turbidity sensor Articles

  • Turbidity Warning System

    Morgan Est Contractors for National Grid Supply and installation of telemetred groundwater monitoring network, May 2006 ongoing Hydro-Logic recently completed the supply and installation of borehole instrumentation and a telemetry monitoring system to monitor groundwater conditions in 28 observation wells located at 19 sites in the vicinity of Croydon. The ...

  • Dynamic soft sensors for detecting factors affecting turbidity in drinking water

    Effective monitoring of water quality is critical for water safety. In particular, online monitoring based on modeling is useful in several applications such as process assessment, hazardous event detection or common fault diagnostics in the water processes. Soft sensors have lately established themselves as a good alternative for different tasks of process control such as the acquisition of ...


    By IWA Publishing

  • Exclusive: Introducing the new TurbiTechw2 D-ISO turbidity sensor

    We have some exciting news and you are the very first to read about it! This 2nd – 3rd November at the WWEM Show in Telford we will be launching the latest sensor in ...


    By Partech (Electronics) Ltd.

  • Comparing Optical Turbidity With LISST-ABS

    For measuring suspended sediments, the use of optical backscatter sensors or other turdibity sensors is widespread. At the same time, it is understood that these sensors respond to total particle area, not volume or mass. In other words, optical turbidity sensors have this property: their sensitivity decreases with increasing grain size. The decrease follows 1/diameter. This has been published ...


    By Sequoia Scientific, Inc.

  • How & When We Measure Turbidity

    Turbidity, along with Suspended Solids, is a way of measuring the clarity of a body of water, and how many particles are affecting it. The difference is that while Suspended Solids describes the density of the materials in the water, Turbidity describes how those materials affect light passing ...


    By Partech (Electronics) Ltd.

  • Technical Focus: Turbidity as Control for Primary Settlement

    Turbidity is a very useful tool when regarding control within the primary settlement stage of water treatment. By utilising turbidity as a control variable during this stage of the process you  can enable a more rapid response to variations in load  and provide early warning  to operators of equipment malfunction before it’s too late; allowing for immediate action to be taken ...


    By Partech (Electronics) Ltd.

  • Turbidity Measurements in Drinking Water, Effluent Discharges and Coagulant Controlling

    This month at Partech Water Instruments we’re talking about our turbidity sensors—fantastic to use as an environmental indicator. So how can they be used? We’re here to tell you about turbidity sensors being utilised for drinking water, effluent discharges and coagulant controlling. Turbidity Sensors and Drinking Water Turbidity sensors ...


    By Partech (Electronics) Ltd.

  • Partech Water Instruments Case Study: Landfill Turbidity and Dosing Control - Case Study

    Set in one of Devon’s most beautiful river valleys Deep Moor is a haven for aquatic wildlife and therefore the site needs to be careful not to have any detrimental effects on the environment. Partech have been working closely with Greenacre Pumps of Newton Abbot in order to provide an extremely reliable and cost-effective dosing system. The best things about Partech’s Turbidity and ...


    By Partech (Electronics) Ltd.

  • Case Study: Liz Bagshaw on the IRC sensors

    Our infrared IR’C sensors have been making waves in the world of glacial meltwater monitoring. Glacial environments are key indicators of global warming and climate change. They’re also home to a diverse range of microorganisms. Both of these need to be quantified and monitored, but doing this isn’t easy because of the cold, remote environments in which they are found. To combat ...


    By Partech (Electronics) Ltd.

  • Partech Water Instruments Case Study: China’s Success with Partech’s Clever Sensors!

    Ronghuai Water Group uses Partech water instruments in 20 of their water plants across China! Currently, the Watertechw2 pH8000 and TurbiTechw2 LA sensors are used in the plants. The ...


    By Partech (Electronics) Ltd.

