toxicity monitoring system Articles

  • Whole Effluent Toxicity Testing

    What is Whole Effluent Toxicity (WET) testing? Whole Effluent Toxicity (WET) testing is an important component of the U.S. Environmental Protection Agency’s (USEPA’s) integrated approach for detecting and addressing toxicity in surface waters. The National Pollutant Discharge  Elimination System (NPDES) permit program, authorized by the Clean Water Act, controls water pollution by ...

  • Toxic and Hazardous Materials in Electronics

    Untitled Document Introduction In October 2000 Environment Canada released a report called Information Technology (IT) and Telecommunications (Telecom) ...

  • Toxic algae successfully monitored, controlled at drink water reservoir in the UK

    Within the water industry, combating algae is known as a hazardous chemical process. However the chemical free approach and solution of LG Sound is confirmed to be environmental friendly by Sembcorp Bournemouth Water (SBW). As a result of the experienced problems in the lakes of SBW, the MPC Buoy was installed to improve the water ...


    By LG Sonic

  • Indigenous people fight toxics in Arctic

    The fourth meeting of the United Nations Environment Programme’s Conference of the Parties of the Stockholm Convention on Persistent Organic Pollutants opened today in Geneva, Switzerland to discuss restricting and phasing out the world’s most dangerous chemicals. Representatives from Indigenous communities of the Arctic greeted the delegates with drumming and traditional songs to remind them of ...

  • A Comparison of Point Sensors and Open Path Monitors For Toxic Gas (esp. HF) Monitoring

    Point Sensors Ion Mobility Spectroscope (IMS) – a gas sample is ionized by a radioactive source (Ni63). Differences in ion drift under the influence of an applied electric field produce a spectrum that is dependent on the mass, charge, and shape of the component ions. The detector signal and strength is tuned to the drift time of the ion of interest (in this case HF) and signal strength is ...


    By Boreal Laser Inc.

  • Development of a groundwater fungal strain as a tool for toxicity assessment

    Despite the significant ecological role in groundwater the value of fungi as indicators of groundwater pollution is not known, as fungi are notoriously challenging to assess for toxicity because of their varied morphological components, in particular their filamentous structures. Hence they remain rarely used in environmental risk assessments and monitoring programs for aquatic systems. We ...


    By John Wiley & Sons, Ltd.

  • Bioswales reduce contaminants associated with toxicity in urban stormwater

    Contamination and toxicity associated with urban stormwater runoff are a growing concern because of the potential for receiving system impacts. California water regulators are mandating implementation of green infrastructure as part of new urban development projects to treat stormwater and increase infiltration. Parking lot bioswales are low impact development practices that promote filtering ...


    By John Wiley & Sons, Ltd.

  • Monitoring the aquatic toxicity of mosquito vector control spray pesticides to freshwater receiving waters

    Pesticides are applied to state and local waterways in California to control insects such as mosquitoes, which are known to serve as a vector for West Nile Virus infection of humans. The California State Water Resources Control Board adopted a National Pollutant Discharge Elimination System General Permit to address the discharge of pesticides to waters of the United States resulting from ...


    By John Wiley & Sons, Ltd.

  • Regionally Based Assessment of Persistent Toxic Substances

    Untitled Document EXECUTIVE SUMMARY In 1997 the United Nations Environment Programme (UNEP) Governing Council decided that immediate international action ...


  • Modern water`s toxicity monitor used for river clean-up research case study

    Modern Water pic (AIM:MWG), the owner of leading water technologies for the production of fresh water and monitoring of water quality, has collaborated with the Unwersity of Central Florida (UCF) to supply a Microtox® M500 toxicity monitor. The monitor will assist with research into acVanced treatment techniques which could provide a solution to the removal of Total Phosphorus from the Middle ...

  • Fixed multi-parameter gas detection system can ensure industrial facilities are safe from hazardous or toxic gases

    Industrial workplaces are likely to come across one or more hazardous or toxic gases. Combustible gases such as methane are highly dangerous because they can cause large and fatal explosions when ignited. Other problem areas when working in industry are carbon monoxide (which poisons the cardiovascular system), oxygen deficiency, and elevated levels of other gases and pollutants, depending and ...


    By PPM Technology

  • Online Instrumentation to Protect Wastewater Facilities from Toxic Chemicals

    ABSTRACTSecurity concerns are driving current research to develop means of detecting toxic chemicals in wastewater influents as few online instruments are currently available for this purpose. Online respirometers such as the STIPTox are the obvious choice using existing, established technology. One of these units was recently used successfully in the WERF project 03-CTS-7S “Feasibility Testing ...

  • Effect of increasing bromide concentration on toxicity in treated drinking water

    Research is increasingly indicating the potential chronic health effects of brominated disinfection by-products (DBPs). This is likely to increase with elevated bromide concentrations resulting from the impacts of climate change, projected to include extended periods of drought and the sudden onset of water quality changes. This will demand more rigorous monitoring throughout distribution ...


    By IWA Publishing

  • Canarina DISPER Software · air toxics dispersion model · algorithms 7

      Canarina DISPER Software · air toxics dispersion model   9.1.2 Downwind and Crosswind Distances  The model uses a Cartesian receptor network. All receptor points are converted to Cartesian (X,Y) coordinates ...

  • PureAire Universal Gas Detector Offers Protection Against Toxic Levels of Ammonia

    In March of 2016, an ammonia gas leak at a seafood processing plant in Boston left one worker dead. The fumes at the plant were so powerful that firefighters could not promptly enter the scene to mitigate the gas leak and try to save the staff member until much later. Reports show that 5,300 pounds of ammonia gas leaked out of the plant. If you work with ammonia at your facility, learn ...

  • Controlling level of toxic liquids for the foam industry case study

    Solid provides a durable solution for level controlling of toxic liquids, using the SmartScan 50L ultrasonic measurement gauge. Polymers Ashkelon Industries located in the city of Ashkelon, is a major supplier of foam for the furniture and mattresses industry in Israel. The company has a long-standing reputation in manufacturing of foam in various shapes and sizes for mattresses, furniture and ...

  • Toxicity Identification Evaluation (TIE) as a Tool for Water Quality Management

    Whole effluent toxicity (WET) testing has evolved into a critical element of many National Pollutant Discharge Elimination System (NPDES) permits issued to both industrial and municipal dischargers. Over 6,500 dischargers to both fresh and salt waters are required to conduct toxicity tests to determine if their effluent might be potentially toxic to organisms in the receiving system. While ...


    By AECOM

  • Biological monitoring system, iTOXcontrol, continues in Scarlino - Case Study

    The recorded death of fish in the river that flows out of the industrial zone of Scarlino has created the need of the installation of a biological alarm system. The decision was made to work with an automatic system, iTOXcontrol created by microLAN-The Netherlands represented in Italy by Ecotox Lds, which uses marine bacteria. The system compares the values of the light emission from these ...


    By microLAN B.V.

  • Oxygen Monitors for the New Millennium

    Oxygen monitors have become a required piece of safety equipment for many industrial and laboratory environments, where the release of certain toxics can create an area unsafe for living beings (human or animal).  When making a purchasing decision on any oxygen detection monitor, one need look no further than the sensor cell found at the heart of the monitor.  While each oxygen ...

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you