table magnet Articles

  • The Electro-magnetic forces

    In this research we will introduce the new technique Electro– magnetic forces to filtrate the lubricant oil from the dust of the natural or artificial solid metals. DC type voltage within the range of 0–30 Volts were used on a steel meshes (Porosity=0.83) and for the steel discs (P=0.0885), while the range of 0–200 Volts were applied for the steel meshes (P=0.787) .The preliminary investigations ...


  • Rare earth magnet minerals in China

    Recently in China, the ministry of industry and information released on its websites, ministry of industry and information, ministry of land and resources, National development and reform commission, etc, 6 ministries in total, jointly issued the notice concerning the special action of renovation towards the national rare earth magnet production. The action will last from August 1st to ...


    By Stanford Magnets

  • Neodymium Magnets Grade Data Sheet

    As the strongest type of commercial magnets, neodymium magnets are graded according to their maximum energy product. For example, Grade N35 indicates that the maximum energy product of a N35 magnet should be 35MGOe. The actual energy product of a N35 magnets could be range from 33-35 MGOe. The highest grade available is N52. The pull ...


  • Sweed model 5703 XHD magnetic separator system

    Built for the most extreme linear scrap challenges Model 5703 XHD Chopper Put four cable-annihilating rotary knives on a beefy 600 lb flywheel that’s driven by up to 60 HP of raw power and you have a super heavy-duty rotary shear with a serious appetite. Sweed’s taken their popular 5703 rotary shear, originally introduced in the early 90’s, and ...


    By Sweed Machinery, Inc.

  • UE: risk of shortage for 8 rare earth metals

    In a report published on November 4th, the European Joint Research Centre (JRC) has warned of the "risk of shortage" in 2020-2030 of eight strategic metals used in low carbon energy technologies identified in the European SET Plan adopted in 2008. This report continues the work done in a previous study of the JRC from 2011. It is also based on the scenarios presented in 2011 in the roadmap of ...


    By Stanford Magnets

  • Regeneration of used oil

    Used oil regeneration technologies Over time, oil accumulates oxidation products, contaminants and impurities which drastically reduce its quality. Contaminated oil can no longer meet quality requirements and must be changed. Waste oil is collected and regenerated to retain valuable basic materials. Oil cannot be recycled at petroleum processing plants with ...


    By PC GlobeCore

  • Microfiltration Pilot System, California

    INTRODUCTION In May 2013, Pure Aqua, Inc. successfully manufactured and supplied an microfiltration pilot system to a membrane manufacturer for Title 22 certification. Title 22 is the State of California’s stringent standard for treatment/disinfection of wastewater for non-potable reuse and ...


    By Pure Aqua, Inc.

  • What is `Fishing`? SRS Crisafulli Studies Oil and Gas

    What is "Fishing"?   SRS Crisafulli Studies Oil and Gas Residents of Eastern Montana and Western North Dakota are fortunate to have access to many natural resources. Outdoor recreation is a popular past time here, with fishing at the top of the ...


    By SRS Crisafulli, Inc.

  • Surface Decontamination of Nickel Compounds (Nickel Nitrate (Ni(NO3)2)) by DeconGel 1101

    Abstract Surface decontamination efficacy determination of DeconGel™ 1101 on stainless steel, carbon steel, and concrete surfaces contaminated with nickel nitrate (Ni(N03)2) was performed with ICP-OES (Inductively Coupled Plasma-Optical Emission Spectroscopy) according to Environmental Protection Agency (EPA) SW-846 Methods: 3005A (sampling) and 6010C (analysis). ...


    By METIS Scientific

  • Case study - Increasing efficiency with permanent leakage monitoring

    Abstract In this paper information from Water Authorities in the USA, Europe, Middle East and Australia that have purchased permanent monitoring leak detection equipment is reviewed and the findings are presented in a structured format that covers the following: Justification for permanent monitoring Evaluating the different product offerings ...


    By Gutermann AG

  • Development of Technology for Separation of Aluminium Oxide from Ash and Slag of Kuzbass Thermal Power Plants

    Abstract The paper presents a joint research made by the Siberian State Academy for Mining and Metallurgy and the Institute of Metallurgy and Concentration of the National Academy of Sciences, Kazakhstan, on separation of aluminum oxide from ash and slag of Kuzbass thermal power plants. This work is an integral part of 'The Development of a Technology for Deep Processing of Waste from Thermal ...


  • Skid mounted BWRO Systems, Venezuela

    INTRODUCTION In July 2013, Pure Aqua successfully manufactured and supplied five skid mounted BWRO systems to a major company in Venezuela. The skid mounted BWRO systems came complete with am activated carbon filter for chlorine ...


    By Pure Aqua, Inc.

  • C18 extraction of atrazine for increased sensitivity in the RaPID Assay

    Performance of an increased sensitivity method utilizing an extraction and concentration step to increase analyte concentration of the assayed sample is presented. Recently, Shepard and Carr (1992) reported a method for increased detection of atrazine by gas chromatography using C18 solid-phase extraction (SPE) with a 10 mL water sample. An application with BakerbondÒ C18 SPE columns for ...


  • Wastewater sterilization (purification): completely new method “vortex layer machine”

    The purification and safe disposal (neutralization) of industrial waste water effluents represent a very important ecological problem. The principal problem or requirement involves reducing the concentration of harmful impurities to concentration levels below their maximum allowable concentration limits. In fulfilling this requirement the amount of fresh water consumption needed to maintain the ...


    By GlobeCore GmbH

  • The essential functional features of the high-speed CNC grinder

    High-speed CNC grinder has very high requirements for the main functional parts. First of all, it requires to be a high spindle speed and power. Secondly, cnc hard turning lathes table requires a high feed rate and motion acceleration. What’s more, NC grinding’s ...


  • Coal Powder Plant

     Coal Crushing Plant,Coal Powder Plant,Coal Grinding Process The feeders load the ROM coal onto a reclaim ...


  • "A Non-Chemical Water Treatment for Cooling Towers"

    Untitled Document Introduction This paper will describe a case study of a ...


    By Dolphin WaterCare

  • Turning metal wires from pulp bales into profit with TANA Shark

    Metal wires from paper pulp bales are high in value but very hard to shred and clean for selling purposes. Usually the metal wires are stuck with plastics and some remains of the pulping process. This particular type of waste is almost impossible to separate, says a landfill operator in France. Normally the only possibility to handle this type of waste is to dump it at a landfill. This is due ...


    By Tana Oy

  • Controlling the addition of Chlorine into a Process

    There are several methods for controlling the addition of chlorine into a process. These methods include flow proportional injection, ORP (oxidation reduction potential) or a residual chlorine analyzer. Each method measures a different process characteristic. Depending on the specific type of process being controlled, there generally is a best choice for controlling the injection of either ...


    By Walchem, Iwaki America Inc.

  • SGS Informs You on the Recent Settlements of California Prop 65

    California Proposition 65 for Consumer Product Safety California’s Proposition 65 is now over 25 years old and has been effective in reducing exposures to toxic chemicals. It allows California residents to eliminate carcinogens and reprotoxic chemicals from consumer products and industrial activities.  Persons doing business with ten or more employees, unless otherwise ...


    By SGS

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you