uv-based flame detector Articles

  • Two Detector Solution to Analyzing Sulfur

    Sulfur compounds are reactive, corrosive to pipes, and destructive to catalysts in petroleum refineries. Sulfur emission are strictly regulated globally. When released into the atmosphere sulfur dioxide converts to sulfuric acid resulting in adverse effects on human health and the environment. Sulfur detection is found useful in many other industries; therefore, detection of sulfur compounds in ...


    By Restek Corporation

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • Real Time TOC Analysis in Steam and Condensate

    Executive Summary Steam in petro/chemical plants could be contaminated with hydrocarbons (TOC = Total Organic Carbons) from various sources. In any case this is a sign for defects in the process, whether it they occur in the heat exchanger, the blow down vessel, the condensate recovery or other parts of the system. Conventional solutions to monitor such contaminations use TOC- ...


    By JCT Analysentechnik GmbH

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Ethanol rail car facilities case study

    Due to the advanced true flame detection technology employed within the FDS range of flame detectors, they are capable of detecting ethanol fires. At Ethanol Rail Car terminals across the mid west of the United States we have a large install base of Micropack FDS301 Visual Flame Detectors. With the detectors ability to record any fires it detects, as well as the ability to remotely view the live ...

  • BP Schiehallion FPSO case study

    The Schiehallion Vessel is a Purpose Built FPSO (Floating Production, Storage and Offloading system). The Schiehallion FPSO was specially designed to withstand the harsh climates of areas like the Atlantic Margin. Extreme conditions have been encountered over the past few years of operating experience, which have contributed to improving the knowledge and procedures for operating safely. ...

  • BP BTC Pipeline case study

    Spanning three countries from the Caspian Sea to the Mediterranean coast. At a length of 1,768km, the Baku Tbilisi Ceyhan (BTC) Pipeline is one of the great engineering endeavours of the new millennium. The BTC oil export pipeline transports crude oil from offshore oil fields in the Caspian Sea to the Turkish coast of the Mediterranean from where the crude is further shipped via tankers to ...

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

  • The Portable FID for Stack Emissions: lightweight, compact, ergonomic, safe

    POLLUTION S.r.l. manufactures POLARIS FID analyser, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • BP Sangachal terminal case study

    One of the world’s largest integrated oil and gas processing terminals. Located 55km south of Baku, the Sangachal Terminal is a vital link in Azerbaijan’s oil and gas industry. An oil and gas terminal that receives, processes, stores and exports crude oil and gas produced from the Azerbaijan's offshore oilfields in the Caspian Sea. Treated crude oil and gas at the terminal ...

  • The determination of major and minor elements in air filters and urine for hazard assessment, using a new CCD DUAL-VIEWED ICP optical emission spectrometer

    This article describes the application of a new type of CCD-based, dualviewed ICP optical emission spectrometer for the analyses of industrial hygiene types of samples. Several trace elements in air filter media are determined by ICP-OES. Urinary electrolytes and trace elements are determined in a single dilution automatically in both the axial and radial plasma viewing orientations. Results of ...


    By PerkinElmer, Inc.

  • TVOC measurement for LEED/green building evaluation

    Total Volatile Organic Compounds (TVOC) may be evaluated when building designers/managers are pursuing the Leadership in Energy and Environmental Design Green Building Rating System for New Construction (LEED-NC) EQ Credit 3.2. The latest LEED-NC guidance document specifies that the maximum allowed concentration of TVOC measured in a building (post construction, pre-occupancy) is 500 µg/m3; the ...


  • Improving Safety by Conforming to Industry Standards and Certifications

    Abstract Globally, safety standards play a key role in designing and executing gas and flameame detection projects. How can these standards, which might seem cumbersome at times, help users make informed decisions? What information can be used to assist in conforming to standards and maximizing safety? This paper will analyze standards from an end-user view, will consider ...

  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By MOCON, Inc. - Baseline

  • Case study - How to properly maintain and service your oxidizer

    Your air pollution control system represents a significant investment in not only initial capital but also ongoing maintenance and operation. Routine inspections performed by your staff combined with thorough maintenance plans provided by Anguil Environmental Service Technicians will ensure you get the most from your investment over the entire life of the system. Anguil has almost three decades ...

  • 5th-Generation Thermox WDG Flue Gas Combustion Analyzer

    "For more than 40 years, we have been a leader in combustion gas analysis," says Mike Fuller, divison VP of sales and marketing and business development for Ametek Process Instruments, "and we believe the WDG-V is the combustion analyzer of the future." WDG analyzers are based on a zirconium oxide cell that provides a reliable and cost-effective solution for measuring excess oxygen in flue gas as ...

  • Identifying Leaks from Natural Gas Pipelines at a Safe Distance

    The use of natural gas, of which methane is the principle component, is increasing worldwide. According to the American Petroleum Institute methane meets 24% of U.S. energy demand and heats over 50% of all U.S. households. It also has many industrial uses, such as the manufacture of chemicals like ammonia, methanol, butane, ethane, propane and acetic acid; it is also an ingredient in products as ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you