wet waste Articles

  • Determining Proper Cooling Tower Size

    To maximize water-based cooling tower benefits, the appropriate tower size must be selected, requiring the identification of several critical factors. Cooling towers are a relatively inexpensive and reliable way of expelling heat from a number of industrial processes, including nuclear & thermal power plants, petroleum refineries, petrochemical plants, food processing plants, as well as HVAC ...


    By Delta Cooling Towers, Inc

  • 100 Simple Ways To Save Water

    To improve water conservation install a rain sensor, it turns off your irrigation when it rains. Use a weather-based controller. The use of smart controllers can reduce water usage 24% a year on average. Learn about available rebate programs ...


    By Jain Irrigation, Inc

  • Electrochemical decomposition of fluorinated wetting agents in plating industry waste water

    Electrochemical decomposition of fluorinated surfactants (PFAS, perfluorinated alkyl substances) used in the plating industry was analyzed and the decomposition process parameters optimized at the laboratory scale and production scale of a 500-liter reactor using lead electrodes. The method and system was successfully demonstrated under production conditions to treat PFAS) with up to 99% ...


    By IWA Publishing

  • Development of wet pre-treatment and pulper technology

    Since 1984 BTA is involved in activities in the area of waste pre-treatment. This process was first implemented in 1986 in a pilot plant. The patented BTA-Process is consisting of the following main steps: - Wet pre-treatment of waste with separation of the contaminants and production of a pumpable suspension- Sand separation by a hydrodynamic grit removal system- Digestion of the suspension in ...


    By ORBIT e.V.

  • Wet electrostatic precipitators: A preferred technology for emission control

    The basic science behind electrostatic precipitators is as familiar and as simple as static cling. But today, this elemental force has been harnessed to a technology that is helping to remove millions of tons of toxic chemicals from our atmosphere; saving billions of dollars annually in pollution-related physical damage; and averting costly impacts on health and mortality rates for millions of ...


    By Beltran Technologies, Inc.

  • Dry/Wet Scrubbers for Clean Air Compliance

    Air-scrubbing venturis and towers may be the answer to clean air compliance for small- to medium-sized companies. Forthcoming requirements of the Clean Air Act Amendments of 1990 will inventory many more specific chemicals considered hazardous. From acetaldehyde to xylenes, the list regulated under the air taxies program includes 189 hazardous air pollutants (HAPs). That number may ...


    By CR Clean Air Group, LLC

  • In-situ estimation of the methane generation rate for a wet and highly organic solid waste landfill

    Significant investments in landfill gas utilisation projects are required at project commencement. The methane generation rate for the Villa Dominico Landfill in Buenos Aires, Argentina is 0.26 yr−1, a very high rate as a result of the high organic content in the waste, and high moisture conditions within the refuse. The implications for landfills is that ...


    By Inderscience Publishers

  • Exergy analysis of the process of wet-process phosphoric acid production with full utilisation of sulphur contained in the waste phosphogypsum

    The wet-process phosphoric acid is produced by decomposition of phosphate raw materials with sulphuric acid. This gives a large amount of waste product-phosphogypsum. The thermochemical decomposition of phosphogypsum gives a gas rich in SO2. This gas is processed to obtain sulphuric acid, which is fed back into phosphoric acid production. The aim of this paper is to perform exergy analysis of the ...


    By Inderscience Publishers

  • Taylor made washing lines for wet recycling of conterminated plastics

    NEUE HERBOLD Maschinen- und Anlagenbau GmbH, located in Sinsheim/Germany manufactures and sells complete washing lines for the recycling of plastics waste. Prior to re-pelletizing the plastic waste must be size reduced, washed and if necessary foreign materials separated. NEUE HERBOLD washing lines, produce granules or flakes with a high quality even at today's ...

  • Tailor-made washing lines for wet recycling of conterminated plastics

    NEUE HERBOLD Maschinen- und Anlagenbau GmbH, located in Sinsheim/Germany manufactures and sells complete washing lines for the recycling of plastics waste. Prior to re-pelletizing the plastic waste must be size reduced, washed and if necessary foreign materials separated. ...

  • Contaminant removal from dry and wet sands by thermal desorption

    Infrared heating was used to determine the effects of temperature and moisture on the removal of selected organic compounds from contaminated sand matrices. Quartz sand was used as a chemically inert surrogate for soil to isolate the heat transfer and mass transfer effects without any chemical contribution from soil. The selected organic contaminants were 3-nitrobenzene sulphonic acid, sodium ...


