sulfur burner Articles

  • Treatment Options for Molten Sulfur Storage

    Documento sin título ...


    By Merichem Company

  • Suspension Burning for Tire Fuel Optimization in Precalciner Cement Kilns

    Synopsis: A presentation on optimizing substitution rates of Tire Derived Fuel (TDF) in precalciner kilns using Suspension Burner technology.  Discussions will be made on the challenges faced by both preheater and precalciner kilns using TDF on the feed shelf, technical measures aimed at solving these limitations, achieving high TDF ...


    By AFS Technology

  • Combustion Of Heavy Fuels And Liquid Wastes

    This paper describes the design and operating conditions of liquid and gas combustors for heavy fuels and liquid wastes. Lower fuel prices can be achieved by switching from light oil to heavy ones, or combining with unconventional waste fuels. Unconventional waste fuels such as energetic off gases and organic liquid waste require especially designed combustion equipment like a special combustor ...

  • `Sensitivity of Condensable Particulate Matter Speciation on Predicted Visibility Impacts – Case Study,` presented at the NCASI West Coast Conference, September 2005

    Introduction This paper evaluates a realistic case study for an existing major emission source that is required to evaluate visibility impacts at a nearby federally-protected Class I area. The fictitious source is a 1960's era coal-fired electric generating unit (EGU) characterized as a pulverized coal-fired, dry bottom, wall-fired boiler equipped with PM and NOx controls (i.e., ...


    By Trinity Consultants

  • Urban Air Quality Management

    ' Poor air quality due to pollution is a serious environmental problem in most urban areas. The greatest burden of pollution is on human health. Urban air quality management requires an integrated approach that (i) identifies the most serious problems and measures that offer cost-effective and feasible solutions across a range of economic sectors and pollution sources including industries, ...


    By The World Bank

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • Petroleum Refining Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Case study - Reactor vent emission control

    OVERVIEW Many chemical and petroleum companies use batch reactors to make their products.  These reactors typically have vents which are opened and closed during emptying, filling, mixing, heating or cooling and other steps of the production process.  The gases coming from these vents must be controlled under most government regulations.  Generally speaking, the ...

  • Case study - Destruction of inert process emissions

    Many chemical companies use batch reactors to make their products.  These reactors typically have vents which are opened and closed during emptying, filling, mixing, heating or cooling and other steps of the production process.  The gases coming from these vents must be controlled under most government regulations.  Generally speaking, the emissions produced are inert (little or no ...

  • Difficult Complex Decisions For Coal-fired Power Plant Operators

    Changing fuel prices, government regulations and technology all combine to make decision making difficult for operators and developers of coal-fired power generation facilities around the world. Power plant designers in developing countries face new local environmental regulations plus additional requirements stipulated by lenders such as the World Bank. In the developed world, the regulations ...


    By The McIlvaine Company

  • Cleaning Up Gasification Syngas

    Documento sin título ...


    By Merichem Company

  • Understanding Air Pollution Control System Design Specifications

    As the full effect of the Federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many different companies will be required to install new or additional air pollution control equipment.  With well over twenty-five years of proven success in a variety of industries, thermal and catalytic oxidation has become a popular method for controlling volatile organic compound (VOC) ...


    By The CMM Group, LLC

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Air Pollution Control Specs

    As the full effect of the federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many companies will be required to install new or additional air pollution control equipment.  With more than 25 years of proven success in a variety of industries, catalytic and thermal oxidation has become a popular method for controlling volatile organic compound (VOC) and hazardous air ...


    By The CMM Group, LLC

  • Small project PSD cautions

    Following U.S. EPA’s promulgation of the PSD and Title V GHG Tailoring Rule, electric utilities, facilities with large industrial boilers, and other heavy industry manufacturing operations should be aware that the Prevention of Significant Deterioration (PSD) significance threshold for greenhouse gases (GHGs) may be the most stringent PSD triggering threshold for certain projects. Even ...


    By Trinity Consultants

  • EPA proposes updates to CISWI rules

    On June 4, 2010, the U.S. EPA proposed updates to the Standards of Performance for New Stationary Sources (NSPS) for Commercial and Industrial Solid Waste Incineration (CISWI) Units (NSPS Subpart CCCC) and Emission Guidelines (EG) for Existing CISWI Units (EG Subpart DDDD), collectively referred to as the "CISWI Rules." In order to describe the proposed updates to the CISWI Rules, it is necessary ...


    By Trinity Consultants

  • Taking Fossil Fuels to the Next Level - Standards Underpin Extraction, Processing and Distribution

    To the average person, the oil and gas industry may appear simple — a matter of literally tapping into a natural resource and distributing it to customers. Of course the matter of extraction is rarely simple, and in the case of emergent hydraulic fracturing technology, it is particularly complex and capital-intensive. In fact, the world of petroleum and natural gas extraction, distribution ...


    By ASTM International

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you