SDEC France

SDEC France

31 products found

Products by Eijkelkamp Soil & Water

  • Field Measurement Equipment

  • Eijkelkamp - Model 06.15.SA - Penetrologger With GPS, Standard Set

    Eijkelkamp - Model 06.15.SA - Penetrologger With GPS, Standard Set

    The resistance to penetration is a means of determining the ground load-bearing capacity, and the ease with which roots will grow through the ground (important when agricultural, rural- and civil engineering techniques are involved). The resistance to penetration is a mechanical characteristic that, given a certain texture, depends on changing parameters such as degree of humidity, density and the strength of the connection between mineral particles....

  • Eijkelkamp - Model 09.01.SA - Hydraulic Conductivity Test Kit

    Eijkelkamp - Model 09.01.SA - Hydraulic Conductivity Test Kit

    In case of direct measurement in the field the auger hole method according to Hooghoudt can be applied.Following this method the determination of the permeability to water of a soil takes little time (by comparison to other methods), requires a limited number of instruments.

  • Eijkelkamp - Model 06.03 - Pocket Penetrometer

    Eijkelkamp - Model 06.03 - Pocket Penetrometer

    The 'pocket penetrometer' is specifically used to determine the penetration resistance of top layers (measuring depth 5 mm) and of samples in the field or in the laboratory. Measuring range 0.5 MPa. When pushing the instrument into the ground, the pin encounters a force of the ground. The spring is compressed by this force. A slip ring is taken along during this operation, which shows on the scale the maximum force that has been encountered. The scale...

  • Model 14.10 - Pocket Vane Tester with 3 Vanes

    Model 14.10 - Pocket Vane Tester with 3 Vanes

    Pocket vane tester for measurement up to 250 kPa (2,5 kg/cm2). The pocket vane tester is a shear strength measuring tool that is used in profile pits or on the surface. The small, practical format also makes the tool very suitable for testing on soil samples. The short period of time the test takes allows for several measurements in the same soil or layer which in turn allows for the calculation of an average value. The shear strength can be raead...

  • Model 14.05 - Field Inspection Vane Tester

    Model 14.05 - Field Inspection Vane Tester

    The shear strength or stress of the soil depends on different soil characteristics such as for instance: the granular composition, the humus content, the humidity and (in case of vegetation covered areas) the degree of coverage and the density of the roots. In order to determine the shear stress in the strata in for instance a profile pit, on the surface (for instance a sports terrain), at the bottom of a borehole or in a sample, several different...

  • Eijkelkamp - Model IB 06.06 - Hand Penetrometer for Top Layers

    Eijkelkamp - Model IB 06.06 - Hand Penetrometer for Top Layers

    The hand penetrometer for top layers is a device that is used to determine the penetration resistance of top layers. Because of the limited overall length of the device, the hand penetrometer can also be used for horizontal measurement, for instance in the walls of profile pits.

  • Model 09.07 - Guelph Constant Head Permeameter

    Model 09.07 - Guelph Constant Head Permeameter

    Guelph constant head permeameter for measurements to a depth of 15-75 cm, complete with field tripod, augers, well brush, water container, vacuum test handpump, etc. in carrying case.

  • Eijkelkamp - Model 14.35 - Soil Oxygen Content Analysis System

    Eijkelkamp - Model 14.35 - Soil Oxygen Content Analysis System

    Soil gas analysis can yield a lot of information concerning the soil environment. Using a ‘piercing probe’ and an oxygen content meter the growing conditions for shrubs and trees can be defined. And who would not want to be able to measure the extent of soil pollution in an area without timeconsuming soil drilling?

  • Hellige - Model 08.10 - pH-Indicator for Soil

    Hellige - Model 08.10 - pH-Indicator for Soil

    A number of analysis of the soil can be executed immediately in the field. The determination of the pH and the nitrate content are soil analysis that frequently occur. The Hellige pH-indicator is a very simple apparatus to estimate the pH (acidity) of a soil for the purpose of a soil suitability indication and straight forward fertilizing advise. The pH is determined on the basis of colour comparison.

  • Arcadis-Eijkelkamp - Model 20.02 - Oil Detection Pan

    Arcadis-Eijkelkamp - Model 20.02 - Oil Detection Pan

    The oil detection pan is developed for a rapid on-site analysis of soil and groundwater for floating contaminants e.g. soaps, dyestuffs and all kinds of oil derivates such as tar, lubricating oil, kerosine and petrol.

  • Eijkelkamp - Model 08.04 - Sand Rulers

    Eijkelkamp - Model 08.04 - Sand Rulers

    A sand ruler is a disc made of transparent material with standard (specimen) samples. It is an excellent indicative aid in determining the particle size distribution. Of the sample to be tested a representative part is rubbed dry with the fingers in the palm of the hand. The sample is then placed in the hollow area in the center of the ruler. The average grain size is now judged by comparing the average grain size of the sample with the specimen in...

