solid waste storage Articles

  • Defining solid waste

    Simultaneous to the publication of the final National Emission Standards for Hazardous Air Pollutants for Boilers (the Boiler NESHAP) and the Commercial and Industrial Solid Waste Incinerator (CISWI) Rules, EPA issued a new regulation that for the first time defines what materials are a non-hazardous solid waste when combusted. This rule, Solid Wastes Used as Fuels or Ingredients in Combustion ...


    By Trinity Consultants

  • Municipal solid waste management in Khoram Abad City

    This paper presents an overview of current municipal solid waste management in Khoram Abad city. Necessary data was collected from municipality information, direct observation, taking photography, Interviewing with responsible persons and a questionnaire. According to data collected by the local authorities, the waste generation rate is estimated to be 800 g/cap. d   with density of 243 ...


  • Equipment List for full solids manage & drilling waste

    Solids Handle & drilling waste management are pretty important for drilling contractor. If they manage this division well, they can save lots of money on drilling mud / drilling chemicals, also they can be environmental friendly. There is much equipment needed for solids control & drilling waste ...


  • EPA Issues Proposed Revisions to Definition of Solid Waste

    The definition of “solid waste” under the federal Resource Conservation and Recovery Act (RCRA) is unquestionably one of the most difficult environmental concepts to get one's head around. Even after 27 years, the U.S. Environmental Protection Agency (EPA) is still tinkering with revisions to the definition to better define the types of recycling activities that fall within the scope of the ...


    By Bergeson & Campbell, P.C.

  • Municipal solid waste and recovery potential: Bangladesh perspective

    Rapid urbanization and population growth are largely responsible for very high increasing rate of MSW generation in the urban areas of Bangladesh, one of the densely populated Least Developed Asian Countries (LDACs). These scenario posses a social, environmental and professional threat for city dwellers, urban planners, development authorities and other concerned stakeholders. In Bangladesh, a ...


    By University of Tehran

  • Solid Waste Reduction: Insulform Pty Ltd

    Insulform Pty Ltd is a medium sized Melbourne based company that manufactures trim and insulation components for the automotive industry. Reformulation of the raw material and the process used to manufacture rear parcel shelves for passenger vehicles has resulted in significant cost savings, with reduced price to the customer, and the elimination of a significant solid waste stream. ...


  • Solidification / Immobilisation of hazardous waste for subterranean storage

    The use of subterranean salt mines for the final storage of inorganic hazardous waste is state of the art in Germany, and in fact most other European countries. However, the technical requirements to prepare the waste in an appropriate way are quite challenging. Over ten years ago econ supplied a plant to a salt mine in eastern Germany. The plant uses econ’s unique batch-wise working mixing ...

  • Solid Waste Management: A Case Study of National Refinery Limited

    Investigations have been carried out to assess and characterize the waste being generated in one of the largest petrochemical refinery of Pakistan. It was found that the refinery complex generates about 2000 metric tons of solid waste and about 0.55 million gallons of waste water per day. Besides these gaseous pollutants like H2S, CO, CO2 NO2, and particulate matter are also emitted in the ...


  • EPA`s Proposed Solid Waste Definition Fact Sheet, May 2007

    EPA's re-proposal on solid waste definition is receiving comments until June 25, 2007. This fact sheet summarizes the elements of the new proposal. Basic Idea of Proposed Rule (as of March 26, 2007) If hazardous secondary materials ...

  • Use of Land over Closed Municipal Solid Waste Landfill

     §330.951. Definitions. Unless otherwise noted, all terms contained in this section are defined by their plain meaning. This section contains definitions that are applicable only to this subchapter and which supersede definitions in §330.2 of this title (relating to Definitions) where those terms appear in this subchapter. As used in this subchapter, words in the singular include the plural ...


  • Determination of the Environmental TCLP Metals in Waste-Waters, Solid Wastes, and Soils by Flame Atomic Absorption Spectrophotometry

    Hazardous wastes can originate from many sources – industrial processes, product formulations, synthetic operations, virtually any manufacturing business. The nature and composition of the “wastes” can vary so much that one industry’s discharge can serve as another’s raw materials. It is the tremendous transfer of these materials – their storage, transportation, spillage and leakage into the ...


    By Buck Scientific Inc

  • Long-term leachate emissions from municipal solid waste landfills sre unknown

    The Swiss have always been highly environmentally aware, and for a long while have looked after their environment in an exemplary fashion. The 'Guidelines to waste management in Switzerland' ( EKA, 1986 ) were set in 1986, well ahead of many states. One necessary objective of this as a code of good practice has been that all waste management procedures have to provide materials which either are ...


  • Methane emissions reduction from organic wastewater and solid waste co-composting: parameter estimation and sensitivity analysis

    Using the approved large scale methodology AM0039 and approved baseline methodology AM0010, an estimated 7,329.04 tCO2e/yr are typically generated from degradation of organic wastes at the landfill in Mauritius. Baseline emissions for anaerobic degradation of organic wastewaters (OWW) in open lagoons approximated to 36,036 tCO2e/yr; 402,783.92 tCO2e/yr for transportation of OWW and municipal ...


    By Inderscience Publishers

  • Establishment of industrial solid waste treatment costs of the mechanical industry – a case study in Ho Chi Minh City of Vietnam

    Survey results from 72 mechanical manufacturers in Ho Chi Minh City (HCMC) in conjunction with related studies showed that industrial solid waste – hazardous waste (ISW-HW) treatment charges were operated in two forms: fixed and varied based on generated ISW-HW mass. Charges of collection – transport – storage – treatment – landfill for each waste composition varies widely (5 ÷ 20 fold), ...


    By Inderscience Publishers

  • TOC Determination in Solid Samples using the Suspension Method

    The TOC content in solids plays an important role in the classification of soils, sludges and sediments. According to the German Ordinance on Environmentally Compatible Storage of Waste from Human Settlements, TOC in solid materials is one of the key parameters for the characterization of wastes as part of the acceptance control of landfills. This important control measure requires a ...

  • Methane emissions reduction from organic wastewater and solid waste co–composting: parameter estimation and sensitivity analysis

    Using the approved large scale methodology AM0039 and approved baseline methodology AM0010, an estimated 7,329.04 tCO2e/yr are typically generated from degradation of organic wastes at the landfill in Mauritius. Baseline emissions for anaerobic degradation of organic wastewaters (OWW) in open lagoons approximated to 36,036 tCO2e/yr; ...


    By Inderscience Publishers

  • Treatment Options for Molten Sulfur Storage

    Documento sin título ...


    By Merichem Company

  • Waste Treatment

    Introduction The Department of Energy's (DOE) Waste Management program directs the storage, treatment, and disposal of waste generated by DOE's activities. In support of this mission, the Waste Management program uses a variety of treatment technologies to change the characteristics of the waste so that it may be more easily managed. What Is Waste Treatment? ...


  • Waste Disposal

    Introduction The final step in the waste management process is waste disposal, the permanent isolation of waste. Some wastes can be managed and disposed safely with existing facilities and proven methods. Other Department of Energy (DOE) wastes require more complex disposal facilities. DOE has conducted extensive research into alternative waste disposal methods and has concluded that deep ...

  • Turning wood chips and sawdust into a valuable solid fuel

    RUF briquetting units are the economical solution for the processing of wood chips and sawdust. Where timber is planed, turned and sanded, manufacturers end up with large quantities of wood chips and sawdust. By briquetting this material, you can recover a valuable solid fuel. Where large quantities are produced, the single briquette pressing system developed by RUF GmbH is the most economical ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you