stack gas probe Articles

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Heating value

    The CustomerThis Chemical Company is a leading supplier of performance polymers. Their products are used in a wide range of applications including adhesives, coatings, consumer and personal care products, sealants, lubricants, medical, packaging, automotive, paving, roofing and footwear products. The ProcessThe company uses flare stacks to dispose of the waste products ...

  • Continuous measurement of Process oxygen for Claus sulfur recovery unit (sru) start-ups and shut-downs case study

    During start-up and shut-down, any time a sulfur recovery unit (SRU) transitions from ambient temperature through fuel gas warm up to the introduction of acid gas, measurement of 02 stoichiometry is critical. Historically, operators have manually taken samples using a portable electrochemical type Os analyzer. While giving more or less satisfactory results, the requirement for more stringent ...

  • Full-scale SVE system operates in tandem with groundwater treatment

    Since 1993, SVE has been implemented using two designs at the TP Industrial, Inc. (TPI) site in Gardena, CA, to treat soil contaminated with chlorinated solvents. The SVE system was modified in 1997 to improve emissions control efficiency by using carbon adsorption units that treat effluent from an air-stripping system for treating site ground water. By the end of 2007, SVE had removed a ...

  • Smart LDAR — more cost-effective?

    On December 19, 2008, EPA issued a final rule establishing a voluntary Alternative Work Practice (AWP) to detect leaks of volatile organic compounds (VOC) and hazardous air pollutants (HAP) from process equipment (FR Vol. 73, Number 246), thereby providing the regulated community additional flexibility in complying with leak detection and repair (LDAR) requirements. The AWP allows owners or ...


    By Trinity Consultants

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By Sigrist-Photometer AG

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you