer wind-tunnel, will be presented. A brief description of the tunnel, the measurement system, and the artificially developed neutral boundary layer is given. The experiments investigate ground-level concentration measurements and vertical and ...


    By Inderscience Publishers

  • Turning waste into wattage

    How we are helping to meet the growing demand for waste energy recovery It’s a sign of the times that more and more companies and organisations are now looking at ways to capitalise on the waste material their production process produces rather than having to pay a third part to take it away for them.  One reason of course is the high cost of scrappage.  Another is the ...

  • Thermal Treatment Technologies

    Hot gas decontamination: Hot gas decontamination is a technology still in the pilot-scale of development that can be used for decontamination of explosives-contaminated masonry or metallic structures. The method involves sealing and insulating the structures, heating with hot gas stream to 260 °C (500 °F) for a prescribed period of time, volatilizing the explosive contaminants, and destroying ...

  • GHG emissions: an assessment at municipal solid waste disposal site in Indore, India

    After ratifying the Kyoto protocol the assessment of anthropogenic greenhouse gases (GHG) inventories has become crucial for India. Municipal solid waste management system for city of Indore, India, has been evaluated for GHG emissions over a period of 41 years. Corresponding assessment of CO2, methane and ...


    By Inderscience Publishers

  • Microwave processing in MOX fuel cycle

    The prominent aspect of the microwave heating technique applications in nuclear material processing is its eco-friendly status. It is envisaged that no active liquid waste will be generated from microwave processing. AFFF has fabricated the (U, Pu)2O mixed oxide fuels for PHWRs, BWRs and PFBR. AFFF is also working for the AHWR fuel cycle. The present paper summarises about the process ...


    By Inderscience Publishers

  • Nuclear Plant in southeastern United States case study

    Turning Liquid Waste into Solid Money Savings using QUIK-SOLID© Project Background: A nuclear plant located in southeastern United States had to dispose of approximately 7,000 gallons (26,488 L) of liquid sludge that resulted from aggressive preventive maintenance activities. The plant stored the watery sludge in B-25 boxes (90 ft each). The slightly ...


    By CETCO

  • Landfill Crisis: Rethinking Issues of Waste Management in South Africa

    As a result of the closure of many landfills in South Africa and the difficulty of locating new sites, there is now a need to rethink the issue of waste management. The National Waste Management Strategy (initiated in 1997) of South Africa advocates the implementation of integrated waste management strategies in order to meet socio-economic and environmental requirements. This paper reports on an ...


    By Ecosystems Ltd.

  • CASE STUDY #27 Q-PAC PLASTIC - “Q-PAC saved us $8,362 per year and did not plug!”

    The city of Pittsfield, Massachusetts purchased two acid scrubbing towers for their Municipal incinerator. The scrubbers had to perform at unusually high particulate loadings forcing change-out of packing every 3-4 months. Because the ...


    By Lantec Products, Inc.

  • Techniques for processing industrial waste using arcplasma generated by the twelve-phase alternating current

    We have already presented an arc-discharging plasma generator, generally called a thermal plasma generator which is constructed by the six-phase alternating current power supply(Matsuura et al, 1994a, 1997). A more effective thermal plasma generator can construct by expanding this concept. As an example, this small power supply system has been presented in reference (Matsuura et al., 1994b). In ...


    By ORBIT e.V.

  • Like a phoenix from the ashes

    Thanks to growing environmental awareness, waste is increasingly being separated and recycled. However, residual waste always remains that can't easily be recycled. This ends up in waste incineration plants (referred to as KVAs in Swiss German) for disposal and reclaiming, such as the KVA Linthgebiet in Niederurnen in the Swiss canton of Glarus. Due to the strict environmental specifications ...


    By Metrohm AG

  • Time to address the air pollution control residue problem

    The incineration of municipal solid waste is gaining increasing importance in the UK, especially as the burning of waste can be used to generate energy, providing a more sustainable solution to our waste problem by diverting it from landfill sites. An issue with incineration is that some of our waste contains hazardous chemicals such as chlorine and lead which are volatilised during the process. ...

  • This idea deserves to clean up

    Untitled Document Cape Breton may very well be one of the most scenic places in Canada, but in the middle of that East ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you