thermal waste treatment Articles

  • In-Situ thermal treatment of MGP waste and creosote

    Abstract: Remediation of coal tar at former Manufactured Gas Plant (MGP) sites, and creosote associated with wood preservative sites is challenging due to the viscous nature of the dense non-aqueous phase liquid (DNAPL) and the modest solubility and vapor pressure of the contaminants of concern (COCs). DNAPL seepage into surface water bodies, as well as groundwater plumes formed by the most ...


    By TerraTherm, Inc.

  • Treatment of waste thermal waters by ozonation and nanofiltraton

    After their use for heating, e.g. in greenhouses, waste thermal waters may cause environmental problems due to their high contents of ions, and in some cases organic matter (associated with an oxygen demand) or toxic compounds. The aims of this work were to decrease the high organic content of waste thermal water by a combination of ozone treatment and membrane separation, and to investigate the ...


    By IWA Publishing

  • Thermal Treatment Technologies

    Hot gas decontamination: Hot gas decontamination is a technology still in the pilot-scale of development that can be used for decontamination of explosives-contaminated masonry or metallic structures. The method involves sealing and insulating the structures, heating with hot gas stream to 260 °C (500 °F) for a prescribed period of time, volatilizing the explosive contaminants, and destroying ...

  • Determining Proper Cooling Tower Size

    To maximize water-based cooling tower benefits, the appropriate tower size must be selected, requiring the identification of several critical factors. Cooling towers are a relatively inexpensive and reliable way of expelling heat from a number of industrial processes, including nuclear & thermal power plants, petroleum refineries, petrochemical plants, food processing plants, as well as HVAC ...


    By Delta Cooling Towers, Inc

  • Thermal Treatment Of Halogenated Inorganic Aqueous Waste With Energy And By-Product Recovery

    This paper describes the incineration technology used to safely destroy the liquid and gaseous wastes containing inorganic salts generated by Bulk Pharmaceutical and agrochemical industries. The plants are supplied with dedicated downstream Air Pollution Control System (APC) or energy recovery where applicable. Due to the emergence of new products and increased production in Pharmaceutical and ...

  • Thermal hydrolysis of waste activated sludge at Hengelo Wastewater Treatment Plant, The Netherlands

    The thermal hydrolysis process (THP) is a sludge treatment technique which affects anaerobic biodegradability, viscosity and dewaterability of waste activated sludge (WAS). In 2011 a THP-pilot plant was operated, connected to laboratory-scale digesters, at the water board Regge en Dinkel and in cooperation with Cambi A.S. and MWH Global. Thermal hydrolysis of WAS resulted in a 62% greater ...


    By IWA Publishing

  • Thermal Desorption

    Untitled Document Introduction: ...

  • Efficient Waste Water Treatment

    Clean drinking water is an essential need of mankind. Often surface water like rivers or lakes is used as drinking water source. To prevent these resources from pollution the effective treatment of waste water is a must. For example in China 75% of discharged waste water is coming from pulp and paper, textile and dyeing industries. To run a waste water treatment plant in the most efficient way ...


    By J.V. Niebergall CDH

  • Regenerative thermal oxidizer - Wastewater treatment facility

    Epcon has extensive experience in designing and building Air Pollution Control Systems for the Wastewater Treatment Industry. The Problem The water treatment plant could no longer have open storage tanks to store industrial wastewater from the refineries in the area. They were emitting VOC's from their open storage tanks and were required to reduce their VOC emissions by ...


    By Epcon Industrial Systems, LP

  • Waste to energy – processing waste with a high thermal value to substitute combustibles

    With the taking effect of the TASi (Technical Regulations on Estate Waste) in 2005, non-treated waste must no longer be disposed of and deposited. Commercial and industrial residues with a high thermal value such as rejects from paper industry, punchings from rubber and plastics, and other mono-fractions which are characterized by homogeneity and constant combustible properties through mechanical ...


