well bore survey Articles

  • New advances in planning a bore

    Software helps take out the guesswork Horizontal directional drilling (HDD) is challenging and difficult work fraught with unknown obstacles. While it’s not possible to eliminate every obstacle, bore planning software tools developed by drill manufacturers can help small and large contractors create a bore plan that may help minimize risks. Bore planning software was ...


    By Vermeer

  • Case Study - Construction Aggregate: Sand

    Geologic Mapping of Sand Unit Thickness Pyramid was contracted to perform an electrical resistivity survey across 230 acres of undeveloped land in North Carolina. The purpose of the survey was to quantify the lateral extents and approximate depth/thicknesses of sandy soils near the ground surface. The client was interested in the potential of the site to be utilized as a sand mine, and ...


    By Advanced Geosciences, Inc.

  • Scanning proposed borehole locations for Utilities case study

    Environmental and engineering firms often are tasked with performing soil borings for monitor well installation as part of a Phase II Environmental Site Assessment. This task becomes more challenging when the borings are to be installed in gasoline stations, right of ways or other areas where there are numerous underground utilities that are either unmarked or not properly located. GeoView can ...


    By GeoView, Inc.

  • Hydrogeologic Investigation of VOC Contamination in Bedrock Using Mass Flux Analysis – A Case History

    Courtesy of US EPA and NGWA proceedings of the 2004 U.S. EPA/NGWA Fractured Rock Conference: State of the Science and Measuring Success in Remediation, September 13-15, 2004, Portland, Maine AbstractA fractured bedrock system was investigated using a combination of hydrogeologic methods to minimize the number and depth of bedrock wells installed during the investigation. These ...


    By Arcadis

  • Dynamics of nitrate & perchlorate in groundwater.

    The Apache Powder Superfund Site is located in Cochise County, Arizona, approximately 50 miles southeast of Tucson. The site was listed on the National Priorities List pursuant to CERCLA in 1990. Principal groundwater chemicals of concern (COCs) include nitrate-nitrogen (nitrate-N) and perchlorate. Concentrations of nitrate-N exceeding 500 mg/l and 2,300 mg/l have been detected in the “shallow ...


    By Hargis + Associates Inc

  • A New Perspective: a new way to overcome iron bacteria problems has come to America

    Published in the April edition of the Waterwell Journal, this article looks at the problems caused by iron bacteria and iron oxide in wells and boreholes and how Boresaver, a specialist range of cleaning treatments, can solve those problems. Mineral scale and bacterial slime contamination are becoming an increasing problem in groundwater bores in America. Iron bacteria and iron oxide deposits are ...


    By Geoquip Water Solutions

  • Triad use at Naval Base San Diego saves an estimated 6 years and US$3m for site investigation

    The U.S. Naval Facilities Engineering Command Southwest (NAVFAC SW) used the Triad approach to collect an integrated hydrogeologic and chemical dataset for expediting and optimizing characterization of a volatile organic compound (VOC) plume at Naval Base San Diego (NBSD), CA. The 295-acre 'IR Site 22' was identified in 2003 when VOC concentrations reaching 100 mg/L were reported in an upgradient ...

  • New monitoring technology helps reveal Arctic secrets

    A group of Arctic researchers has employed the latest monitoring technology to investigate the effects of climate change, by measuring temperature and salinity in the water column beneath surface ice. The results of the investigation, which utilised YSI’s new 'Castaway-CTD', could cast new light on our understanding of the ways in which shifting ocean currents impact upon the climate in ...

  • Enhanced Aerobic Bioremediation of Petroleum UST Releases in Puerto Rico.

    Abstract: Releases of petroleum compounds from underground storage tanks (USTs) containing diesel fuel and gasoline are a serious and increasingly prevalent problem in Puerto Rico. Remediation of groundwater impacted by these releases utilizing common methodologies can be quite costly and require long periods of time to implement. Oxygen is often the limiting factor retarding optimal ...


    By REGENESIS

  • Engineering Geology

    This is a collection of various cases where the 2D resistivity imaging method pioneered by Advanced Geosciences Inc have been successfully applied. Click on a section below and you will be shown a full 2D resistivity imaging brochure detailing the ...


    By Advanced Geosciences, Inc.

  • Ground Penetrating Radar Evaluation of Concrete Tunnel Linings

    Abstract - Ground penetrating radar was used to map tunnel lining condition and locate concrete deterioration and voids in a continuous and non destructive manner. GPR surveying of Kapoor Water Supply Tunnel, Victoria, Canada was carried out with a 1000 MHz Sensors and Software Ltd., Conquest system mounted on a custom built cart. This 8.8 km long 2.3 m diameter concrete lined circular tunnel was ...


    By SewerVUE

  • Former Dry Cleaning Site Contaminated with PCE - Case Study

    In-Situ® Inc. TROLL® 9500 Multiparameter Sonde helps resolve treatment challenges and saves $200,000 in drilling, reagents, and consulting. A former dry-cleaning site in the Pacific Northwest, Ultra Custom Care Cleaners, was found to be contaminated with PCE (perchloroethylene). According to the U.S. Geological Survey (USGS), PCE was widely used in the dry cleaning of fabrics since the ...


    By In-Situ, Inc.

  • Bioventing systems at Alaska air force base achieve cleanup closures

    The U.S. Air Force and Alaska Department of Environmental Conservation (ADEC) collaborated in installing and operating seven full-scale bioventing systems over the last 10 years to address hydrocarbon and VOC contamination at the King Salmon Airport (KSA) in Alaska. Five of the systems achieved cleanup closure within five years of operation, and another is currently under closure review. The ...

  • Integrated local water supply plan

    Client: City of Wichita, Kan. Completion Date: June 2001  Services Provided Water supply planning Evaluation of alternatives Cost estimating Economic comparison Environmental studies (NEPA) Program management Hydrogeologic engineering Water quality monitoring ...


    By Burns & McDonnell

  • Achieving

    Introduction The leak repair requirements, under Title VI Section 608 of the Clean Air Act Amendments of 1990, require that when an owner or operator of an appliance that normally contains a refrigerant charge of more than 50 pounds discovers that refrigerant is leaking at a rate that would exceed the applicable trigger rate during a 12-month period, the owner or operator must take corrective ...


  • Low-Flow (Minimal Drawdown) Ground-Water Sampling Procedures

    Untitled Document Background The Regional Superfund Ground Water Forum is a group of ground-water ...


    By Solinst Canada Ltd.

  • Utilizing unconventional water sources for industrial reuse

    Reclamation and reuse of unconventional wastewater sources for plant raw water, cooling water and process pre-treatment has increased substantially due to increases in the cost of drinking water, recurring water shortages that can impact business operations, and tightening government regulation. Water is required in almost every industrial sector for the processing and manufacture of products. ...


    By WesTech Engineering, Inc.

  • Enhancing Your Role as a Standards Professional - Part 1: The Elevator Speech

    You know your participation in standards development is critical to your company, but does your company recognize this? Do you have the support and resources you need? Here’s how to develop a quick summary of what you do and what you need that top-level executives will hear and understand. For years, standards professionals and organizations have extolled the benefits of standards and the ...


    By ASTM International

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you