steel oil-water separator Articles

  • Oil Water Separator Maintenance

    Oil water separators (OWS) can be co$tly to maintain, $20,000 or more on average per cleaning and if not properly managed, can be very expensive conduits of pollution. Have you taken steps to minimize the effects and consequences on your operating co$t? When was your facility’s last OWS maintenance ...

  • Separation

    Introduction: Ex situ separation can be performed by many processes. Gravity separation and sieving/physical separation are two well-developed processes that have long been primary methods for treating municipal wastewaters. Magnetic separation, on the other hand, is a much newer separation process that is still being tested. Gravity Separation Gravity ...

  • Synthesis of graphene oxide–SiO2 coated mesh film and its properties on oil–water separation and antibacterial activity

    Oil–water separation has recently become a worldwide challenge due to the frequent occurrence of oil spill accidents and increasing industrial oily wastewater. In this work, the multifunctional mesh films with underwater oleophobicity and certain bacteriostatic effects are prepared by layer-by-layer assembly of graphene oxide-silica coatings on stainless steel mesh. The mesh film exhibits ...


    By IWA Publishing

  • AAA Class Stainless Steel Lubricating Oil Purifier

    Zhongneng’s Oil Treatment technology can bring you this!   -TYA High Vacuum UCO Processing Machine | Used Cooking Oil Purifier   Application: The TYA High Vacuum Oil Purification System is made of stainless steel material, it is especially designed to remove ...


  • A Guide to Oil in Water Monitoring for Environmental Compliance

    Applications for industrial oil in water monitoring can vary greatly. In upstream and midstream oil and gas production applications, monitoring separation efficiencies is key to optimize production rates, preventative maintenance, chemical use, flow, and environmental compliance. Separated water from the oil is called produced water and it must be cleaned of oil before disposal or ...


    By Arjay Engineering Ltd.

  • Separation tank / Floating tank for separation of different kinds of plastic

    The NEUE HERBOLD – Separation Tank Type TB is used for separation of  plastics with various densities, primarily for film flakes, granulate from  PET bottles and other rigid types of plastics. Depending on the application, floating particles like film falkes or sinking particles like PET bottle flakes are separated from other high density plastics. The standard separation tanks ...

  • Case study 103: Oil well and salt water disposal site

    Operational Profile Type of Operation: OilWell,Salt Water InjectionWell Location: Texas Equipment: 10x20water knockout, 6x20 heated vertical separator b/d: 3800 bbl Gravity of oil: 41 degrees BS&W beforestudy: 0.04% Unit size: 3” ...


    By Eco1st Technology Group

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • Separate cash flow valuation – applications to investment decisions and tax design

    Oil project assessment using separate cash flow valuation (Jacoby and Laughton, 1992; Laughton and Jacoby, 1993; Emhjellen and Alaouze, 2002), presumes that the present value of the cost cash flow of oil projects can be calculated using a risk free rate. This paper examines whether this practise, at least to a first approximation, is reasonable. More specifically, the paper examines whether ...


    By Inderscience Publishers

  • Steel coating mill saves $450k. with fluid purification program

    The Problem: A leading manufacturer of electro-galvanized and aluminized steel coil products, used as body panels in the automotive industry, was experiencing quality defect issues due to residual surface oil left on the parts after cleaning operation. In order to meet the surface finish specifications of the finished sheet, the mill requires all incoming steel coil stock to be pickled and oiled ...

  • A feasibility study of magnetic separation of magnetic nanoparticle for forward osmosis

    It was recently reported that a UK company has developed a naturally non-toxic magnetoferritin to act as a draw solute for drawing water in forward osmosis process. The gist of this technology is the utilization of the magnetic nanoparticle and high-gradient magnetic separation for draw solute separation and reuse. However, any demonstration on this technology has not been reported yet. In this ...


