biogas flare Equipment available in France

Available in France| Near France
57 Results found

We couldn't find any biogas flare equipment in France

Here is a list of results available in France

Current filtering criteria

You can remove a filter by clicking on the x
  • Category: Energy & Renewables ×

  • Subcategory: Biogas ×

  • Keyword: biogas flare ×

  • Available in: Europe ×

  • Available in: France ×

HOFGAS - Model IFL4c - Customised Biogas Gas Flaring System

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

Customised HOFGAS-IFL4c biogas gas flaring system is deployed when express regulations on gas emission must be observed. Because of no visible flame, erection of the gas flare is most advantageous even near residential areas. The system is simple to operate and adjust, and starts reliably. The high temperature flare for biogas comes with the ...

Biogas Flare

by BioBG GmbH     based in Westerstede, GERMANY

If biogas can’t get stored or removed by CHP cause of maintenance or stoppages, it should get burnt for environ- mental reasons. This can be done by biogas flares. Manually steared flares has to be started and stopped by stuff and are often powered by a 12V lead-acid battery. Fully automatic flares are starting, if there is too much gas- ...

HydroThane - Biogas Flare

by HydroThane STP BV     based in KC `s Hertogenbosch, NETHERLANDS

HydroThane can deliver different types of emergency burners / flares for biogas - waste (water) treatment plants. Biogas flares have the task of temporary or periodic burning of biogas produced by an anaerobic process in case there is no possibility to use it for energy production.

GWE - Biogas Flares

by Global Water Engineering (GWE)     based in Bangkok, THAILAND

All anaerobic plants, must be equipped with a biogas flare, for safety reasons. GWE flares are designed to operate at low to medium pressure (<50 mbar), without the need for a biogas fan and for continuous burning in a wide range of biogas flows (5-100 %). This avoids the need for biogas storage systems (e.g. balloons) and keeps the biogas ...

Elevated Biogas Flares

by DWS bvba     based in Wijnegem, BELGIUM

Flare for a capacatiy from 50 Nm3/h to 6.000 Nm3/h. Minimum methane concentration as low as 45% without pilot gas. No pilot gas needed.Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

Shielded Biogas Flares

by DWS bvba     based in Wijnegem, BELGIUM

Flare for a capacatiy from 50 Nm3/h to 500 Nm3/h. Minimum methane concentration as low as 45% without pilot gas. No pilot gas needed.Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

Model T - Biogas Flare Stacks

by Progeco s.r.l.     based in Brescia (BS), ITALY

The T flare is a self-supported elevated flare (open type) complete with a safety ladder and an upper platform that allow access to the nozzle and ignition and flame control equipment. The flame shield is designed to prevent accidental flame extinguishing and provides a chamber lined with fiberceramic for more complete biogas combustion. The flare ...

Model EMR - Biogas Flare Stacks

by Progeco s.r.l.     based in Brescia (BS), ITALY

EMR flare is a simple safety device typically installed in biomass plants where there are no specific restrictions relevant to fumes exhaust height, minimum combustion temperature, and a partially visible flame is accepted. All the equipment is fitted on-board, contained in a stainless steel frame which simple design and small footprint allow for ...

No Temperature Control Ground Biogas Flares

by DWS bvba     based in Wijnegem, BELGIUM

Flare for a capacatiy from 50 Nm3/h to 2000 Nm3/h. Minimum methane concentration as low as 20%, also for landfill. Pilot gas on biogas. Low pressure, flow direct from reactor, no blower needed. Weather proof ignition system. 10 years waranty on body. 2 years on electronics and ignition system at normal use.

Static Biogas Flare

by CONVECO S.r.l.     based in Brescia, ITALY

Static biogas flare combustion is indicated when reclaiming old landfills or to ensure the safety of new landfill where biogas production capacity is limited because of low waste disposal levels of and where electricity is not for to drive various items of equipment.

Biogasmart - Model ST - Elevated Biogas Flare Stack

by Biogasmart     based in Gadesco Pieve Delmona, ITALY

The T flare is a self-supported elevated flare (open type) complete with a safety ladder and an upper platform that allow access to the nozzle and ignition and flame control equipment. The flame shield is designed to prevent accidental flame extinguishing and provides a chamber lined with fiberceramic for more complete biogas combustion.

Biogasmart - Model HE-Type - High Efficiency Biogas Flare Stack

by Biogasmart     based in Gadesco Pieve Delmona, ITALY

HE-Type is an enclosed ground flare; combustion takes place within a cylindrical chamber lined with fiberceramic and this causes a higher destruction efficiency of the biogas in comparison to open flares. Enclosed combustion also makes flame and noise less perceptible and for this reason these flares are normally selected for installation in ...

HOFGAS - Model IFL2c - Standard Flare for Sewage or Biogas Plants

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

This biogas / WWTP gas flare with insulated combustion chamber and manually air combustion regulation is deployed when express regulations on gas emission must be observed. Controlled combustion of methane gas within high temperature flare.

HOFGAS - Model IFL1c - Standard Gas Flare for Gasholder Operation

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

Standard biogas / WWTP gas flare for sewage or biogas plants. Ideal in combination with gasholder operation and gas systems with constant pressure ratios. Thanks to concealed combustion, the HOFGAS-IFL1c flare attains more than 99% combustion efficiency. Because of no visible flame, erection of the gas flare is most advantageous even near ...

HOFGAS - Model APM - Gas Treatment Plant for Recovery

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

The HOFGAS- APM is a complete pump and flare station for the safe and economic treatment of gas from anaerobic fermentation. Apart from the plant components, a detailed regulation and operational concept is supplied for the specific adaptation to the particular process. In particular, the discharge pressure for recovery is regulated and the signal ...

Hofstetter - Model Ready/Palma - Gas Treatment Plant for Methane Gas From Lagoons

by Hofstetter BV     based in Schiphol-Rijk, NETHERLANDS

Hofstetter offers a reliable system for processing methane gas from palm oil extraction or other typical anaerobic digestion processes. The biogas is disposed of in an environmentally friendly manner or used to generate electricity.

Model 97310 - Enclosed Flare

by Shand & Jurs (L&J Technologies & L&J Engineering)     based in Hillside, ILLINOIS (USA)

The S&J 97310 Enclosed Burner removes harmful emissions from waste gas streams. This unit is specifically designed to bring emissions levels to within allowable limits as dictated by customer requirements or governmental bodies such as the EPA. Every unit is designed for maximum destruction efficiency for each application’s process ...

NOXmatic - Model BM - Biomethane Flare

by ennox biogas technology GmbH     based in Hard, AUSTRIA

Modern and large biogas systems for biogas upgrading to natural gas quality is becoming ever more popular. Here the biogas is treated for the complete removal of all unwanted gaseous materials and fed into the gas network or alternatively used as fuel in vehicles.

ECO - Manual Gas Flare

by ennox biogas technology GmbH     based in Hard, AUSTRIA

THE robust and maintenance free flare suitable for small biogas systems, special installations or when an automatic gas flare is not specified. The NOXeasy flare is manufactured entirely from stainless steel and equipped with high quality components (i.e., ATEX certified flashback prevention, DVGW certified manual flap).

Model 97300 - Waste Gas Burner

by Shand & Jurs (L&J Technologies & L&J Engineering)     based in Hillside, ILLINOIS (USA)

The Shand & Jurs Biogas 97300 Waste Gas Burner is specifically designed to operate efficiently with low BTU anaerobic digester waste gases. The 97300 helps to properly contain and incinerate waste gases thus minimizing odors and VOCs.

Related Terms for biogas flare

Need help finding the right suppliers?

Let the XPRTs do the work for you