thermal oil heater Articles

  • Biomass fired thermal oil heater case study

    This 12 MWth output Biomass Power Plant is one of the turnkey products of Biomass Power. The plant was fully commissioned in December 2006. The system has a capacity of 12 MW thermal output producing up to 10MWth of 300°C 10 Barg pressure hot oil, up to 10 tonnes per hour of steam and 2 MWth of 200°C hot air. This is all achieved from one grate heating three separate heat exchanges. The ...


    By Biomass Power Limited (BPL)

  • Hurricane HR Cyclones to capture fine fly ash particulate enabling the use of wood waste fired thermal oil heater for Sonae Indústria - Case Study

    The company was forced to use a natural gas fired hot gas generator for drying fibre despite having the necessary amount of thermal energy available in the exhaust stream of a wood waste fired thermal oil heater. The problem of using the biomass thermal oil heater laid on the emission of fine burnt and unburnt particulate which were carried over with the dried fibre and finally deposited on the ...

  • Chemical, Physical, Mineralogical, Morphology Characteristics of a Thermal Power Plant Washing Waste

    Most of electricity is generated by thermal power plants in Iran. Shahid Rajaee thermal power plant consists of four 250MW natural gas and fuel oil burning units that is located at 100 km west off Tehran. As a result of fuel oil burning in winter time, boilers air heaters are washed and cleaned frequently. The wastewater originating from air heater washing contains suspended ...


    By University of Tehran

  • Pumps for synthetic heat-transfer liquids

    As soon as the temperature in a heat-transfer system becomes too high for water, a plant operator must choose between petroleum-based or synthetic oils as the heat-transfer liquid. When modern petroleum oils are used, systems with feed temperatures up to about 300 °C can stay in service for their entire service life with one filling and with virtually no maintenance. Once feed temperatures ...


    By ALLWEILER GmbH

  • Case study: EPA region 9

    ISTR Overview Neighborhood: Industrial Heating Tubes: 14 Target Temp: 325 ˚C Heating Period: 130 Days Target: 0.9 mg/kg for Benzene Contaminant: TPH-d TPH-mo Benzene Naphthalene BaP Geology: ...

  • Plan B 4.0 by the numbers - data highlights on solar energy

    Concerns about global warming, rising fossil fuel prices, and oil insecurity have prompted calls for a new energy economy, one that replaces fossil fuels with renewables. The sun is an enormous reservoir of energy; in fact, the sunlight reaching Earth in just one hour is enough to power the global economy for a whole year. Harnessing some of this energy is an essential component of Earth Policy ...


    By Earth Policy Institute

  • The design of static mixer heat transfer equipment for adhesives, sealants, resins and polymers.

    The fluids handled within the adhesives and sealant industries are amongst the most difficult to handle of any in the main process industries globally. The characteristics which make them particularly difficult to handle include: High viscosities (typically 1-2000 Pa.s, or 1000 to 2 million cP). Often non-Newtonian (viscosity is not constant and varies with shear rate). Some ...


    By National Oilwell Varco

  • Hurricane and ReCyclone MH Systems for PM Emission Control on biomass boilers’ flue gases Total flow 92 132m3/h @ 230°C - Case Study

    FOREWORD Advanced Cyclone Systems, S.A. (ACS) designed and installed, on a turnkey basis, a hurricane3 system and a Mechanical ReCyclone (ReCyclone MH) for Particulate Matter (PM) emission control of the flue gases from two biomass boilers. The installation took place in Nelspruit, South Africa, at the wood-based panels plant Sonae Novoboard, owned by Sonae Industria (SI). ...

  • Hurricane and ReCyclone MH Systems for PM Emission Control on biomass boilers’ flue gases Total flow 92 132m 3/h @ 230°C - case study

    FOREWORD Advanced Cyclone Systems, S.A. (ACS) designed and installed, on a turnkey basis, a hurricane3 system and a Mechanical ReCyclone (ReCyclone MH) for Particulate Matter (PM) emission control of the flue gases from two biomass boilers. The installation took place in Nelspruit, South Africa, at the wood-based panels plant Sonae Novoboard, owned by Sonae Industria (SI). Sonae ...

  • Dazed and Confused: Alternative fuels and the CISWI definitions rule

    As discussed in ALL4’s December 2008 issue of 4 The Record, the use of alternative and non-traditional fuels for heat and power generation is on the rise, an increase that can be attributed to the price surge and volatility of traditional fossil fuels, as well as to a general desire to use more environmentally friendly materials to reduce greenhouse gas emissions. Alternative fuels have been ...


    By All4 Inc.

  • Tuning Your Boiler for EPA Boiler MACT Compliance

    The EPA’s Boiler MACT regulations are heating up. Boiler MACT is an EPA rule to limit hazardous air pollutants (HAP) from commercial and industrial boilers and process heaters. Originally proposed in 2011 as a mandate driven by the Clean Air Act,  the rules are Area Source Boiler MACT 40 CFR 63, subpart JJJJJJ for smaller boilers (stores, hotels, apartments, ...


    By Sierra Instruments, Inc.

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • Petroleum Refining Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Case study - Amine tail gas treatment

    COVERING YOUR TAIL GAS The discovery of new shale formations throughout the world and the development of new drilling technologies have increased natural gas production and prompted government agencies to instigate tighter air-pollutioncontrol regulations on processing operations. Unfortunately, meeting environmental regulations is not a profit-generating endeavor. Simply put, the time ...

  • On energy, we`re finally walking the walk

    The United States has entered a new energy era, ending a century of rising carbon emissions. As the U.S. delegation prepares for the international climate negotiations in Copenhagen in December, it does so from a surprisingly strong position, one based on a dramatic 9 percent drop in U.S. carbon emissions over the past two years and the promise of further huge reductions. Prominent among these ...


  • Controlling Stack Emissions in the Wood Products Industry

    Electrostatic precipitation has been a reliable technology since the early 1900's. Originally developed to abate serious smoke nuisances, the manufacturers of zinc, copper, and lead quickly found electric gas cleaning a cost efficient way to recover valuable product carried out of the stacks from furnace operations. Today electrostatic precipitators are found mainly on large power plants, cement ...


  • UAE’s MISP center accelerates pre-commercial tech development

    Almost three years after launching the Middle East’s first CSP plant, Masdar joined with Masdar Institute to launch late last year the region’s first CSP research and demonstration centre. Masdar Institute Solar Platform (MISP) builds around a set of unique facilities including a 100kW beam-down concentrating tower and its solar field, a hot-oil loop and thermal energy system (TES), ...


    By FCBI Energy

  • Eco-Friendly Thinking: Heating Your Home and Water With Biomass Fuel and Appliances

    With today’s struggles with carbon footprints, pollution, and finite energy sources, people are becoming more environmentally conscious. And if you’re thinking of transforming your home into a more eco-friendly structure, there’s a lot to consider. If you want to stray from your oil, gas, or electric heating system, consider investing in a biomass heating ...


    By Uzelac Industries, Inc

  • Efficient steam production in paper mills

    The paper and pulp industry is an energy and emission intensive industry. Steam is an essential part of the paper making process with steam boilers, steam distribution systems and other processes accounting for a large percentage of a paper mill’s energy costs. Useful energy is often lost from boilers and process equipment such as heat exchangers, dryers, evaporators etc, as well as from ...

  • Renewable energy progress report

    What is the Renewable energy progress report and what is its purpose? The Renewable Energy Directive states that a progress report should be issued every two years. The purpose of this progress report is to assess Member States' progress in the promotion and use of renewable energy in line with the 2020 targets. In addition, it contains sections on ...


    By Europa Press Room

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you