Process control and emission monitoring in a waste to energy plant is a challenge. A large number of gaseous components need to be measured with high accuracy. Almost 100% uptime is required and the monitoring system needs to be easy to maintain and fast to calibrate.
Air is lifeblood. Daily we inhale approximately 15.000 liter. Still, the air contains invisible pollutants, which vary in its composition and concentration depending on the location. Especially the respirable particles with a diameter of less than 2.5 µm (PM 2.5) were considered to be particularly dangerous.
The process control of a CO2 capture plant needs good and reliable detection of gas phase NH3 and CO2. Measuring NH3 is a challenge due to the corrosive environment and high concentrations of NH3. Several places in the process needs to be monitored and to transport the sample is difficult. A large dynamic range is needed as the NH3 concentration can vary between 15% volume and a few mg/m3.
RDF is a fuel that is normally produced from waste with high calorific value. The original waste comes from households, industry and commerce and is processed for energy extraction; it is meant for co-incineration plants and replaces standard fuels (e.g. coal) in production plants for cement, power plants or other co-incineration plants.
Our range of hazardous waste incinerators are specially designed to cope with ALL kinds of medical and hazardous waste in ALL climates and conditions. Our products ensure efficient, clean and hassle-free disposal of hazardous waste is possible. These models are suitable for the incineration of clinical waste including type 4 pathological waste (red bag waste) from Hospitals, Research Centres, Pharmaceutical Companies , Drug Manufactures, Primary Care Trusts, Private GPs Practices, Cosmetic Surgery Clinics,...
Weathering of materials is most often an irreversible process affecting the cosmetic properties or strength of materials. This aging process is mainly driven by UV radiation, Heat and reactive elements in the atmosphere, for example chemical contamination. The plastic fabric of the product can dry and therefore weakened. The solar load can overheat the products and change material properties irreversibly. A common method to test the deterioration of materials is to expose materials to sun light and environment....
Waste to energy: The use of refuse derived fuel (RDF) is part and parcel of today`s regulated waste disposal. Using a selective treatment process, fractions high in calorific value are separated off from commercial and industrial waste, creating a marketable product. Depending on calorific value, composition and particle size, this fuel is used in industrial fluidised bed firings, in cement kilns and in RDF power plants.
Power plants play a vital role. We help minimize downtime while delivering safety and productivity. Whether your power plant serves the needs of ordinary homes, hospitals or factory production lines - the world needs reliable and safe power, and you need profitability. At Endress+Hauser, we bring precision and safety to power plants all over the world.
The Xact® 625i combined with ADAPT software creates the industry's most powerful tool for high time resolution detection of airborne metals. The Xact® 625i measures trace metals at very low detection limits at time resolutions down to 15 minutes. The ADAPT package captures corresponding wind speed and wind direction data, then seamlessly integrates the measurements into wind regression analyses available at the touch of a button. This creates the most single most powerful fence line/ source identification...
There are valuable resources in waste that have to be extracted. Being specialists in the processing of waste of all kinds – first and foremost in the area of refuse derived fuels – we constantly work on the advancement of our solutions for customer-oriented and cost-effective shredding.
OPSIS non-contact monitoring solutions, based on either DOAS or TDL techniques, are very well suited for applications in the mining and smelting Industries, as the flue gas conditions often involve high temperatures and high dust concentrations.
Newland Entech Europe could reducing NOx emissions adding ozone to the flue gas before it enters the chimney. The ozone convert the NOx to N2O5, which it is high soluble in water
and is easily removed from the flue gas by a scrubber.