Coal-fired Power Applications

41 Results found
Only show results in Virginia?
OK
  • Category: Energy & Renewables ×

  • Subcategory: Coal-fired Power ×

NH3 Monitoring in Air

by Unisearch Associates Inc.     based in Concord, ONTARIO (CANADA)

NH3 (Ammonia) is a colorless gas with a distinctive pungent smell. Ammonia monitoring is essential in coal-fired power plants, where NH3 is used to reduce NOx emissions. The ammonia consumes all of the NOx, but its high concentration that is needed for these purposes also starts reacting with other things and in the process can clog up filters and cause premature failure of expensive SCR equipment and pre-heaters. Not to mention that these high levels create an irreparable damage to the environment.

Coal pulverizing for the coal industry

by Columbia Steel Casting Co., Inc.     based in Portland, OREGON (USA)

Columbia Steel has established itself as a manufacturer of quality replacement parts for coal pulverizers and ash crushers used in power plants.

Power Plant & Power Station Emissions Monitoring

by Procal - Parker Hannifin Corp     based in Peterborough, UNITED KINGDOM

For more than 25 years, coal and biomass fired plants have formed the largest installed user base for Procal CEM systems. Throughout this period, there has been increasing environmental scrutiny and process upgrades, including the near-ubiquitous use of after-treatment systems such as sophisticated FGD and SCR.

Primary air control for coal-fired power plants

by Kurz Instruments, Inc.     based in Monterey, CALIFORNIA (USA)

Power Generation Combustion Air Measurements: The need for accurate, repeatable & reliable combustion air measurements in power generation plants is critical to efficient operation and safety throughout the entire facility and processes. Coal-fired power plant applications pose a number of challenges to obtaining these critical flow measurements includ¬ing large ducts, limited metering runs, poor velocity and temperature profiles, high vibration, temperatures up to 750° F and dirty `Fly Ash` laden air.

Environmental monitoring solution for power plant

by Ecotech Pty Ltd     based in Knoxfield, AUSTRALIA

The construction of coal and natural gas power stations is continuing at a steady rate along with older power stations being retrofitted with more effective flue gas cleaning systems. Both the community and environmental protection authorities are paying closer attention to both emission and ambient concentrations around power stations.

Continuous process waste tyre to oil recycling

by DoingGroup     based in Henan Province, CHINA

Solution: Continuous pyrolysis plant Function: Recycling waste tire to fuel oil Applicable raw material: Car tire, Truck tires, OTR tries, etc Output: 45-52% crude oil, 30% carbon black,12-15%steel wire, 8% waste gas Heating fuel: Coal / wood / fuel oil / gas Pyrolysis plant land size: 25x20m Reactor design: Mutiple reactors with internal rotating Reactor material: Q245/Q345 Boiler plate

Alternative Fuel Production for Energy / Substitute Fuel Production for Energy

by eFACTOR3 LLC     based in Pineville, NORTH CAROLINA (USA)

Being driven by new legislation, the production of substitute fuel/alternative fuel will be gain momentum in the next few years, as well as the expected increase of recycling rate in municipalities. This means a lot of waste streams can be turned into alternative fuel for the coal fired power plant, cement and lime industry, biomass power plant, or other industrial boiler systems that still burning fossil fuels.

Liquid pumping for the pharmaceutical industry

by Watson-Marlow Fluid Technology Group     based in Falmouth, UNITED KINGDOM

SPS pumps have been successfully used in the cosmetics industry for many years for gentle transfer of shampoos, creams, pastes and lotions. The highest hygienic standards, no pulsation, gentle conveyance and CIP also make the SPS series pump very successful in biopharmaceutical applications.

Liquid pumping for the fine chemical industry

by Watson-Marlow Fluid Technology Group     based in Falmouth, UNITED KINGDOM

SPS pumps stand out from the competition for handling shear-sensitive suspensions, solutions, washing-up liquid and detergents, as well as very viscous media such as silicones

Agitation and mixing solutions for flue gas desulfurization

by National Oilwell Varco     based in Dayton, OHIO (USA)

FGD (Flue Gas Desulfurization) involves the treatment of flue gas from coal fired power plants.  The main goal is to remove sulfur, particulates, and other chemicals such as mercury from the flue gas prior to environmental release.  Governmental regulations by the EPA put limits on the amount of impurities which can be released into the air.   The use of mixers to clean and scrub the flue gas is utilized to help power companies meet permitted limits on the release of controlled substances.

