7 products found
Pagani Geotechnical Equipment s.r.l. Products
-
Other
-
Pagani - Kit DS-44 for environmental sampling with dynamic penetrometer
The Pagani DS-44 is a thick-walled sampler with a piston and it is driven into the ground by hammering. The piston allows to take samples at the depth required. The impact-hammer-driving system minimizes adverse effects such as heating effect, which occurs in sampling with rotation ...
-
Pagani - Model DP - Penetrometrice Dynamic Tests
Pagani Geotechnical Equipment Penetrometers allows the dynamic driving of cones and rods according to the International Standard ...
-
Pagani - Model CPT - Cone Penetration Testing Tests
The CPT test (mechanical type) is essentially the extent of resistance to opening up a bit of size and mechanical characteristics standardized, stuck in a land-speed constant (2 cm / sec). In Cone Penetration Testing, with the Begemann Mechanical Cone, the Qc (tip resistance) and RL (side friction) values are measured with a load cell and displayed on a readout electronic ...
-
Pagani - Model TGAS07B - CPTu Touchscreen Digital Acquisition System
To satisfy the growing demand for a strong and easyto-use CPTu system, Pagani Geotechnical Equipment designed a new touchscreen CPTu acquisition unit that can be used outdoor with any weather condition. Our touchscreen digital acquisition system TGAS07 simplifies and speeds up the procedure of acquisition without the need for a notebook. Thanks to its qualities as water-resistance, sunlight readable touchscreen and extended temperature range, it is ...
-
Pagani - Model TGAS08 - Touchscreen Industrial Computer for SCPTu
To satisfy the growing demand for a strong and easyto- use SCPTu system, Pagani Geotechnical Equipment designed a new touchscreen SCPTu acquisition unit that can be used outdoor with any weather ...
-
Pagani - Field Vane Tester
This test enables the direct measurement of the undrained shear resistance of saturated cohesive soils. It can be carried out either in the field, on the wall or at the bottom of an excavation, or even in a laboratory on a confined specimen. The test consists of forcing into the soil a vane equipped with four orthogonal blades and then rotating until the soil failure. Maximum torque value must be measured and ...
-
Pagani - Rotary Drilling System
The Rotary System inserted on the sounding rod permits rotary drilling with screw and allows indisturbed sampling by means of a standard sampling unit. Therefore, continuos helical auger permit utilization of such device as Screw-Plate, and other special equipment for In Situ ...