    By Inderscience Publishers

  • Pollution Systems VS-3 wet srubber removes grease and particulate

    A leader in the Food Industry has several Pork Sausage Cookers at their manufacturing site in Alabama.  Each cooker exhausts over 4,000 ACFM.  The streams are saturated with moisture and the pollutant load is pork grease.  Electrostatic Precipitators (ESP’s) have been installed to treat the exhaust.  However, the ESP's were not working well and have high maintenance and ...


    By Pollution Systems

  • Waste Disposal

    Introduction The final step in the waste management process is waste disposal, the permanent isolation of waste. Some wastes can be managed and disposed safely with existing facilities and proven methods. Other Department of Energy (DOE) wastes require more complex disposal facilities. DOE has conducted extensive research into alternative waste disposal methods and has concluded that deep ...

  • Waste not in Asheville

    Asheville, North Carolina, has gained a national reputation as a hub of local and artisanal foods. In fact, the local foods movement in this Southern Appalachian city has become so embedded in the community consciousness that the city has dubbed itself “the world’s first Foodtopian Society.” There are hundreds of unique restaurants, dozens of bakeries, breweries and ...


    By BioCycle Magazine

  • Leak tightness testing system for nuclear fuel assemblies in wet conditions of interim spent fuel storage

    The Slovak wet Interim Spent Fuel Storage Facility in the Jaslovske Bohunice nuclear power plant was built and put in operation in 1986. Since 1999, leak tests of VVER-440 fuel assemblies have been provided by the special leak tightness detection system 'Sipping in Pool' delivered by the Framatome-anp facility, with external heating for the precise detection of active specimens. Although this ...


    By Inderscience Publishers

  • Tri-NOx Multi-Chem Wet Scrubber. Case Study of Our NOx Scrubber in a Hydroprocessing Plant.

    Criterion Catalyst Co. L.P. is the world's largest supplier of catalysts for hydroprocessing, including hydrotreating applications. The company is also a leading supplier of reforming and specialty catalysts for the refining industry. Criterion's facility in Azusa, CA installed a Tri-NOx Mult-Chem scrubber with a 3000 cfm capacity at 250 lbs./hr. of NOx. The system has four polypropylene columns, ...


    By Tri-Mer Corporation

  • Enzyme Activities and Chemical Changes in Wet Olive Cake after Treatment with Pleurotus ostreatus or Eisenia fetida

    Abstract  A laboratory experiment was conducted to evaluate the enzyme activities and chemical changes recorded in a recalcitrant phenolic-rich waste after treatment with Pleurotus ostreatus or Eisenia fetida. The waste used was wet olive cake (alperujo in Spanish), a waste produced in huge amounts by the olive oil industry. Both P. ostreatus and E. fetida were very effective in removing ...


  • Improved wet weather wastewater influent modelling at Viikinmäki WWTP by on-line weather radar information

    Municipal wastewater treatment plant (WWTP) influent is typically dependent on diurnal variation of urban production of liquid waste, infiltration of stormwater runoff and groundwater infiltration. During wet weather conditions the infiltration phenomenon typically increases the risk of overflows in the sewer system as well as the risk of having to bypass the WWTP. Combined sewer infrastructure ...


    By IWA Publishing

  • Effectiveness of a Sediment Time Critical Removal Action – PCB Reduction in Fish Tissue, Surface Water and Sediment via Wet Excavation

    Documenting successful remediation of polychlorinated biphenyl (PCB)‐contaminated sediments is limited; potentially due to inadequate monitoring methods, complexities associated with the environment, and selected remedial techniques. At some sites, absence of appropriate baseline and post‐removal monitoring limits proper evaluation of remedial efficacy. Accurate interpretation of interactions ...


    By John Wiley & Sons, Ltd.

  • Turnkey waste handling systems

    The turnkey article discusses the ability of Reaction Distributing Inc. to design waste handling solid waste handling systems that are specific to our clients' individual needs.  The standard line of dry and wet waste compactors as well as the vertical and horizontal balers often form a large part of the overall process however.  It is our ability to analize, recognize and formulate new ...


    By Reaction Distributing Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you