toxicity monitoring equipment Articles

  • Toxic and Hazardous Materials in Electronics

    Untitled Document Introduction In October 2000 Environment Canada released a report called Information Technology (IT) and Telecommunications (Telecom) ...

  • Evaluation of an automated luminescent bacteria assay for in situ aquatic toxicity determination

    A new system for monitoring toxicity TOXcontrol® (MicroLAN BV, The Netherlands) has been used to assess the toxicity of a selection of priority or emergent compounds in the laboratory. In this study, inhibition curves and EC50 – Effective Concentration causing 50% inhibition – of selected compounds (including pesticides, pharmaceuticals, surfactants and metals commonly detected in ...

  • Warehouse Optimization: Balancing Equipment Performance and Worker Safety Through Emissions Measurements and Air Quality Monitoring

    Successful warehouse functionality is dependent on both maximizing equipment performance and providing a safe and healthy environment for workers that encourages productivity. However, these two factors are often at odds with each other as warehouse equipment such as forklifts, burnishers and delivery trucks emit toxic gases that can have the potential to create poor indoor air quality which ...

  • Toxicity Identification Evaluation (TIE) as a Tool for Water Quality Management

    Whole effluent toxicity (WET) testing has evolved into a critical element of many National Pollutant Discharge Elimination System (NPDES) permits issued to both industrial and municipal dischargers. Over 6,500 dischargers to both fresh and salt waters are required to conduct toxicity tests to determine if their effluent might be potentially toxic to organisms in the receiving system. While ...


    By AECOM

  • Asbestos monitoring – what monitor should I be using?

    Asbestos is the name given to a group of minerals that occur naturally as masses of strong, flexible fibres that can be separated into thin threads and woven. These fibres are not affected by heat and do not conduct electricity. Asbestos is chemically, relatively stable. For these reasons, asbestos has been widely used in many industries.  These four types are classified as follows:  ...


    By Shawcity Limited

  • Monitoring Phenol in Water

    The Situation A plant located in the eastern United States manufactures phenolic resin for applications in plastics molding. This plant uses well water for cooling its reaction process and then discharges the water into a local creek. A leak in the reactor and associated cooling equipment would cause phenol and phenolic compounds to contaminate the cooling water. Such a leak could ...

  • Oxygen Monitors for the New Millennium

    Oxygen monitors have become a required piece of safety equipment for many industrial and laboratory environments, where the release of certain toxics can create an area unsafe for living beings (human or animal).  When making a purchasing decision on any oxygen detection monitor, one need look no further than the sensor cell found at the heart of the monitor.  While each oxygen ...

  • How Accurate is Your Monitor?

    When you consider the many regulations and guidelines that health and safety officers and first responders are faced with, it is amazing they maintain the ability to detect such a wide variety of hazardous pollutants and toxic agents.  There is no lack of regulations governing how to monitor chemical compounds, and the list grows longer all the time.  New standards for portable gas ...

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • Intraurban variability of Ambient PM Arsenic and other air toxics metals case study

    The Missouri Department of Natural Resources (MoDNR) and Washington University participated in a project to collect and analyze air toxics metals data. It was funded through a Community Air Toxics Grant from the U.S. Environmental Protection Agency (USEPA). The study grew out of the southside St. Louis Community Air Project (CAP) which identified six hazardous air pollutants of concern including ...


    By Cooper Environmental

  • A Method of Assessing Air Toxics Concentrations in Urban Areas Using Mobile Platform Measurements

    ABSTRACTThe objective of this paper is to demonstrate an approach to characterize the spatial variability in ambient air concentrations using mobile platform measurements. This approach may be useful for air toxics assessments in Environmental Justice applications, epidemiological studies, and environmental health risk assessments. In this study, we developed and applied a method to characterize ...

  • Wireless monitoring for a safe indoor environment

    This article discusses the benefits of wireless technology for continously monitoring the indoor environment. In striving for the construction of energy efficient and cost-effective buildings, the imperative issue of the buildings Indoor Air Quality (IAQ) is often overlooked. This can often lead to a unhealthy indoor environment and even to conditions such as Sick Building Syndrome (SBS) or other ...


    By PPM Technology

  • FRACKING: Freeing Energy Resources versus Polluting the Earth and Public Health with Radiation and Toxic Chemicals?

    Fracking demands the use of millions of gallons of water, precious drinking water, and sand infused with up to 1,000 different toxic chemicals to fracture the shale rock and release the trapped gas or oil. The wastewater, brine, and sludge are then returned to the surface and in need of disposal. Unfortunately there is not yet a clear and safe method of disposal or storage. Among these chemicals ...


    By Technical Associates

  • EPA mercury rules: Keeping the lights on while removing toxics from our air

    Next week the U.S. Environmental Protection Agency is expected to finalize new rules to reduce mercury and other toxic air emissions that will affect dozens of antiquated power plants currently operating without pollution controls. These rules have stirred debate in some circles as to whether retrofitting or retiring outdated plants will cause shortfalls in electricity capacity. How will new EPA ...

  • Monitoring Multiple Gas Hazards in Ice Arenas

    The equipment used in an arena such as an ice re-surfacer, ice edger, floor sweepers, lift trucks and other special equipment are more often powered by fuel than electricity. The exhaust produced by the gas, propane or diesel fuel powered machines emits, into the air, carbon monoxide (CO), nitrogen dioxide (NO2) and particulates. Ammonia (NH3) is commonly used in the ice chiller mechanical room ...

  • Monitoring heavy metals for compliance with RoHS and WEEE directives

    The rapid expansion in the quantity of used electronic and electrical appliances has created a need to safely dispose of the used equipment. The European Community has introduced regulations to enforce limits on the amount of toxic metals and organic chemicals used in the production of material. Compliance with the regulations will help prevent hazards for future generations when the equipment is ...


  • Neosens™ on-line Fouling monitoring for Cooling Towers

    A New Approach to Fouling Control Neosens offers innovative, cost effective sensor solutions for monitoring the presence of biofilm and scale in cooling towers, heat exchangers and other industrial process applications. Fouling in cooling systems is a worldwide, multi-billion dollar problem, reducing energy efficiency, increasing maintenance costs and creating health risks due to ...


  • Designing and Implementing Perimeter Air Monitoring Programs

    Perimeter or fenceline ambient air quality and meteorological monitoring programs have become increasingly valuable at hazardous waste, landfill, dredging, ports, and MGP remediation sites. Air quality monitoring programs protect public health and reduce owner liability ...


    By AECOM

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you