steam generating thermal oxidizer Articles

  • Case study - Waste heat generates steam and savings

    OVERVIEW A coil coating facility purchased a new a 15,000 SCFM Regenerative Thermal Oxidizer (RTO) which had a nominal heat transfer efficiency rate of 90% thermal energy recovery. It was designed with supplemental fuel injection (SFI) which is used during low VOC loading conditions, to help save fuel cost.  The facility was looking for additional ways to decrease their exhaust ...

  • Thermal Desorption

    Untitled Document Introduction: ...

  • Case study - Oxidizer system optimization

    OXIDIZER SERVICE SERIES: PART 4 As promised, this is the fourth installment of Anguil's Oxidizer Service Series. If you have read through the first three parts, this can be seen as a capstone of those efforts. Having a strong oxidizer service plan, backed up with recommended spare parts and all of the proper documentation will not only improve your system performance but also allow you to focus ...

  • The Other Side of Zirconium Oxide case study

    Regular Fuel Efficiency Applications Separate Oxygen and Combustibles Sensors In standard flue gas applications for Thermox analyzers, the user generally tries to extract the maximum energy from the fuel and transfers as much of that energy as possible to the process. These applications require the process to be operated as efficiently as possible by keeping both oxygen (excess air) and ...

  • How to Optimize Oxidation Systems for Efficient Operation

    Emphasis on air management within converting-process dryers and ovens is critical to the design of pollution-control systems for treating exhausts containing VOCs (volatile organic compounds). Efficient air management allows the pollution-control system to be optimally sized to meet the needs of the process. Good process control further defines the emission stream by avoiding the need for large ...


    By Babcock & Wilcox MEGTEC

  • Case study - Oxidizer energy recovery options

    Overview The mainstream media today is full of allusions to energy awareness and conservation. Just as visible these days are media references to astronomical dollar figures that can boggle the mind. This article does not seek to break out of that mold, but rather to conform to it – as Oxidizer Stack Heat Recovery offers a tremendous opportunity for both energy conservation and ...

  • Thermal Power - Guidelines for New Plants Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Sensitivity analysis in a simulated auto thermal Natural Gas reforming process

    Auto Thermal natural gas Reforming (ATR) is one of the mostly used conventional hydrogen generation technologies by the highly developed countries. ATR reactors do not need any direct or indirect heat exchanger, and that is why they are more compact and so preferable than the other reformers. In this study, a process including reformers, carbon dioxide sequestration and a cryogenic separation ...


    By Inderscience Publishers

  • Case study - Maximizing heat recovery from your oxidizer and reducing operating costs

    More and more, companies operating air pollution control equipment today realize that the initial capital cost of an oxidizer system can be rapidly eclipsed by continued operating expenses if careful attention is not periodically given to the system. Below are ten tips to ensure your oxidizer is operating at peak performance. The first five tips focus on parameters end-users should know about ...

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • WIRAJASA Waste Oil Burner

    Brief description on our patented Waste Oil Burner that was introduced in 2008. This innovative device works on two key principles namely pre-heating of waste oil and application of super-heated water or sub-critical steam to enhance the oxidation of heavy oil. Heating capacity of this burner is adjustable starting from 700,000 BTU/hour to 1,400,000 BTU/hour is suitable for various thermal ...


    By CV Wirajasa Teknik Industri

  • Case study - Keeping ethanol production green

    OVERVIEW Originally published in Pollution Engineering Magazine. In an effort to reduce the world’s dependence on fossil fuels, there has been a major push towards alternatives. Ethanol has been at the forefront of this movement because it reduces greenhouse gas emissions from automobiles and its production has a positive net energy balance. The homegrown fuel also ...

  • Air Pollution Control in the Printing and Web Coating Industries

    For many U.S. companies in the printing and web coating business, the use of an Air Pollution Control System (APCS) to control harmful air pollutants is not new.  In these industries, depending upon their location, companies have been installing APCS since the early 1970's.  However, for some companies the clock is still ticking regarding their compliance with local, state and federal ...


    By The CMM Group, LLC

  • Put energy into emission control projects

    Many companies feel pressured to spend the least amount possible to meet environmental regulations, primarily because compliance isn’t a profit generating endeavor. What some environmental and compliance managers fail to realize is that emission control equipment can quickly become a profit decreasing endeavor with this penny wise-pound foolish approach. With mandatory greenhouse gas (GHG) ...

  • Case study -Operating cost reduction strategies

    Overview More and more, companies operating air pollution control equipment today realize that the initial capital cost of an oxidizer system can be rapidly eclipsed by continued operating expenses if careful attention is not periodically given to the system. ACTION Below are ten tips to ensure your oxidizer is operating at peak performance. The ...

  • Case study - Amine tail gas treatment

    COVERING YOUR TAIL GAS The discovery of new shale formations throughout the world and the development of new drilling technologies have increased natural gas production and prompted government agencies to instigate tighter air-pollutioncontrol regulations on processing operations. Unfortunately, meeting environmental regulations is not a profit-generating endeavor. Simply put, the time ...

  • Data Requirements for Soil, Sediment, and Sludge

    Site soil conditions frequently limit the selection of a treatment process. Process-limiting characteristics such as pH or moisture content may sometimes be adjusted. In other cases, a treatment technology may be eliminated based upon the soil classification (e.g., particle-size distribution) or other soil characteristics. Soils are inherently variable in their physical and chemical ...

  • Biofilter Applications in the Coatings Industry.

    Soaring energy costs and the high cost of ‘end-of-pipe’ pollution control equipment has caused companies and regulatory agencies to re-evaluate ‘unconventional’ means of achieving VOC and HAP emissions control. The coatings industry is an excellent candidate for alternative, unconventional controls, as VOC and HAP reductions have not been as strident as has been the case in many other industries. ...


  • Paragould AR case study

    Maximum Capacity Expected Increased population in Paragould, Ark., forces city to expand wastewater treatment plant to better manage sludge disposal Does this sound familiar? Your lagoon is filling with both primary and secondary sludge, and will be at capacity within the next two years. Paragould, Ark., a growing city of 22,500 located in northeast Arkansas, had just that problem. ...


    By Komline-Sanderson

  • Food Processing: Odor Control in Edible Oil Processing

    Abstract: The problems with odor around a typical edible oil deodorizer are discussed in detail, and a three-step solution to eliminate these problems is presented. The three steps are a distillate recovery system which recovers most of the fatty acid in the deodorizer vapor discharge as a valuable byproduct, a closed loop barometric cooling water system which keeps the fatladen ...


    By CR Clean Air Group, LLC

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you