well monitoring equipment Articles

  • Learn How to Better Balance Equipment Performance and Worker Safety with Our Latest Application Note

    Do you want to ensure the safety and health of the workers at your warehouse and maximize the performance of the equipment they use? Here at E Instruments, we know that having a successful, and fully-functioning warehouse is dependent on whether or not the equipment is being maximized, and if the workers are working in a healthy environment that encourages productivity. However, we also know all ...

  • 10 Reasons why you should continuously monitor low temperature and liquid chemical sterilants for worker safety

    1. Sterilant chemicals are highly toxic Low temperature and liquid chemical sterilants are designed to kill all microorganisms including resistant spores and if they were not toxic, they would not be effective in sufficiently high concentration to destroy all microbial life including the chemically resistant sporicidal forms of certain ...


    By ChemDAQ, Inc.

  • Oil Sampling Best Practices

    Obtaining a representative oil sample from a closed loop lubrication system is essential to any good oil analysis program. As oil analysis programs become more standardized for routine monitoring, especially within equipment warranty support programs, equipment makers provide more sampling points on new equipment. These ...


    By Spectro Scientific

  • Technical and safety practices

    Safety is absolutely paramount in the medical industry, with lives literally at stake if something were o go wrong. Regrettably, this was more than reinforced recently following the tragic news of a death of a newborn at a hospital in Sydney, Australia, after it was mistakenly administered nitrous oxide (N2O) instead of oxygen (O2) in July this ...


    By Geotech

  • E-Z Trays an Integral Part of Levelland`s Groundwater Treatment - Case Study

    QED E-Z Tray® Air Strippers an Integral Part of Levelland's Groundwater Treatment System The refinery at the former Motor Fuels Corporation produced all grades of gasoline, tractor fuels, diesel, distillate products, and fuel oils. It closed in 1954 after 15 years of operation, and the refinery equipment was removed by 1958. The property has since been redeveloped, but the ...


    By QED Environmental Systems

  • Oil Sampling Best Practices (Part 2)

    Understanding Dynamic Particle Equilibrium in Closed Loop Systems Dynamic Equilibrium Condition (DEC) is defined as a steady state condition where the normal wear rate in a machine results in no net gain or loss of particles. ...


    By Spectro Scientific

  • Case study - Well monitoring for a water supplier

    The municipality company, in city of Luebek, Germany, provides potable water for approximately 120,000 households, all pumped from more than 30 wells.  These wells have water levels as deep as 160 meters.  The water levels of these groundwater wells must be measured with the highest possible accuracy.  Previously, the pressure probe's analogue output signals (4…20mA) that ...

  • San Juan Island well production and tank level monitoring case study

    San Juan Island is a popular resort destination whose population fluctuates with the season and the arrival of Orca whales and salmon runs. To get to the island, you must first drive an hour north of Seattle to the city of Anacortes. From there you take a two-hour ferry ride through a 130 island group to arrive at the 20 mile San Juan Island, which is at the waterway entrance to Puget Sound. Bob ...


    By Mission Communications, LLC

  • IAEA safeguards equipment

    The International Atomic Energy Agency (IAEA) operates a large diversity of equipment to verify nuclear materials, contributing to the confirmation of the states' compliance with their respective nonproliferation obligations. The variety of physical and chemical properties of nuclear materials, as well as their storage environment, requires an arsenal of instruments. Additionally, the IAEA ...


    By Inderscience Publishers

  • Fuel alternatives for heavy equipment

    High fuel prices are leading composters and wood grinders to reevaluate diesel-guzzling heavy equipment, looking to alternatives that are both more cost-efficient and environmentally friendly. This could be as “simple” as filling up existing machines with biodiesel blends, could involve swapping out a diesel model for an electric one, or even go as far as generating electricity on site to power ...


    By BioCycle Magazine

  • Nonaqueous Phase Liquids Compatibility with Materials Used in Well Construction, Sampling, and Remediation

    The EPA Regional Ground Water Forum is a group of EPA professionals representing Regional Superfund and Resource Conservation and Recovery Act Offices (RCRA), committed to the identification and resolution of ground-water issues impacting the remediation of Superfund and RCRA sites. The Forum is supported by and advises the Superfund Technical Support Project. The compatibility of remediation, ...


    By QED Environmental Systems

  • Asbestos monitoring – what monitor should I be using?

    Asbestos is the name given to a group of minerals that occur naturally as masses of strong, flexible fibres that can be separated into thin threads and woven. These fibres are not affected by heat and do not conduct electricity. Asbestos is chemically, relatively stable. For these reasons, asbestos has been widely used in many industries.  These four types are classified as follows:  ...


    By Shawcity Limited

  • Planning For Fenceline Monitoring

    The development of a general framework for fence-line monitoring can go a long way toward getting a plan quickly implemented, with less stress and potentially large cost-savings. Automation can greatly reduce operational costs of the fence-line monitoring as well as reducing data loss due to equipment problems. No facilty expects to do fence-line monitoring, therefore they seldom plan for it, but ...


    By American Ecotech LLC

  • The future is condition monitoring

    It’s been a big month here at Hansford Sensors. We kicked off November by celebrating our 10thanniversary, during which time we were playfully predicting what our company may look like in another decade. While our thoughts on this are strictly hypothetical at this stage, thanks to the release of a new report we now have a better idea of the state of the condition monitoring ...


    By Hansford Sensors

  • Monitoring Phenol in Water

    The Situation A plant located in the eastern United States manufactures phenolic resin for applications in plastics molding. This plant uses well water for cooling its reaction process and then discharges the water into a local creek. A leak in the reactor and associated cooling equipment would cause phenol and phenolic compounds to contaminate the cooling water. Such a leak could ...

  • GW monitoring in saxony

    Background During the hundred-year flood in 2002 in Eastern Germany the river “Elbe“ and a lot of rivers in the catchment area exceeded the banks and caused damages of millions within a short period of time. Often unnoticed, the groundwater level was rising extremely after a certain time. The time of rising groundwater took considerably longer than the actual flood, and caused enormous ...

  • Plant area monitoring at Krško

    Post-Fukushima upgrades at Krško in Slovenia (www.nek.si) are being implemented in accordance with the requirements of the national regulator and the plant owners. The first phase, including a passive containment vent filtering system and hydrogen recombiners, a new emergency diesel generator, and a protected store of mobile emergency equipment, is already completed. The next phase in ...


    By Saphymo

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you