  • Eijkelkamp - Model 08.15 - Soil Sampling and Classification Set

    Eijkelkamp - Model 08.15 - Soil Sampling and Classification Set

    Soil research is a very important aspect in the planning and execution of agricultural- as well as civil engineering and operations. In order to make the soil research as comprehensive as possible the following studies must be made with regards to: The build up of a soil; i.e. determining the composition, the thickness and the position of the various strata. The soil properties; measuring the permeability, the filtration capacity, the bearing...

  • Model 09.06 - Mini Rainfall Simulator for Erosion Test

    Model 09.06 - Mini Rainfall Simulator for Erosion Test

    The extent to which the soil is sensitive to erosion is determined largely by the composition of the soil. Knowledge of the sensitivity to erosion is important for the development of a certain plot. The sensitivity to erosion is hard to measure. Absolute values can not be obtained. It is, however, possible to obtain a reasonable indication by means of a relative measurement. For such a measurement a rainfall simulator can be applied.

  • Eijkelkamp - Model 17.21 - Measuring Wheel, Incl. Case

    Eijkelkamp - Model 17.21 - Measuring Wheel, Incl. Case

    Precision measuring wheel with folding grip for distance measuring in the field. The counting mechanism is shockproof and fitted over the measuring wheel. The meter can be calibrated and has a measuring range of 9999.99 m and can be read-out in cm. The tolerance is below 0.02%. The counting mechanism is driven without vibrations. The measuring wheel is supplied inclusive a case.

  • Eijkelkamp - Model 17.16 - Tri-Partite Aluminium Ruler, 300 cm

    Eijkelkamp - Model 17.16 - Tri-Partite Aluminium Ruler, 300 cm

    The aluminium ruler is used for accurate measuring in mm of the planeness of bare surfaces such as asphalt, concrete, gravel, floors of sports accommodations, etc. The aluminium ruler comes in three parts and is supplied inclusive measuring wedges and carrying bag. The overall length measures 3 meter, the range is 1-20 mm and the accuracy is 0.3 mm.

  • Eijkelkamp - Model 08.11.01 - Soil Colour Book

    Eijkelkamp - Model 08.11.01 - Soil Colour Book

    Determination of a subgroup in the soil classification system is based among other aspects on colour differences. The colour of the soil is determined by comparing the sample with standard soil colour charts (Munsell). Soil colour charts are available in a Japanese (12 colour charts; art. no. 08.11.01) and American (10 colour charts; art. no. 08.11.03) version.

  • Eijkelkamp - Model 08.19 - Civil Engineering Soil Test Kit

    Eijkelkamp - Model 08.19 - Civil Engineering Soil Test Kit

    Soil research is a very important aspect in the planning and execution of agricultural- as well as civil engineering projects and operations. In order to make the soil research as comprehensive as possible the following studies must be made with regards to: The build up of a soil; i.e. determining the composition, the thickness and the position of the various strata. The soil properties; measuring the permeability, the filtration capacity, the bearing...

  • Eijkelkamp - Penetrologger with GPS Standard Set

    Eijkelkamp - Penetrologger with GPS Standard Set

    The resistance to penetration is a means of determining the ground load-bearing capacity, and the ease with which roots will grow through the ground (important when agricultural, rural- and civil engineering techniques are involved). The resistance to penetration is a mechanical characteristic that, given a certain texture, depends on changing parameters such as degree of humidity, density and the strength of the connection between mineral particles....

  • Hooghoudt - Model 09.01.SA - Hydraulic Conductivity Test Kit

    Hooghoudt - Model 09.01.SA - Hydraulic Conductivity Test Kit

    In case of direct measurement in the field the auger hole method according to Hooghoudt can be applied.Following this method the determination of the permeability to water of a soil takes little time (by comparison to other methods), requires a limited number of instruments.

  • Model 14.36 - Oxygen Diffusion Meter

    Model 14.36 - Oxygen Diffusion Meter

    Oxygen diffusion meter for measurement of mobility of oxygen in soil + redox measurement. Standard set with read-out unit, reference electrode and brass electrode in case and 1 Pt-electrode for measurements till 70 cm depth. Complete with Riverside auger Ø 7 cm.

  • Eijkelkamp - Model 11.03.30 - Manual Sounding Devices

    Eijkelkamp - Model 11.03.30 - Manual Sounding Devices

    The devices are provided with a probe, which is connected to a measuring tape with centimeter graduation. When the probe touches a conductive liquid, a clear acoustic and light signal is produced. If the cable is then lifted a little, the signal will stop. Determination of this point allows the user to read the depth directly from the measuring tape (accuracy: ± 0.5 cm).

  • Aardvark - Model 09.12.SA - Fully Automated Constant-Head Borehole Permeameter

    Aardvark - Model 09.12.SA - Fully Automated Constant-Head Borehole Permeameter

    The Aardvark permeameter is a fully automated constant-head borehole permeameter to measure soil hydraulic conductivity (Ksat) and other related parameters like sorptivity and percolation in the field. The set can be installed easily and can be used to a depth of 15 m. The permeameter is available for use with a laptop/tablet and for use with a (flash) logger.