well inspection Articles

  • The Phase 1 Environmental Assessment

    In today’s world where every property is subject to potential environmental risks a Phase 1 Environmental Site Assessment or ESA is an appropriate action to take. An ESA can help determine if the property has been contaminated by previous or current activities. The ESA can help protect the purchaser of a property from environmental risks prior to the closing on a property.  Lenders ...

  • Case study - Wall leakage testing in the lab with acoustic camera

    Problem Facade insulation testing is usually performed by using a loudspeaker in the sending room, and record the sound pressure level (SPL) with microphones in both the sending and receiving room. The difference in SPL adjusted for the size of the dividing wall element will then give an estimate of the sound reduction quality of that element. However these measurements will not say ...


    By Norsonic AS

  • How a contract research lab advanced its polymer characterization capabilities

    Realizing the Advantages of Ultra-High-Performance Size Exclusion Chromatography Compared to GPC Intertek is a global provider of quality and safety services designed to help businesses improve products, assets and processes, overcome market constraints and reduce risks. From auditing and inspection, to testing, training, and certification, Intertek enables customers to meet end ...


    By Waters Corporation

  • Oil Sampling Best Practices (Part 2)

    Understanding Dynamic Particle Equilibrium in Closed Loop Systems Dynamic Equilibrium Condition (DEC) is defined as a steady state condition where the normal wear rate in a machine results in no net gain or loss of particles. ...


    By Spectro Scientific

  • ALBANISA Oil Spill Equipment Setup - Case Study

    As a part of the Bolivarian Alliance for the People of Our America (acronym in Spanish: ALBA), Nicaragua has received funds to build a new oil hub in the Caribbean. The hub will be available for oil companies in order to store their products before reaching its final destination. By doing that the profit will be increased as the costs for transportion is reduced. The updated environmental ...


    By DESMI A/S

  • 10 Reasons why you should continuously monitor low temperature and liquid chemical sterilants for worker safety

    1. Sterilant chemicals are highly toxic Low temperature and liquid chemical sterilants are designed to kill all microorganisms including resistant spores and if they were not toxic, they would not be effective in sufficiently high concentration to destroy all microbial life including the chemically resistant sporicidal forms of certain ...


    By ChemDAQ, Inc.

  • Biosolids ban struck down

    In 1994, Los Angeles County Sanitation Districts (LACSD) bought a 4,700-acre farm (called Green Acres Farm) in southwest Kern County for the purpose of land applying biosolids from its 11 wastewater treatment plants. LACSD land applied 800 wet tons/day at this site for several years. In 2006, Kern County voters passed Measure E on the ballot with 83 percent approval. This measure banned ...


    By BioCycle Magazine

  • Gavin Russell, Sales Engineer at TOMRA Sorting Recycling, is sharing key considerations on managing MRF upgrades

    Gavin Russell, Sales Engineer at TOMRA Sorting Recycling, analyses the rising volume of MRF upgrades, considers the rationale driving such decisions, and shares some ideas on how to manage a successful upgrade. Material quality issues Whilst material quality is a primary factor in any evaluation of an MRF’s performance, this can be influenced by a range of ...


    By TOMRA Sorting (TITECH)

  • Element Inspection Criteria for Couplings

    Baldor-Dodge Raptor’s easy to assemble, patent-pending split rubber element significantly decreases total cost of ownership and extends driven equipment life. Designed for drop-in interchangeability, the Raptor offers easy installation and reduced maintenance in an innovative design. When it is time to inspect or maintenance the coupling, it is important to know what to look for so elements ...


    By Modern Pumping Today

  • A well-developed blind spot

    A shipping container arrives at a port and is immediately sequestered for inspection. The product that it purportedly contains is legal for import, but two decades of unfortunate experience have taught the customs and environmentalauthorities that the foreign shipment possibly contains materials hazardous to human health. In the case of the newly-arrived container, the authorities open it and ...


    By Recycling International

  • Think health as well as safety

    Lee Calver of Workplace Law writes about how the HSE is making sure that the construction industry ‘thinks health’ as well as safety’. Not many weeks pass without the Health and Safety Executive (HSE) releasing new research or detailing ...


    By Altius Vendor Assessment Ltd

  • REACH: How to prepare for the inspection?

    Inspections REACH: what are they? With the publication of Decree Sanctions (Legislative Decree no. 133/2009, published in the Official Gazette of 24/09/2009 ) which provides for the application of penalties in cases of non-compliance with the provisions of the REACH Regulation, began an intense program monitoring and verification by the ...


    By Selerant srl

  • Drones for Wind Turbine Inspection

    Unmanned Aerial Vehicles and Inspection Services for Wind Turbines: Global Market Assessment and Forecasts By the beginning of 2015, there were nearly 270,000 individual wind turbines operating globally. The more than 800,000 blades spinning on these turbines are battered by the elements over time and gradually wear out. Deterioration can cause reduced energy ...

  • How To Survive An OSHA Inspection

    Untitled Document While there's little upside to facing an Occupational Safety and Health Administration (OSHA) inspection, it is possible to ...


    By 3E Company

  • Not Had Your Inspection Yet? Be Prepared!

    The CQC Notification We had our CQC inspection this week and if it hadn’t have been for the fact that we were notified of the visit the day before we were to move to a new clinical computer system (SystmOne) we might not have felt quite so anxious about our impending visit! Whilst everything we do is in preparation for an inspection there’s nothing like a deadline to ...

  • Aircraft Engine Remote Visual Inspection

    An aircraft MRO center was in need of an easy to use borescope for use in a wide variety of applications on both turbine and piston powered aircraft. The VJ-Advance (VJ-ADV) from RF System Lab was selected because of its unique combination of features and very competitive price. Using the VJ-ADV, technicians are now able to conduct engine and airframe inspections quickly and easily, documenting ...


    By RF System Lab.

  • Growth and Evolution of a Municipal Pool Safety and Inspection Program

    The city of Plano Health Department swimming pool safety and inspection program has been growing and evolving since 1992. Currently, five environmental health specialists inspect 370 permitted commercial swimming pools. The environmental health specialists, who are all well trained and are Certified Pool Operators by the National Swimming Pool Foundation, inspect each facility twice during the ...

  • Hazardous Material and Asbestos Inspection Case Study

    Global has been contracted by the Genesee County Land Bank Authority (GCLBA) to complete pre-demolition hazardous material and asbestos inspections on blighted structures located in the City of Flint beginning in 2002 and continuing through the present. In March and November 2013, Global was awarded multiple contracts from GCLBA, which utilize MBEG and HHF funding sources to eliminate blight and ...

  • It’s Time to Prepare for an OSHA PSM Inspection

    Companies who are required to comply with OSHA’s Process Safety Management standard (1910:119) should be on high alert now that inspectors are being encouraged to complete more time-consuming, complex investigations. The reason? OSHA’s new enforcement weighting ...


    By Intelex Technologies Inc.

  • Inspection of Internal Structure of Walls by Subsurface Radar

    ABSTRACT This paper deals with the application of ultra-wide band time-domain subsurface radars, equipped with special signal processing techniques, to realize non-invasive image testing of the building walls' internal structure that are made with brick, stone, concrete, reinforced concrete and other construction materials. There are two normally associated problems, qualitative and ...


    By Transient Technologies LLC

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you