stack sampling equipment Articles

  • The 10 Key Factors in Selecting a Stack Sampling Firm

    Summary: This document is a summary of the key factors that you should take into consideration when hiring a stack testing firm.This has been prepared in conjunction with the ASTM criteria for standard practice of testing companies.The ASTM criteria has been supplemented, based on 125 years of direct testing experience, which is the combined years of experience of the individuals that contributed ...

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...

  • The Portable FID for Stack Emissions: lightweight, compact, ergonomic, safe

    POLLUTION S.r.l. manufactures POLARIS FID analyser, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...

  • Determination of TOC in stack through the innovative FID analyser easy to carry - Case Study

    PROBLEM: The industrial chimney's emissions of Volatile Organic Compounds (VOCs) are becoming issues of global importance and to have an accurate knowledge about how to test VOC turns into a strategic issue. VOC emissions are quantified and monitored according to standard EN 12619, using FID analyzer which uses hydrogen and other reference gases in ...

  • The Flexibility & Versatility of a Portable Emissions Analyzer

    Issue Fixed CEMS (Continuous Emissions Monitors) Measure at One Location CEMS are fixed units that typically only measure from one sample location which is usually on a main centralized stack. This main stack is often fed by several separate emissions sources throughout the plant such as boilers, heaters, engines, ovens, and furnaces. If the CEM ...

  • Analysis of TNT and RDX in groundwater

    MATRIX: Water ANALYTE: TNT and RDX LIMIT OF DETECTION: TNT 1 ppb (mg/L), RDX: 5 ppb (mg/L) BACKGROUND: This application describes a field screening method for determining TNT and RDX concentrations in water. The method uses solid phase extraction to remove and preconcentrate the analytes from water. In the method, a 2 ...


  • It’s not just clean; it’s CETCOclean - chemical cleaning of 10”and 8” ethane pipelines

    CETCO Oilfield Services Pipeline Division chemically cleaned 10” and 8” ethane pipeline segments prior to an in-line inspection (first time ILI on the 10” pipeline). The operator’s primary concerns were flow interruptions to the receiving plant and ensuring that all line debris was collected prior to entering the downstream 8” section. CETCO designed and supplied all necessary equipment and ...


    By CETCO Energy Services

  • EPA mandatory reporting of GHGs rule

    Recent EPA Guidance EPA does not intend for the calibration requirements of 98.3(i) to apply to any units where the rule allows the use of “company records” to quantify fuel usage or other parameters; however, a facility’s GHG monitoring plan must include descriptions of the procedures and methods used for quality assurance, maintenance, repair of all flow meters ...


    By Trinity Consultants

  • Innovative emissions monitoring uptake soars

    Firms in the UK’s waste and power sectors are proactively seeking Best Available Techniques for emissions monitoring, according to Enviro Technology. Over recent months there has been a surge in demand for sophisticated equipment, such as monitors of total gaseous mercury. The air quality and emissions monitoring specialist believes that a combination of factors, such as the recast ...

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Keeping Pace with PTP and CCRL

    Two, three or four times a year, laboratories around the world check their performance with testing programs from ASTM International’s Proficiency Testing Program and the Cement and Concrete Reference Laboratory. Using samples sent for a particular program cycle, labs run specific methods and submit their results to PTP and CCRL for analysis. Each lab then receives reports that serve as a ...


    By ASTM International

  • The Flexibility & Versatility of a Portable Emissions Analyzer - Case study

    Issue Fixed CEMS (Continuous Emissions Monitors) Measure at One Location CEMS are fixed units that typically only measure from one sample location which is usually on a main centralized stack. This main stack is often fed by several separate emissions sources throughout the plant such as boilers, heaters, engines, ovens, and furnaces. If the CEM ...

  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...

  • Recovery of Precious Metal Catalysts - A New Process Using Supercritical Water Oxidation

    Up to now, the recovery of precious metals used as catalysts in chemical processes has involved the use of incineration. Now, however, a British-Swedish joint venture has developed a process which uses supercritical water oxidation instead, which provides many economic and environmental advantages. Precious metals are used extensively in catalysts in a wide range of industrial chemical processes. ...

  • Gas cell selection for analysis of electronic gases

    APIMS and FTIR remain the preferred analytical tools for monitoring impurities in the electronic  specialty gases used by the semiconductor industry, although other tools such as CRDS are currently finding application in selected cases. FTIR spectroscopy offers the advantage of the simultaneous measurement of all gaseous species that exhibit dipole moment changes during vibrations at ...


    By CIC Photonics, Inc.

  • Odor Control Advances at Composting Facility

    The Rockland County (New York) Cocomposting Facility began operations in February, 1999, processing biosolids from the five publicly owned treatment works (POTWs) in the county. The Rockland County Solid Waste Management Authority (RCSWMA) owns the facility, but contracted with Waste Management of New York to design, build and operate (DBO) the 110 wet tons/day agitated bin composting facility ...


    By BioCycle Magazine

  • Catalytic Oxidizers…What You Should Know.

    Within the U.S., depending upon specific plant operations, geographic locations, etc.,  many companies concerned with controlling VOC emissions have been operating air pollution control systems for years.  However, due to business expansion, plant modifications or recent changes in EPA guidelines, an increasing number of companies are now finding it necessary to install new emission control ...


    By The CMM Group, LLC

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you