  • Staged Thermal Treatment Combined With Pyrometallurgical Smelting Producing Energy and Products From Waste

    Incineration of waste is considered as a state-of-the-art technology. However staged gasification in combination with pyrometallurgical smelting is ready for market introduction and offers principal advantages. These are higher efficiency (up to 35% electricity), efficient and cheaper fuel gas cleaning (less emissions), high quality secondary products (synthetic basalt), high input flexibility, ...


  • Maximising biogas in anaerobic digestion by using engine waste heat for thermal hydrolysis pre-treatment of sludge

    EXECUTIVE SUMMARY Dublin's Ringsend WWTP was designed to serve a population of approximately 1.2 million pe with a sludge production of 37,000 dry tonnes per year after upgrading to full secondary treatment. Several technical solutions were put forward as part of a Design, Build, Finance and Operate (DBFO) competition, with the chosen solution being a proposal by Black and Veatch for a ...


    By Cambi AS

  • Olive mill waste water treatment

    The production of olive oil generates two kind of waste waters: RINSING WATERS: the quantity is subject to change. It can be re-circulated, after the settling to remove the solids, or discharged directly. SLUDGE: vegetation water with additional water, whose quantity is subject to change. In case of traditional oil mills, the hot additional water flows to the inlet of the centrifuge. Part ...

  • Thermal hydrolysis pre-treatment for high solids anaerobic digestion

    The City and County of San Francisco completed a two-year pilot study of pre-treatment processes to mesophilic anaerobic digestion for improved biosolids stabilization and production of biosolids suitable for unrestricted reuse (class A biosolids). The results of this effort will help in the design of the new Solids Handling Facility (SHF) at the 11 m3/s Southeast Water Pollution Control Plant ...


    By Cambi AS

  • Integration of thermal hydrolysis into sludge treatment at cottonvalley WwTW, milton keynes

    The paper is a case study of the construction, commissioning and operation of a new 21,000 tonnes dry solids per annum sludge treatment centre at Anglian Water’s wastewater treatment works at Cottonvalley, Milton Keynes. The construction of the new sludge treatment centre was completed in summer 2008 and is part of Anglian Water’s £95 million AMP5 biosolids programme to provide treatment capacity ...


    By Cambi AS

  • Thermal Desorption - A Viable Solution

    Untitled Document As regulations continue to tighten, the need for expedient and accurate remediation technology is of great importance. When faced with the demand or need to reach ...


  • Chemical, Physical, Mineralogical, Morphology Characteristics of a Thermal Power Plant Washing Waste

    Most of electricity is generated by thermal power plants in Iran. Shahid Rajaee thermal power plant consists of four 250MW natural gas and fuel oil burning units that is located at 100 km west off Tehran. As a result of fuel oil burning in winter time, boilers air heaters are washed and cleaned frequently. The wastewater originating from air heater washing contains suspended ...


    By University of Tehran

  • Thermal hydrolysis as pretreatment of digestion feed

    AbstractA large number of different processes are today on the market for treatment of biodegradable waste. The two principal biological treatment methods available are aerobe treatment (composting) and anaerobe treatment (digestion/fermentation). In Norway so far, aerobe treatment has been the most popular solution. Both windrow composting and tunnel composting systems are in use. The first ...


    By Cambi AS

  • Centralised treatment of oil sludge and other industrial waste

    Centralised treatment of various sources of industrial waste has been established in many European countries over the last decade. Many facilities are still equipped with non state of the art technology and therefore cannot fulfil the broad field of applications with regard to industrial waste remediation. econ's international client decided to be one step ahead and erected a new econ industries ...


    By econ industries GmbH

  • Mechanical biological treatment for municipal solid waste

    A major portion of municipal solid waste (MSW) is dumped in unsanitary landfills in India. To protect the environment, there is an urgent need to develop a technology which could handle the increasing MSW quantities and enhance resource recovery. Mechanical biological treatment (MBT) is considered a potential method for dealing with heterogenous MSW. Proper mechanical sorting can make the ...


    By Inderscience Publishers

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you