Low emissions auxiliary boilers to coal or otherwise fired power plants

by Superior Boiler Works, Inc.     based in Hutchinson, KANSAS (USA)

Whether providing high-efficiency, low emissions auxiliary boilers to coal or otherwise fired power plants across the United States, or heat recovery steam generators to natural gas fired turbine plants you will find Superior Boilers serving the needs of power generation customers for years to come.

Filtration systems & solutions for energy sector

by Porvair Filtration Group     based in Fareham, UNITED KINGDOM

Porvair Filtration Group have supplied a comprehensive range of filtration and separation products to the energy market for many years. We supply all major sectors of the power generation, distribution and supply industry, and our technology is used over a wide range of applications. These include, but are not limited to, the distribution of natural gas, conditioning and treatment of fuel oils, hydrocarbons and produced water, clean coal technologies, gasification and fuel cell technology. Our unrivalled experience and extensive product range ensures we can supply a fully engineered tailored solution for every application.

Spill containment for municipal / military

by Millennium Enterprises, Inc. (MEI)     based in Marietta, GEORGIA (US) (USA)

The SafeGuards line of spill containment products are used in various municipal/military applications ranging from fuel truck containment; fuel and water bladders; maintenance areas to custom solutions for unique applications.

Pyrolysis oil to diesel

by DoingGroup     based in Henan Province, CHINA

Pyrolysis oil to diesel continuous waste pyrolysis oil to diesel Solution: Oil refining machine Applicable: Tire oil, Plastic oil, Waste oil, Pyrolysis oil,Engine oil, Black oil, Heavy oil, etc Output: 85-90% good clean oil, the rest is slag and waste gas Heating fuel: Coal / wood/ fuel oil / gas Oil refining machine land size: 20X15m Reactor material:Q245/ Q345 Boiler plate

Gypsum factory bag filter bags

by Zhejiang Grace Envirotech Co., Ltd     based in XIAOSHAN, CHINA

ECOGRACE produce all bag filter bags for emission control for industry like gypsum factory, asphalt mixing site, tabacco factory,cement mill, cement kiln, steel plant blast furnace,biomass boiler, coal fired boiler.etc.

HCl Monitoring in Air

by Unisearch Associates Inc.     based in Concord, ONTARIO (CANADA)

Hydrogen chloride (HCl) is a colorless, sometimes slightly yellow, gas. It is an undesired environmental component that may be damaging to workers and the surroundings. Exposure limits have thus been established by industries to make sure that the workers operate in a safe environment. HCl monitoring is especially required for incinerators, coal-fired power plants, aluminum recycling and cement plants. Unisearch offers a reliable and easy-to-use HCl analyzer – the TDLAS-based LasIR system. Studies have shown that TDLAS equipment provides data that is more accurate than conventional gas monitoring equipment. When calibrated for HCl monitoring, TDLAS is able to detect this gas among other gases present in the area and provide continuous updates with regards to the changes in its concentration.

Coal Combustion Residuals Disposal for Power Plants

by CETCO     based in Hoffman Estates, ILLINOIS (USA)

Coal combustion residuals (CCR) are generated during the power generation process and can include fly ash, bottom ash, boilerslag, and flue gas desulfurization (FGD) residuals. CCRs contain trace concentrations of heavy metals and therefore cannot be dumped or stored where rainwater can leach the metals. Liner systems can be used to contain the coal combustion by-products and protect them from leaching into the environment.

GIS software for mining industry

by Esri     based in Redlands, CALIFORNIA (USA)

The resources in the earth`s crust require sophisticated technology to discover, extract, and manage. Since mining is inherently spatial, requiring accurate knowledge of areas of the earth`s surface and subsurface, geospatial technology is best suited to intelligently oversee all phases of the mine operation. GIS gives mining companies the tools they need to operate mines responsibly and at optimum efficiency. It is a comprehensive, interoperable technology specifically designed to compile, process, display, analyze, and archive volumes of interdisciplinary data.

Need help finding the right suppliers?

Let the XPRTs do the work for you