  • Accuracy of different sensors for the estimation of pollutant concentrations (total suspended solids, total and dissolved chemical oxygen demand) in wastewater and stormwater

    Many field investigations have used continuous sensors (turbidimeters and/or ultraviolet (UV)-visible spectrophotometers) to estimate with a short time step pollutant concentrations in sewer systems. Few, if any, publications compare the performance of various sensors for the same set of samples. Different surrogate sensors (turbidity sensors, UV-visible spectrophotometer, pH meter, conductivity ...


    By IWA Publishing

  • Analytical Technology Helps Britannia Food Ingredients Ensure Safe Wastewater Disposal

    Britannia Food Ingredients Ltd. is a speciality fats company for the chocolate, confectionery, biscuit and snack food industries. The company are specialists in providing the demanding fat formulations found within chocolate, ice cream, bakery and snack food products. Located at Goole, East Riding of Yorkshire, England, the business was formed in 1996 and produces a range of oils and fats ...

  • Final effluent monitors protect wastewater treatment efficiency

    Southern Water operates 370 wastewater treatment plants (WWTP), many of which are unmanned for most of the time and most have numeric environmental permits, so a network of online monitors has been established to improve treatment and protect discharge compliance. This has involved the installation of final effluent monitors at over 300 sites in a programme that has lasted for more than ten ...


  • DT82E Environmental Data Logger Monitors Catchment Areas

    Water disruptions occur after a large amount of water is rapidly collected in a catchment area. Testing for a variety of chemical and biological agents as well as clarity, rate of movement and water levels are continuously monitored for environmental management. The dataTaker DT82E Environmental data logger can be used to monitor turbidity, conductivity, temperature, pH, level and flow sensors. ...


    By CAS DATALOGGERS

  • From mess to mass: a methodology for calculating storm event pollutant loads with their uncertainties, from continuous raw data time series

    With the increasing implementation of continuous monitoring of both discharge and water quality in sewer systems, large data bases are now available. In order to manage large amounts of data and calculate various variables and indicators of interest it is necessary to apply automated methods for data processing. This paper deals with the processing of short time step turbidity time series to ...


    By IWA Publishing

  • How & Why We Measure Suspended Solids

    In case you weren’t sure, Suspended Solids is simply a density measurement used to describe exactly how much waste sludge and particles are in the water, and is measured in milligrams per litre (mg/l), grams per litre (g/l) or percentage solid (%). 1000mg/l = 1g/l = 0.1%. It is used to calculate the amount of material, or load, in a wastewater or industrial system. Suspended Solids ...


    By Partech (Electronics) Ltd.

  • On-line measurements provide more accurate estimates of nutrient loading: a case of the Yläneenjoki river basin, southwest Finland

    Automatic on-line measurement stations for water quality components and water level were equipped with dataloggers and GSM transmitters; the stations were installed at two sites in the Yläneenjoki river basin, SW Finland. Measurements during five seasons in 2006–2007 were conducted to find out whether the produced data would provide more accurate estimates of material and nutrient transport than ...


    By IWA Publishing

  • In-situ quality monitoring station in Lower Saxony

    Background 'Duemmer' is a shallow lake in the south-west of Lower Saxony; through the lake flows the river 'Hunte'. The catchment area spans 426 km2. With a surface of 12.4 km2 and an average depth of 1.1 m there is a water volume of approx. 14 million m3. Large parts of the lakeside are a nature reserve and the lake is a popular local recreation area. The lake suffers from strong nutrient ...

  • Chlorine mystery solved

    Following the installation of in-pipe drinking water quality monitoring sondes, distribution engineers discovered an occasional significant disparity between the Intellisondes’ data and results from grab samples tested by a photometer tablet (DPD) method. For most of the time, there was close agreement between the two methods, but periodically, the photometer results varied wildly, whilst ...


    By Intellitect Water Ltd

  • Radar measurement in the North Sea

    Background / Task The NLWKN operates the barrier in the inland waterway of the river Ems. They are working with a dense monitoringnetwork which is required e.g. for the preservation of evidence in case of blocks for the protection against storm tides or if the water depth has to be increased to make the Ems navigable for big vessels coming from the dockyard. After an average a new radar ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you