specific vapor analyzer Articles

  • New Process Gas Analyzer for the Measurement of Water Vapor

    KEYWORDS TDLAS, WMS, Laser Spectroscopy, Water Vapor Measurement, Gas Analyzer ABSTRACT A new analyzer for the measurement of water vapor concentration based on Tunable Diode Laser Absorption Spectroscopy (TDLAS) was developed. The water-vapor line at 1854-nm was selected for the measurement, and the performance of the system was evaluated on different ...

  • Vapor-Phase Biofilters Show Promise for Treating High VOC Emissions.

    Evaluating the Feasibility of Natural AttenuationUsing natural attenuation to remediate organic compounds in groundwater has gained popularity. In some cases, this process can reduce contaminant levels to below risk-based corrective action criteria or regulatory standards without implementing additional remedial action alternatives. However, it is often difficult to prove that natural ...


  • Vapor-Phase Biofilters Show Promise for Treating High VOC Emissions

    Evaluating the Feasibility of Natural AttenuationUsing natural attenuation to remediate organic compounds in groundwater has gained popularity. In some cases, this process can reduce contaminant levels to below risk-based corrective action criteria or regulatory standards without implementing additional remedial action alternatives. However, it is often difficult to prove that natural ...


  • The application of Flow Injection Technology to automating cold vapor MERCURY analyses

    This document describes the application of flow injection technology to cold vapor mercury analyses. It can be obtained from PerkinElmer by requesting method number ENVA-100. Appendices 1 and 2 show letters from the US EPA indicating acceptability through the Alternate Test Program for both drinking water and wastewater sample analysis. 1.0 Scope and Application 1.1 This ...


    By PerkinElmer, Inc.

  • Reducing the Detection Limits for a Process Moisture Analyzer

    KEYWORDS Moisture Analyzer, Piezoelectric Sensor, Smart Transmitter, Internal Verification, Quartz-Crystal Microbalance ABSTRACT Piezoelectric moisture analyzers have been used in the process industry for over two decades. While this is an older technology for measuring moisture in gas phase samples, it is still one of the most reliable in ...

  • Monitoring Airborne Contaminants in Workplace Atmospheres, Using Sampling Devices and GC or HPLC

    Workers' exposure to hazardous substances must be held within acceptable limits. Therefore, airborne contaminant vapor and particles (including aerosols) in industrial atmospheres must be monitored. In the United States, the National Institute for Occupational Safety and Health (NIOSH) and the Occupational Safety and Health Administration (OSHA) offer, for many such substances, specific ...


    By Sigma-Aldrich Co., LLC

  • Coil Coating Case History

    The Customer The Company manufactures metal roofing and gutter systems for the commercial and residential housing industry. The Process Bare coils of recycled steel and aluminum are uncoiled from a roll. The metal is chemically cleaned, treated and rinsed to prepare the surface for optimum coating adhesion and corrosion protection. The coil then enters a ...

  • Correlation and prediction of saline solution properties for their use in mineral processing using artificial neural networks

    Artificial neural networks (ANNs) are applied to correlate and predict physico-chemical, transport and thermodynamic properties of seawater. Values of these properties are needed in the design, simulation and optimization of processes in which seawater is used, mainly in the mining industry. Density, vapor pressure, boiling temperature elevation, specific heat, viscosity, thermal conductivity, ...


    By IWA Publishing

  • Energy Savings Case History

    The Customer The Company is a worldwide supplier of thousands of innovative and reliable products to dozens of diverse markets—from automotive to healthcare to renewable energy to electronics. Products include tapes, adhesives, abrasives, films, reflective materials, filtration systems and an array of other products that keep homes clean, offices organized and buildings ...

  • High Quality Moisture Analysis for High Value Resins

    Whether you’re making syringes or turkey basters, pacemakers or milk jugs, maintaining the correct moisture content in your resins is essential to your production process. Join us February 9-11 in Anaheim, CA at Plastec West / MD&M West, booth 3920, and see why our instruments are considered the leaders in moisture analysis for the medical device ...


