water analyzer Articles

  • Detect Leaks and Analyze Water Consumption with WaterSignal

    Did you know it will cost an estimated $1 trillion over the next 25 years to upgrade the nation’s water system to run more efficiently? While part of the problem is fragile, hundred-year-old water mains, it also falls on property owners to ensure they are doing their part to save water — for both the environment and their wallets. But how? ...


    By WaterSignal

  • New Process Gas Analyzer for the Measurement of Water Vapor

    KEYWORDS TDLAS, WMS, Laser Spectroscopy, Water Vapor Measurement, Gas Analyzer ABSTRACT A new analyzer for the measurement of water vapor concentration based on Tunable Diode Laser Absorption Spectroscopy (TDLAS) was developed. The water-vapor line at 1854-nm was selected for the measurement, and the performance of the system was evaluated on different ...


    By AMETEK Process Instruments

  • Analyzing the potential of community water systems: the case of AguaClara

    Successful maintenance of water provision has as much to do with the ongoing governance of these systems as the technology that goes into building them. This governance generally occurs at the community level. Most water systems are small and located in areas where there is generally not the profitability necessary to entice private investment. Understanding how community management can improve ...


    By IWA Publishing

  • TOC analyzer for airports

    During winter, de-icing processes at airports necessitate storm water and de-icing water management. Especially due to adhesive (sticky) substances, strongly fluctuating concentrations and a lot of chemicals, the monitoring systems itself must be tailor-made to fight this water analysis challenge. LAR 's ...


    By LAR Process Analysers AG

  • Validation of Salt Water Disposal Well Treatment Plants with Handheld Oil in Water Sample Analyzer

    Salt Water Disposal (SWD) well operators often dispose a substantial volume of oil inadvertently when injecting salt water, thereby losing the opportunity to sell the oil on the market and potentially reducing the ability to inject water in the well. Injection facilities are typically operated with minimal instrumentation or system optimization, which means the operators don't know how much, or ...

  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By AMETEK MOCON - Baseline

  • Validation of salt water disposal well treatment plants with handheld oil in water sample analyzer

    Salt Water Disposal (SWD) well operators often dispose a substantial volume of oil inadvertently when injecting salt water, thereby losing the opportunity to sell the oil on the market and potentially reducing the ability to inject water in the well. Injection facilities are typically operated with minimal instrumentation or system optimization, which means the operators don't know how much, or ...

  • Analyze Trace Amounts of Solvents in Water Using Packed Column GC

    Glass or stainless steel columns containing 80/120 Carbopack B/3% SP-1500 packing can be used to analyze water-based samples for ppm to low percentage levels of many organic compounds. This bulletin describes minimum detection limits and maximum capacity of these columns, adsorption and memory effects, and other factors that affect component quantitation. Problems are defined that might arise ...


    By MilliporeSigma

  • Application notes: The Sievers InnovOx TOC analyzer: boiler water monitoring

    Background A boiler system is a semi-closed loop system in which water is heated and converted into steam to power a generator. The steam is then allowed to form a condensate and the process is repeated. Boiler water chemistry directly impacts boiler efficiency and fuel use. Improper water treatment allows scale formation and corrosion. Boiler scale and deposits form when impurities ...


    By GE Analytical Instruments

  • Oil in frac water testing

    The amount of water used in and produced by hydraulic fracturing of shale gas wells is in the millions of gallons per well. Whether the water is going to be taken off site for disposal or reused for re-injection, the flowback or produced water needs pretreatment to remove any residual oil from the wa-ter. Waiting for remote laboratory results can take several days to a week. The InfraCal TOG/TPH ...


    By Spectro Scientific

  • Assessing performance of on-line nitrate analyzers

    Traditionally, activated sludge processes were designed to remove organics and suspended solids from wastewater. The justification for including nitrogen control in wastewater treatment facilities began with the need to protect receiving waters from the increasing problem of eutrophication and hypoxia (low levels of dissolved oxygen in bottom waters, generally less than 2 mg/l). One of the ...

  • Phosphorus control protects surface waters

    Phosphorus is the decisive factor for excessive algae and plant growth in water bodies, that’s why quality standards require reductions in the amount of phosphorus released from wastewater treatment plants into rivers and lakes. In recent years, the outlet limit values have not only been reduced on national levels. Depending on the vulnerability of ecosystems, especially low target values ...


    By Endress Hauser AG

  • Comply with Highly Regulated Oil in Water Measurements Using Portable Infrared Analyzers

    The Petroleum Industry – both offshore and onshore -- has regulations that limit the amount of oil in discharged water.  Fixed filter infrared (IR) analyzers have been used to test oil levels in produced water on drilling platforms for over 45 years for a number of reasons. On oil rigs where real estate is at a premium, infrared analyzers such as the Wilks InfraCal TOG/TPH ...


    By Spectro Scientific

  • PeCOD® Analyzer oxygen demand analysis for source & treated drinking waters

    MANTECH’s chemical oxygen demand (COD) analyzer is breaking new ground in the science of monitoring source and treated drinking water. In addition to providing 15-minute COD results and biochemical oxygen demand (BOD) estimates, MANTECH’s PeCOD® Analyzer measures natural organic matter (NOM) in raw and treated drinking water. The NOM Analyzer™  — which is the ...


    By MANTECH Inc.

  • Global Monthly Water Scarcity: Blue Water Footprints versus Blue Water Availability

    Freshwater scarcity is a growing concern, placing considerable importance on the accuracy of indicators used to characterize and map water scarcity worldwide. We improve upon past efforts by using estimates of blue water footprints (consumptive use of ground- and surface water flows) rather than water withdrawals, accounting for the flows needed to sustain critical ecological functions and by ...


    By IWA Publishing

  • Well Water Treatment Systems

    Well Water Treatment Systems | Industrial & Commercial Well water treatment systems are used to purify water and eliminate impurities from all types of well water (dug wells - driven wells - drilled wells). To have the right and the most efficient well water treatment system, you need to correctly analyze the well water chemistry and to have a fundamental understanding of how ...


    By Pure Aqua, Inc.

  • Reducing the Detection Limits for a Process Moisture Analyzer

    KEYWORDS Moisture Analyzer, Piezoelectric Sensor, Smart Transmitter, Internal Verification, Quartz-Crystal Microbalance ABSTRACT Piezoelectric moisture analyzers have been used in the process industry for over two decades. While this is an older technology for measuring moisture in gas phase samples, it is still one of the most reliable in ...


    By AMETEK Process Instruments

  • Testing the Waters

    Last summer’s wave of tropical storms left the East Coast scrambling to ensure drinking water quality. Water Quality Products editorial intern Raissa Rocha spoke with Marc Hamel of testing equipment manufacturer Horizon Technology Inc. to discuss the impact weather events may have on water quality. Raissa Rocha: What is your experience with ...


    By Horizon Technology, Inc.

  • Topological clustering as a tool for planning water quality monitoring in water distribution networks

    Topological clustering was explored as a tool for water supply utilities in preparation of monitoring and contamination contingency plans. A complex water distribution network model of Copenhagen, Denmark, was simplified by topological clustering into recognizable water movement patterns to: (1) identify steady clusters for a part of the network where an actual contamination has occurred; (2) ...


    By IWA Publishing

  • Monitoring Phenol in Water - Case Study

    The Situation A plant located in the eastern United States manufactures phenolic resin for applications in plastics molding. This plant uses well water for cooling its reaction process and then discharges the water into a local creek. A leak in the reactor and associated cooling equipment would cause phenol and phenolic compounds to contaminate the cooling water. Such a leak could ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you