well monitoring Articles

  • Area monitoring of specific ppb-level constituents utilizing process gas chromatography

    ABSTRACT In most of the industrialized countries worldwide, increasingly stringent environmental regulations require the continuous reduction of a wide range of emission sources and components. Despite local variations concerning concentrations, absolute emission quantity, target priorities and timetables, regulations typically require active compliance and proof thereof. The impact of ...

  • Illinois Utilities Begin to Design Community Solar Programs Under New Energy Law

    Illinois utilities and regulators are putting into motion plans for community solar programs under the state’s Future Energy Jobs Act that passed last year. In filings with the Illinois Commerce Commission (ICC) last month, ComEd outlined proposed terms and conditions for “Community Supply,” also referred to as community solar. Ameren Illinois has also ...


    By Cleantech Law Partners

  • Taking advantage of production waste - Case Study

    Recycling areas: Various scrap Company name: KME (Serravalle Copper Tubes) Located: Serravalle Scrivia (Alessandria), Italy Founded: 1886 Employees: 5700 KME is a leading global fabricator of copper and copper alloy semi-finished products. Each year 405.000 tons of copper and copper alloy semi-finished products (excluding copper wire) are produced. ...


    By Eldan Recycling A/S

  • Abandoning Monitoring Wells: Safety Issues

    Monitoring wells are typically constructed to gauge the extent of contamination, assess water quality and conduct other hydrogeologic studies. Depending on its objective, the monitoring well may remain in use or may be abandoned permanently. When declared inactive, the well is many a times left as it is. Open unused wells are hazardous to life and environment: • Contamination may spread from one ...

  • Implications of observed and simulated ambient flow in monitoring wells

    The authors of this paper present compelling evidence that conventional monitoring wells act as vertical conduits whenever vertical hydraulic gradients are present (i.e., at most sites). Vertical flow within wells due to natural hydraulic gradients not only makes it impossible to accurately define the vertical distribution of dissolved contaminants within the aquifer, but it can transport ...


    By Solinst Canada Ltd.

  • Locate buried monitoring wells case study

    A Phase II Environmental Site Investigation was being conducted at a gasoline station in Fort Myers, Florida. In order to minimize costs, our client intended to use several existing on-site monitoring wells rather than installing new wells. However, five of the existing wells had been covered with asphalt and were no longer visible. GeoView was tasked with performing a shallow geophysical study ...


    By GeoView, Inc.

  • Optimal groundwater contamination monitoring using pumping wells

    This study presents a new method for selecting monitoring wells for optimal evaluation of groundwater quality. The basic approach of this work is motivated by difficulties in interpolating groundwater quality from information collected for only few sampled wells. The well selection relies on other existing data relevant to contaminant distribution in the sampling domain, e.g. predictions of ...


    By IWA Publishing

  • Case study - Well monitoring for a water supplier

    The municipality company, in city of Luebek, Germany, provides potable water for approximately 120,000 households, all pumped from more than 30 wells.  These wells have water levels as deep as 160 meters.  The water levels of these groundwater wells must be measured with the highest possible accuracy.  Previously, the pressure probe's analogue output signals (4…20mA) that ...


    By The OTT Hydromet Group

  • Advances in Multilevel Well Technology

    Several detailed field studies performed at research sites in the 1980’s and 1990’s suggest that most contaminant plumes exhibit large variations in concentration over small vertical distances. These variations are caused by spatial variations in the contaminant source zones and heterogeneity of the geologic materials. Conventional monitoring wells have been shown to be ineffective for accurately ...


    By Solinst Canada Ltd.

  • Well water win-win

    Solve two problems with one filter? That’s what Drinkwell aims to do. Begun through a collaboration between researchers at Lehigh University and the Bengal Engineering and Science University, the Boston-based social venture ...


    By Ensia

  • Use of geostatistics to evaluate the monitoring well network of a TCE plume

    This paper summarises the use of geostatistics to evaluate an existing network of wells in a groundwater monitoring program. The primary objective was to evaluate whether selective well removal would result in a comparable characterisation of a trichloroethylene (TCE) plume. For adequate characterisation, it is important to retain enough wells to evaluate areas with higher concentrations and to ...


    By Inderscience Publishers

  • Evaluation of the snap sampler for sampling ground water monitoring wells for VOCs and explosives

    A series of laboratory and field studies were conducted to determine the ability of the Snap Sampler to recover representative concentrations of VOC and explosives in ground water. For the laboratory studies, statistical analyses of the data (for each analyte) were conducted to determine if the concentrations of analytes in samples taken with the Snap Sampler were significantly different from ...


    By ProHydro, Inc.

  • A method for reducing purge volumes in deep monitoring wells: a purging experiment.

    Regulatory agencies often require three well casing volumes or more be purged prior to collection of groundwater samples for chemical analysis. Costs are high for testing and disposing of potentially hazardous purge water; therefore, efforts must be made to minimize waste-water volume while obtaining representative groundwater samples. Lockheed sponsored a purge experiment on two deep monitor ...


    By Hargis + Associates Inc

  • Plume distortion and apparent attenuation due to concentration averaging in monitoring wells

    This paper, authored by University of Connecticut researchers who performed much of the early work on this topic, describe the various processes that bias groundwater samples collected from conventional monitoring wells. In particular, they discuss the dilution of contaminants that occurs when clean water is simultaneously drawn into monitoring wells pumped to produce groundwater ...


    By Solinst Canada Ltd.

  • San Juan Island well production and tank level monitoring case study

    San Juan Island is a popular resort destination whose population fluctuates with the season and the arrival of Orca whales and salmon runs. To get to the island, you must first drive an hour north of Seattle to the city of Anacortes. From there you take a two-hour ferry ride through a 130 island group to arrive at the 20 mile San Juan Island, which is at the waterway entrance to Puget Sound. Bob ...


    By Mission Communications, LLC

  • Extraction well design for DNAPL recovery.

    The potential for downward migration of dense nonaqueous phase liquid (DNAPL) into deeper portions of a saturated hydrogeologic unit has important implications for successful groundwater remediation. Little information has been published regarding the design of extraction wells that allow DNAPL recovery without simultaneously creating a conduit for cross contamination by vertical migration ...


    By Hargis + Associates Inc

  • Latin America well-positioned for CDM

    The coastal desert of Colombia’s La Guajira state is a world away from Kyoto, the temperate Japanese city where representatives of 159 countries in 1997 signed the Kyoto Protocol on reducing greenhouses gases. The Caribbean laps against rickety settlements. Herds of goats range across scorching sands. Months, whole years, pass without rain. But Kyoto is well known to the inhabitants of La ...


  • How well does my filter work?

    Contamination control is the key to a cost-effective maintenance operation for hydraulic or engine systems. You depend on your filters, whether hydraulic, lube or fuel, to keep your fluids clean, to keep maintenance costs down, and to ensure reliable operation. At some point, you probably will ask yourself whether or not your filters are really working and doing what they were designed to do. ...

  • Tidal influences on unconfined water levels in wells.

    Tidal effects have the potential to measurably affect water level measurements and the estimation of groundwater flow direction and gradient. This has significant implications for the prediction and monitoring of contaminant plumes in coastal areas. Studies were conducted at two near-coastal sites in San Diego County, California, to evaluate the impact of tidal variability on the interpretation ...


    By Hargis + Associates Inc

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you