    By Arizona Instrument LLC

  • Continuous measurement of Process oxygen for Claus sulfur recovery unit (sru) start-ups and shut-downs case study

    During start-up and shut-down, any time a sulfur recovery unit (SRU) transitions from ambient temperature through fuel gas warm up to the introduction of acid gas, measurement of 02 stoichiometry is critical. Historically, operators have manually taken samples using a portable electrochemical type Os analyzer. While giving more or less satisfactory results, the requirement for more stringent ...

  • The Secret to Quality Food Products

    Quality is everything when it comes to food, and accurate moisture control is essential to quality. Decrease spoilage, wasted products and lost profits by making sure you’re accurately monitoring the moisture content of your food products. Join us July 17-19 in Chicago, IL at the International Food Technologists Annual Meeting & Expo ...


    By Arizona Instrument LLC

  • A Comparison Between EPA Compendium TO-15 and EPA MEthod 8260B for VOC Determination of Soil Gas

    ABSTRACT Evaluations of vapor intrusion pathways of chemical contaminants often include soil gas measurements to assess the potential for indoor inhalation. No longer just a screening tool, soil gas measurements are requiring a level of quality and defensibility which should be incorporated in soil gas analytical protocols. While both EPA Compendium Method TO-15 and EPA SW-S46 Method 8260B ...


    By Eurofins Air Toxics Inc

  • CIRAS-2 User Recalibration of CO2 and H2O

    The CIRAS-2 CO2/H2O analyzer is an inherently stable instrument and does NOT require frequent calibration. The AutoZero function corrects for nearly all changes that result in calibration drifts. The most common causes of drifts in CIRAS-2 readings are i) incorrect Zeros due to exhausted chemicals or ii) leaks on the desiccant columns from rolled or damaged o-rings and iii) incorrect Diff Bal, ...


    By PP Systems

  • Low level moisture measurement in Natural gas using a Lunable diode laser absorption spectroscopy (tdlas) based laser case study

    Introduction The measurement of water vapor in natural gas has long been of industrial importance, and has been addressed by a variety of analytical techniques over the years. Chief among these techniques has been the quartz crystal microbalance (QCM) based analyzers. The QCM technology is still the workhorse for production and pipeline applications, and the technique is considered by most ...

  • Evaporator Limits Boron to 5 PPM at award-winning chemical plant

    Problem: The biggest challenge confronting Rohm & Haas Corp. in building a wastewater plant for its chemical facility in Elma, Wash., was meeting Washington State Dept. of Ecology limitations on boron of 5 ppm. The Elma plant manufactures sodium borohydride, a versatile chemical used in a variety of applications ranging from the generation of sodium hydrosulfite for reductive bleaching of ...


    By Oil Skimmers, Inc.

  • Moisture in Oils: The Three-Headed Beast

    Abstract Moisture contamination in in-service lube oils is perhaps one of the most destructive forms of engine corrosion second only to particle contamination.  Water contamination in oil can be categorized into three forms of water; Free, emulsified, and dissolved.  All forms of water have direct consequences to the oil and gears of the engine, but indirect consequences as ...


    By Arizona Instrument LLC

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Tacoma, Washington - Well 12A superfund site - Case Study

    Combined Remedies for DNAPL Remediation Project Summary TRS Group, Inc. (TRS) teamed with KEMRON and AMEC, under KEMRON's U.S. Army Corps of Engineers (USAGE) Environmental Remediation Services Multiple Award Task Order Contract (MATOC), to perform electrical resistance heating (ERH) for the remediation of volatile organic compounds (VOCs) in the vadose zone ...


    By TRS Group, Inc.

  • EPA Technology News & Trends - Tacoma “Well 12A” Superfund Site

    The U.S. EPA Region 10 office uses an adaptive site management approach that relies on high-resolution site characterization (HRSC) techniques for strategic sampling at the Well 12A project area. This approximate one-square-mile project area is one of three at the 2.5-square-mile Commencement Bay-South Tacoma Channel Superfund site in Tacoma, Washington. The vicinity of Well 12A, one of 13 wells ...


    By TRS Group, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you