9 Articles found

Articles

indicates free access

  • Hydrogen Sulfide Analyzers – Finding the Right Fit for Your Needs

    Hydrogen Sulfide Analyzers – Finding the Right Fit for Your Needs

    Monitoring hydrogen sulfide (H2S) levels is critical for air quality, safety and environmental professionals across a multitude of industries. Doing so helps prevent complaints, citations, penalties, corrosion, fires, illness, and even death. A ...

    Quincy Biamonte

  • The Secret to Quality Food Products

    The Secret to Quality Food Products

    Quality is everything when it comes to food, and accurate moisture control is essential to quality. Decrease spoilage, wasted products and lost profits by making sure you’re accurately monitoring the moisture content of your food products. ...

    Quincy Biamonte

  • Increase Mercury Vapor Detection Range by 10X

    Increase Mercury Vapor Detection Range by 10X

    Vapor dilution module extends detection range of J505 from nanograms to milligrams How it works: The new 10:1 dilution module for the J505 reduces the concentration of mercury vapor in the sample stream by a factor of ten, allowing for a much ...

    Quincy Walker

  • High Quality Moisture Analysis for High Value Resins

    High Quality Moisture Analysis for High Value Resins

    Whether you’re making syringes or turkey basters, pacemakers or milk jugs, maintaining the correct moisture content in your resins is essential to your production process. Join us February 9-11 in Anaheim, CA at Plastec West / MD&M ...

    Quincy Walker

  • Detecting Mercury in Water

    Detecting Mercury in Water

    Determination of Mercury (Hg) in Water by Hand-Held, Portable Cold Vapor Atomic Fluorescence SpectrometryWater is the most familiar and most abundant compound on Earth, making up 71% of its surface area.[1]It is a vital component for all known forms ...

    James A. Moore;Christopher J. Altamirano;Garrett M Rowe

  • The Fatal Flaw in Dew Point Measurement for Injection Molding

    The Fatal Flaw in Dew Point Measurement for Injection Molding

    Dew-point measurement is a common and important metric in the plastic drying process. A good dew point meter can tell you whether your dryer is working normally or if it’s in need of repair. Dew point meters do this by measuring the humidity ...

  • Moisture in Oils: The Three-Headed Beast

    Moisture in Oils: The Three-Headed Beast

    Abstract Moisture contamination in in-service lube oils is perhaps one of the most destructive forms of engine corrosion second only to particle contamination.  Water contamination in oil can be categorized into three forms of water; Free, ...

  • Time is of the essence in plastics

    Time is of the essence in plastics

    Introduction Determining the moisture content in plastics is an important step in the extrusion and molding process of many industrial resins.  Excessive moisture content can lead to microscopic steam pockets that can blister or weaken the ...

    Chris Altamirano

  • Instant Loss on Ignition Results for Trommel Fines

    Instant Loss on Ignition Results for Trommel Fines

    Cost-effective compliance with landfill tax regimes Many issues have been raised with HMRC’s proposed Loss on Ignition (LOI) testing regime for landfill taxes, including concerns that tests will take too long to be actionable and will cost ...

    Chris Altamirano