TOC gas generator Articles

  • The Pitfalls of Process TOC analysis and how to avoid them case study

    Since the introduction of Total Organic Carbon (TOC) Analyzers by Dow, Union Carbide and Automated Environmental Systems in thel960,s,l-5\ they have proven to be an invaluable tool in the environmental and process monitoring fields. While technologies have advanced since then, certain performance characteristics required for true process control have been notably absent. The purpose of this paper ...


    By TOC Systems, Inc.

  • Application notes: The Sievers InnovOx TOC analyzer: boiler water monitoring

    Background A boiler system is a semi-closed loop system in which water is heated and converted into steam to power a generator. The steam is then allowed to form a condensate and the process is repeated. Boiler water chemistry directly impacts boiler efficiency and fuel use. Improper water treatment allows scale formation and corrosion. Boiler scale and deposits form when impurities ...


    By GE Analytical Instruments

  • Determination of TOC in stack through the innovative FID analyser easy to carry - Case Study

    PROBLEM: The industrial chimney's emissions of Volatile Organic Compounds (VOCs) are becoming issues of global importance and to have an accurate knowledge about how to test VOC turns into a strategic issue. VOC emissions are quantified and monitored according to standard EN 12619, using FID analyzer which uses hydrogen and other reference gases in ...

  • Fenton oxidation of gallic and p-coumaric acids in water assisted by an activated carbon cloth

    The objective of this study was to investigate the effect of the presence of an activated carbon cloth (ACC) during the degradation and removal of gallic acid (GA) and p-coumaric acid (pCA) by Fenton oxidation using H2O2 and FeSO4 as catalyst. Removal of GA or pCA by Fenton oxidation was much higher than that of total organic ...


    By IWA Publishing

  • Pulsed corona discharge for degradation of aqueous humic substances

    The research into oxidation of aqueous humic substances (HS) with pulsed corona discharge (PCD) was undertaken to estimate the energy efficiency of the treatment. The PCD system consists of a voltage pulse generator and reactor, in which the gas-phase discharge generating OH radicals and ozone treats the water showered between electrodes. The influence of HS initial concentration, pulse ...


    By IWA Publishing

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By ENVEA

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By ENVEA

  • Laboratory tests describing the biological reactivity of pretreated residual wastes

    In Austria as well as in Germany, several ideas have been put forward on how to describe the biological activity of waste. Gas-generation potential, respiration activity and analysis of material groups ('Stoffgruppenanalysen' according to Van Soest, 1963) and eluate parameters like TOC, NH4-N, COD and BOD were discussed. The use of the Incubation Test (developed by the Department of Waste ...


    By ORBIT e.V.

  • Catalytic ozonation of diclofenac with iron silicate-loaded pumice in aqueous solution

    The catalytic ozonation of diclofenac (DCF) with iron silicate-loaded pumice (FSO/PMC) in aqueous solution was investigated. FSO/PMC was synthesized by a co-precipitation–impregnation method and characterized using scanning electron microscope, N2 adsorption–desorption, X-ray fluorescence, and pHpzc measurements. Results showed that the FSO/PMC/O3 process obviously improved ...


    By IWA Publishing

  • What gas can i use for ftir?

    Fourier Transform Infrared (FTIR) - spectroscopy is used typically in testing laboratories for understanding materials and products. Fourier Transform Infrared (FTIR) - spectroscopy is used typically in testing laboratories for understanding materials and products, identifying chemical compounds in solids, liquids and gases, consumer products, paints, polymers, coatings, ...

  • A Layman`s Guide to Inorganic and Organic Contaminant Removal by Standard Filtration Methods

    Plant operators, maintenance engineers and mechanics, specifying engineers, installation technicians, and others involved in inorganic and organic contaminant removal are oftentimes called upon to choose and apply filtration solutions. To best make these decisions, it is helpful to review information and updated insight on basic filtration technologies, along with their advantages and ...


    By Shelco Filters

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By ENVEA

  • Shimadzu Application Chemist gets Protected - Case Study

    Senior Application Chemist at Shimadzu (Asia Pacific) PTE Ltd, Ting Zhi Wei Edwin, uses Peak Scientific gas generators to support his LC-MS instruments. Find out his experience with Peak's generators and how his lab has benefited from being [Peak Protected] ...

  • Ozone Based AOP process for refractory COD reduction in industrial waster water

    Introduction In recent years improvements  in ozone based advanced oxidation technology efficiencies have lowered capital and operating expenses, improving the viability of the use of ozone as the main oxidant. An investigation into alternatives for refractory COD removal which is economically attractive and do not produce sludge lead to an evaluation of ...


    By ESCO International (EI)

  • Utilizing UV, ozone & AOP technologies for municipal, industrial & waste water treatment

    ESCO International Solutions & Technologies provide a unique portfolio of technical expertise and equipment, specializing in Ozone, UV and Advanced Oxidation Processes (AOP) for water, gas effluent & Odour treatment. Adapting to strict user guidelines and customer focused design means ESCO International systems are reliable and delivers high water purification standards. As conventional ...


    By ESCO International (EI)

  • Soil Vapor Extraction (Ex Situ)

    Introduction: Ex situ soil vapor extraction (SVE) is a full-scale technology in which soil is excavated and placed over a network of aboveground piping to which a vacuum is applied to encourage volatilization of organics. Soil piles are generally covered with a geomembrane to prevent volatile emissions and to prevent the soil from becoming saturated by precipitation. The process includes a ...

  • Why was the name `i-FlowLab` chosen for our scalable nitrogen generator?

    ur i-FlowLab nitrogen generators provide a total laboratory soluition for on-site generation of nitrogen gas.  They deliver a continuous and consistent supply of high-purity nitrogen at the required pressure and flow rates to meet the full and varying demands of your laboratory or research facility, including Sample Evaporation, ICP, ELSD, CO2 Analyzers, FT-IR, TOC, GC and LC-MS. ...

  • Emissions analyser helps manage power station

    A multiparameter emissions monitor at Thetford power station is being used to demonstrate to the Environment Agency that the plant is performing within the conditions of its environmental permit. However, the data from the analyser, which was supplied by Milton Keynes based Quantitech, also performs a vitally important role in helping to manage the plant. “Individual gas readings are ...


    By Quantitech Ltd

  • FTIR emissions analyser helps manage UK power station

    A Gasmet FTIR multiparameter emissions monitor at Thetford power station is being used to demonstrate that the plant is performing within the conditions of its environmental permit. However, the data from the analyser, which was supplied by Gasmet’s UK distributor Quantitech, also performs a vitally important role in helping to manage the plant. “Individual gas readings are displayed ...


    By Quantitech Ltd

  • Amager Bakke / Copenhill Copenhagen, Denmark - Case study

    Copenhagen’s state of the art plant sets new standards for environmental performance, energy production and waste treatment. Innovative technology and architecture integrate to form a future in which waste-to-energy plants are welcomed in any backyard. In year 2017, Copenhageners and visitors will witness a  ...


    By Dürr Megtec LLC

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you