steel safety can Articles

  • Pedestrian safety in the workplace

    What’s at Stake? We are constantly reminding our children about pedestrian safety.  We tell them to cross only at designated crosswalks and to look both ways before crossing the street, but often times to forget these safety basics in the workplace. Workplace traffic can be every bit as dangerous as that found on the city streets. In a collision between a 2000-pound ...


    By SafetySmart

  • Gas Safety in the Laboratory

    Modern laboratories use a number of gases as part of their daily operations. This blog details two of the most common methods of laboratory gas supply, and their associated safety risks and benefits. A number of gases are used in laboratories to support various applications such as Chromatography (GC and LC-MS) Spectroscopy, ELSD and Sample Preparation, to name just a few. Helium, hydrogen and ...

  • Compressed Gas Safety Guide

    Use and storage of any compressed gas under high pressure can be extremely dangerous if proper gas handling procedures are not observed. Moreover, chemical characteristics of specialty gases themselves can pose serious health hazards if containment is not tightly controlled. Paying close attention to a compressed gas product’s technical and safety information is invaluable for maintaining a safe, ...

  • Gas Safety in Confined Spaces

    Introduction An offshore worker ensures a vessel is safe to enter; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face common dangers, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited. A confined space ...

  • Gas safety in confined spaces

    An engineer repairs buried cables; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face a common danger, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited.  ...

  • The Safety Overshoe Has Come of Age

    When the safetytoe was first conceived – a steel toecap inserted into a rubber galosh – some in the safety world considered it unworthy. However, although referred to as an “ugly duckling, it had a practical purpose. It was its practicality that allowed it to survive, even in the face of some fierce institutional opposition. The safetytoe was a very cost-effective alternative to ...


    By Safetytoes International Inc

  • Chainsaw Operating Tips and Chainsaw Safety

    Although chainsaws are excellent tools for wood cutting, the potential for accidents is high and severe injuries can result from improper use. Chainsaw safety should always be your first priority. By taking the necessary safety precautions, you will avoid serious injury. Take some time out before you use your new chainsaw to read the owner’s manual. If you’re very familiar with ...


    By DR Power Equipment

  • Safety Considerations at Anaerobic Digestion Plants

    Anaerobic digestion is a collection of processes which naturally breakdown organic matter to eventually produce biogas - a methane rich gas which is burned to produce both heat and electricity. The methane can also be used as vehicle fuel or injected into the gas grid. The industry is growing fast and is forecast to continue to do so with many farmers adding bio-gas plants alongside their ...

  • Five Critical Parts For Your Steel Storage Tank

    Every year, we sell hundreds of parts for bolted tanks and welded steel tanks. Even though many ground storage tanks needing parts were not originally manufactured by Superior Tank Co., Inc., we can provide standard replacement components for steel storage tanks or can fabricate custom parts and accessories to ...


    By Superior Tank Co., Inc.

  • Types of planetary gear sets that we can supply and manufacturer

    The Types of planetary gear sets is a kind of planetary gear transmission principle, which adopts cycloidal pin gear meshing, and has an advanced design and novel structure. The reducer can be widely used in various transmission machinery, such as: lifting, transportation, mining, metallurgy, petrochemical, textile, printing and dyeing, light ...


    By Sogears

  • How a wet dust collector can prevent a violent explosion (and more!)

    Explosive dust is a major concern among metal finishing operations, and recent changes in the National Fire Protection Association regulations have made compliance more difficult. Metalwork grinding and sanding produces a fine metallic dust that, even after being filtered from the air, can smolder, catch fire, or even explode violently if it’s exposed to a spark. Aluminum, lithim, ...


    By ProVent, LLC

  • ‘Slipp-R’ Safety Toes Case Study

    The European footwear industry has been under siege from low-cost manufacturers abroad.  Fortunately, standards are in place to ensure 'cheap' does not mean 'less' when it comes to workplace safety.  Safety footwear coming into the European markets must meet or exceed the minimum requirements for toe and foot protection as laid out in the CE standards.  This is good news for European ...


    By Safetytoes International Inc

  • Update on the homeowner heating oil safety bill

    All homeowners in Massachusetts should be aware that on December 29, 2008, the State Senate enacted the long-awaited Homeowner Heating Oil Safety Bill as Chapter 453 of the Acts of 2008. It required homeowners to upgrade their existing oil heat supply line and insurance companies to offer coverage for a spill by July 1, 2010. On January 5, 2009, it was signed by the Governor. On June 30, 2010, a ...


    By Penney Engineering, Inc.

  • Increasing efficiency and safety of aluminium smelters – Case Study

    Energy consumption in aluminium smelters The basis for all modern primary aluminium smelting plants is the same: Aluminium oxide (Alumina) is dissolved in an electrolytic bath of molten cryolite (sodium aluminium fluoride) within a large carbon or graphite lined steel container known as a "pot". An electric current is passed through the electrolyte at low voltage, but very high ...

  • How to Evolve Safety from Protection to Prevention to Prediction

    I’m in the market to buy a new car. My shopping experience thus far has led me to be absolutely amazed by how much has changed in the automobile landscape in just a few years. The vehicle I’m replacing is only 6 years old, but in terms of technology and capability it already feels like an antique. One observation that stands out is the amazing pace of change in car safety. ...


    By Intelex Technologies Inc.

  • Why instrument hire makes occupational safety sense

    Background Decisions concerning the acquisition of occupational safety monitoring instrumentation are often made by operational staff that may not have visibility of the full financial implications of their choices. The following article will examine the factors affecting these decisions and explain why a strategic decision to hire instrumentation can deliver substantial and wide-ranging ...


    By Ashtead Technology Ltd

  • Identification and control of safety and health hazards in metal scrap recycling

    The audience for this guide is anyone who works in the metal scrap recycling industry—employers, employees, safety professionals, and industrial hygienists—should read this publication. This guide can help you identify and manage the hazards associated with exposure to various metals and processing chemicals and with related processes and equipment used in metal scrap recycling operations. Why is ...

  • CO2 Monitor For Breweries: Carbon Dioxide Safety and How to Stay Safe

    Carbon dioxide is a necessary byproduct of the brewing process, yet too much CO2 can be dangerous to employee health. In Germany, two workers died at the same brewery in 2012 due to hazardous levels of CO2 present in beer mixing and pressure tanks. Learn more about how CO2 levels can get out of control during the beer brewing process and ways to protect your staff from this deadly gas.  ...

  • Knowledge survey based on published works in the area of WWER reactor pressure vessel steels microstructure

    The effects of intensive fluxes of neutrons, thermal ageing or other external factors result in considerable changes of material microstructures and properties. In particular, the development of the fine scale radiation-induced defects which impede the dislocation motion under the applied stress, known as the irradiation embrittlement, leads to mechanical properties degradation which can results ...


    By Inderscience Publishers

  • C2 CalibrationSolution for a major steel company improves tracking of inventory and reduces calibration time

    At their large ship unloading docks in the port city of Sao Paulo, Brazil, a major steel company unloads large amounts of coal for their steel manufacturing operation. The coal is unloaded from the ships using a large crane that stands more than 200 feet high, and can be moved into place by a drive/track system. After the coal is unloaded into the massive hoppers in the structure, conveyor belts ...


    By Hardy Process Solutions

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you