    By IWA Publishing

  • Double the amount and resale price of the reusable steel with TANA Shark 440DT - Case Study

    Our customer from southern Europe uses tyre shreds as an alternative heat source instead of coal and oil in a process of making cement out of chalk stone. Formerly they used electric, stationary shredder without an over-band magnet. After changing the machinery to TANA Shark 440DT, the diesel-driven mobile waste shredder on tracks, the customer has been very satisfied on both the improvements in ...


    By Tana Oy

  • Development of Technology for Separation of Aluminium Oxide from Ash and Slag of Kuzbass Thermal Power Plants

    Abstract The paper presents a joint research made by the Siberian State Academy for Mining and Metallurgy and the Institute of Metallurgy and Concentration of the National Academy of Sciences, Kazakhstan, on separation of aluminum oxide from ash and slag of Kuzbass thermal power plants. This work is an integral part of 'The Development of a Technology for Deep Processing of Waste from Thermal ...


  • Texas Instruments - A Novel Separation Technique for the Analysis of Trace Levels of Atmospheric Contaminants in Inert Semiconductor Process Gases

    A NOVEL SEPARATION TECHNIQUE FOR THE ANALYSIS OF TRACELEVELS OF ATMOSPHERIC CONTAMINANTS IN INERTSEMICONDUCTOR PROCESS GASES J. Scott McWilliams, Alan Johnson, Charlene Long, Jeremiah D. Hogan*Texas Instruments, Inc.Dallas, TX 75265 Low ppb detection limits for contamination in cylinder gases have been achieved with gas chromatography using a modified gas ...


    By Environics, Inc.

  • Oil Skimmers, Inc., solves waste oil problems quickly and easily

    Many types of industrial processes create waste oil, which can be time-consuming and expensive to collect, store, and dispose of. Worse yet, without constant effort to remove them, residual oils can build up and cause hazards, contamination, and machine downtime. In the metals industry, oil waste comes from machinery and components used to make steel and other metals, as well as from cleaning ...


    By Oil Skimmers, Inc.

  • Oil skimmers cure a header headache

    Oil skimmers are being used in a major Cleveland bolt making plant to clean liquid coolant and clear the air, virtually eliminating the oil smoke and haze that are inherent in hot heading applications. The skimmers are equally efficient in less demanding press operations. Lake Erie Screw Corporation installed the five skimmers - they are Abanaki models - to serve from one to seven headers each. ...


    By Abanaki Corporation

  • Choosing an Oil Skimmer for the Machine Shop

    Advantages of Using an Oil Skimmer: The use of an oil skimmer in the machine shop setting holds many benefits. Removing the oil from a machine coolant tank will initiate some esthetic benefits such as cutting down on the amount of smoke generated from the cutting tool coming into contact with oil laden coolant. When a machine is shut down for the weekend, oil has a chance to come to the ...


    By Abanaki Corporation

  • The Challenge of Removing Surface (free-floating) Oil

    Imagine tackling your greatest production challenge quickly, easily and inexpensively. Now imagine tackling your greatest production challenge quickly, easily and inexpensively – and even generating a profit while doing so. For businesses and industries that deal with oil separation and removal, the solution does not need to be expensive or inefficient. In fact, the answer may be simpler ...


    By Oil Skimmers, Inc.

  • Series KPH transformer oil regeneration device

    Application: Series KPH transformer oil regeneration device use of a special active clay for purifying and regenerating the unqualified transformer oil, switch oil, mutual inductor, it also can be used as absorption unit for treating low viscosity lube oils. Series KPH can remove acid, free carbon, oxides, pigment and particles, it dose not affect insulating oil ingredients and anti-oxidation. ...


    By rier oilpurifier company

  • A way to skim and save: a guide to oil skimming

    Plant personnel are always looking for new tools and equipment to help them run their facility more efficiently. In many manufacturing and processing plants, oily water is present, which prevents a plant from functioning efficiently. Water has several purposes in a manufacturing or processing facility. It can be used for cooling machinery, washing down equipment or in processing. Sometimes, this ...


    By Oil Skimmers, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you