total suspended particulate Articles

  • EU emission inventory report 1990-2011 under the UNECE Convention on LRTAP

    This document is the annual European Union (EU) emission inventory report under the United Nations Economic Commission for Europe (UNECE) Convention on Long-range Transboundary Air Pollution (LRTAP) (UNECE, 1979). The report and its accompanying data are provided as an official submission to the Executive Secretary of UNECE by the European Commission on behalf of the EU as a party. The report is ...

  • European Union emission inventory report 1990–2012 under the UNECE Convention on Long-range Transboundary Air Pollution (LRTAP)

    This document is the annual European Union (EU) emission inventory report under the United Nations Economic Commission for Europe (UNECE) Convention on Long-range Transboundary Air Pollution (LRTAP) (UNECE, 1979). The report and its accompanying data constitute the official submission by the European Commission on behalf of the EU as a party, to the Executive Secretary of UNECE. The report is ...

  • Secondary Effluent Depth Filtration Medium Capacity

    ABSTRACTThe filter medium has a maximum accumulation capacity for the particulate material removed from the suspension that is being filtered. The maximum accumulation capacity (generally referred to as maximum specific deposit [MSD]) of the filter is basically an equilibrium condition, when the binding strength between the particles and the collecting medium (collecting medium can be the medium ...

  • BCP™ 2430 - Detergent Manufacturing Facility - Injection Mold Cooling System - Bio-organic & Corrosion Deposit Control - Case Study

    Problem – Plastic Bottle Mold Defects A bottle manufacturing plant in Utah was experiencing high reject rates due to poor injection mold cooling. This resulted in high plastic recycle costs and the need to extend mold change times for extensive cleaning of the molds’ cooling channels. Cause of Problem - Biofouling Poorly controlled microbial ...


    By AMSA, Inc.

  • Chlorine Disinfection of Blended Wastewater Effluents

     KeywordsBlended Wastewater, Disinfection IntroductionFlow to publicly owned treatment works (POTWs) increases during wet weather events, due to intrusion of storm water into sanitary collection systems and use of combined sewer systems. When such flows exceed the hydraulic capacity of a POTW alternate flow management techniques must be employed to ensure that ...

  • Expanding lead monitoring in support of EPA`s revised NAAQS

    On October 15, 2008, the U.S. Environmental Protection Agency (EPA) substantially strengthened the National Ambient Air Quality Standards (NAAQS) for lead. The revised standards are 10 times lower than the previous standards and will improve health protection for at-risk groups with a particular focus on children. In conjunction with this strengthening of the lead NAAQS, EPA changed the existing ...

  • Desalination pre‐treatment with LFNano

    EconoPure Water Systems EconoPure Water Systems designs and manufactures highly economical, scalable, low‐fouling. membrane systems. The Company leverages the proprietary low‐fouling nanofiltration. (“LFNano”) system consisting of a unique membrane element that is designed to avoid. particulate fouling, biofouling, and scaling. As the name suggests, the LFNano ...

  • Whittier in Frederick, Maryland - Storm Water Treatment Underground Systems Meet Regulatory Requirements

    The Assisted Living Project at Whittier in Frederick, M.D. is a 6.3 acre retirement community situated next to Whittier Lake. Planned by Fox & Associates, it included special design considerations for a cost-effective and attractive means of treating stormwater. To detail the Whittier site, it is comprised of a retirement assisted living facility which is 19,151 sq. ft., a retirement medical ...


    By BaySaver Technologies, Inc.

  • Differentiation of Mass and Flow Limited Rainfall-Runoff Events for Overland Flow from Small Urban Catchments

    ABSTRACTWater quantity and quality are coupled phenomena in urban rainfall-runoff. These rainfall-runoff quantity and quality relationships have been significantly altered by the built environment and associated anthropogenic activities. Understanding the relationship between quantity and quality of urban overland flow for a given catchment facilitates development of in-situ wet weather control. ...

  • Iron and Steel Manufacturing Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Shifting Paradigms of Environmental Management

    Introduction In the past few decades there has been an all around awareness of environmental degradation caused by industrial activities on account of green house gas emissions, stratospheric ozone depletion, acid rain and acidification, eutrophication, soil degradation, technological hazards, chemical mists and fog with potential damage to human race. Environmental considerations therefore ...

  • Focus on Microfiltration Part 3: Extending Service Life Using Prefiltration

    Last month we examined filter selection strategies for maximizing service life in continuous use applications.  In this 3rd installment, we will examine the use of prefilters to extend service life. Clarifying liquids with high levels of suspended solids is challenging, especially for applications requiring submicron filtration.  In these applications, filter users who experience ...


    By Sterlitech Corporation

  • Urban Air Quality Management

    ' Poor air quality due to pollution is a serious environmental problem in most urban areas. The greatest burden of pollution is on human health. Urban air quality management requires an integrated approach that (i) identifies the most serious problems and measures that offer cost-effective and feasible solutions across a range of economic sectors and pollution sources including industries, ...


    By The World Bank

  • Pesticides Manufacturing Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • 7 Common Pitfalls When You Choose a Chemical Coagulation Water Treatment System To Treat Your Water

    Pretreatment processes in water treatment systems are often crucial to maintaining efficiency and longevity of the downstream equipment, such as membrane filtration. Many systems incorporate a coagulation step that will encourage small suspended solids to aggregate and fall out of solution. By eliminating the larger particles in the solution, filtration membranes won’t foul, tear or clog as ...

  • Case study: fish processing plant wastewater treatment

    Abstract This presentation describes the full scale installation of a wastewater treatment system at the Ocean Gold Seafood ("OCS") plant in Westport, Washington, USA. Local Government requires that fish processors remove total suspended solids (TSS), fats, oil and grease (FOGs) and colloidal materials almost completely in order to allow for efficient disinfection. The OCS plant had only ...


    By Clean Water Technology, Inc.

  • Inclined Plate Settlers to Treat Stormwater Solids

    ABSTRACTIt has been well-documented that, in stormwater runoff, many of the problem pollutants are associated with the particulate fraction. Past characterization of urban runoff and source contributions has shown the following: (a) soil disturbance increased the TSS and turbidity in the runoff; and (b) correlations were observed between TSS and particulate runoff concentrations of chromium, ...

  • Pulp and Paper Mills Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Data Requirements for Soil, Sediment, and Sludge

    Site soil conditions frequently limit the selection of a treatment process. Process-limiting characteristics such as pH or moisture content may sometimes be adjusted. In other cases, a treatment technology may be eliminated based upon the soil classification (e.g., particle-size distribution) or other soil characteristics. Soils are inherently variable in their physical and chemical ...

  • Dust monitoring

    Generally, two different approaches are used to measure the amount of dust deposited on a surface; Determination of the soiling of a surface, by a change in its properties; Determination of the quantity of dust deposited, by weight. WHAT IS DUST? Dust is a generic term used to describe fine particles that are suspended in the atmosphere. Dust comes from a wide variety of sources, including soil, ...


    By Queensland Laboratory

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you