Only show results available in Virginia? Ok

Combustion Applications

  • Premium

    Air pollution control for the petroleum processing and petrochemical industries

    The petroleum processing and petrochemical industries place a large emphasis on engineering quality, safety and reliabiliy. With our extensive experience on various processes in these industries, Anguil is the perfect partner to meet these concerns.

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • Premium

    VOC and HAP Abatement

    As is the case for many industrial manufacturing processes, emissions are best destroyed through the use of thermal and catalytic oxidation technologies. Volatile Organic Compounds (VOCs) and Hazardous Air Pollutants (HAPs) are destroyed through the use of high temperature combustion with direct heat recovery. The harmful air pollutants are converted to heat, water vapor and carbon dioxide, creating a destruction efficiency greater than 99%.

    By Anguil Environmental Systems, Inc. based in Milwaukee, WISCONSIN (USA).

  • Premium

    Oily Waste Plants for Oil and Gas Industry

    Wherever oil is produced, processed, transported or stored, our clients face large amounts of oily waste in many different forms. Our VacuDry technology allows efficient and environmentally friendly treatment of all oily waste streams within a single plant. Due to the conditions under which the waste is treated (low temperature, vacuum and nitrogen blanketing), the recovered oil can then be reused after treatment.

    By econ industries GmbH based in Starnberg, GERMANY.

  • Premium

    Several waste gas streams: Short, high concentration peaks and a constant |medium concentration

    Concentration peaks and liquid waste posed a tough challenge on the air pollution control system. With the CTP solution, this waste is not only disposed of but also reduces the burner energy considerably.

  • Premium

    Air combustion for chemical plants

    By AEREON based in Austin, TEXAS (USA).

  • Premium

    Monitoring solutions for the flow combustion efficiency areas

    Combustion efficiency is of major importance on small boiler plants and the best way to monitor this is by monitoring CO2 emissions. CODEL offer the Model 1010 Cross-Duct CO monitor. Using Infra-red Gas Filter Correlation technology to filter out interferences such as dust and other gases. The Model 1010 has low maintenance requirements and meets the needs of most boiler applications. In addition to small boilers the Model 1010 is also used on Animal carcass incinerators and Crematoriums.

    By Codel International Ltd based in Bakewell, UNITED KINGDOM.

  • Premium

    Gas monitoring and dust monitoring for the powerplants industry

    LaserGas measurements

    • Boiler combustion control, O2 and CO
    • DeNOx system, NH3 and NO
    • Electrostatic precipitators (ESP), CO monitoring for explosion prevention
    • Stack gas emissions, NH3, H2O, NO
    • Coal silos, CO monitoring for explosion prevention and detection of smouldering fires (only in coal fired plants)

    LaserDust measurements

    • Stack gas emission
    • Coal silo, explosion prevention

    By NEO Monitors AS based in Skedsmokorset, NORWAY.

  • Premium

    Particles and alkaline compounds

    The malodorous gas given off, loaded with solid and particulate matter, requires a robust installation that guarantees a 24/7 operation. The contamination of the gas given off with alkaline metals was a challenge that led to the development of a special ceramic heat exchanger material.

  • Premium

    Air combustion for the petroleum refining industry

    By AEREON based in Austin, TEXAS (USA).

  • Premium

    Waste air combustion for municipalities

    By AEREON based in Austin, TEXAS (USA).

  • Premium

    Enclosed air combustion for the natural gas industry

    By AEREON based in Austin, TEXAS (USA).

  • Premium

    Feed-in tariffs while avoiding low price periods

    Biomass energy from gasification, when done responsibly with waste wood or suitable agricultural waste such as nut shells, is often eligible for feed-in tariffs. However, biomass gasification has the advantage of being on-demand, so you can feed renewable energy onto the grid at times when wind and solar are not abundant, enabling you to avoid times when prices are too low due to an excess of wind or solar power being fed to the grid.

    By All Power Labs based in Berkeley, CALIFORNIA (USA).

  • Premium

    Dead tree and forest thinning disposal

    Dead trees and wood from forest management can be chipped and dried for gasification. The electricity generated can offset electrical costs while the consumption of waste wood offsets disposal costs. Disposal by gasification also has far lower particulate emissions than controlled burns and a lower carbon footprint than decomposition, since methane emissions from anaerobic decomposition are avoided. Decomposing wood reverts all of its carbon content to CO2, but gasification sequesters a portion of it as charcoal waste, usable as biochar.

    By All Power Labs based in Berkeley, CALIFORNIA (USA).

  • Premium

    Woody biomass gasification

    Converting wood waste into electricity—lumber mill off-cuts, wood from forestry thinnings (cleared of leaf matter), disposal of wooden pallets and crating (with nails removed). Wood is chipped, dried, and used to produce electricity, reducing electrical costs and paid disposal. Disposal by gasification also has far lower particulate emissions than controlled burns and a lower carbon footprint than decomposition, since methane emissions from anaerobic decomposition are avoided. Decomposing wood reverts all of its carbon content to CO2, but gasification sequesters a portion of it as charcoal waste, usable as biochar.

    By All Power Labs based in Berkeley, CALIFORNIA (USA).

  • Premium

    Disposal of dead trees, slash, and thinnings

    Dead trees and wood from forest thinning can be chipped, dried, and converted to renewable energy while eliminating disposal costs. Disposal by gasification also has far lower particulate emissions than controlled burns and a lower carbon footprint than decomposition, since methane emissions from anaerobic decomposition are avoided. Decomposing wood reverts all of its carbon content to CO2, but gasification sequesters a portion of it as charcoal waste, usable as biochar.

    By All Power Labs based in Berkeley, CALIFORNIA (USA).

  • Premium

    Air pollution control for the waste gasification industry

    Processes that create a synthetic gas (syn gas) in a gasification process for waste reduction, electricity generation, or steam production (CHP – combined heat and power processes) – commonly benefit from custom heat recovery systems.

    By Catalytic Products International (CPI) based in Lake Zurich, ILLINOIS (USA).

  • Premium

    Dead tree disposal

    By converting dead trees into wood chips and gasifying them, our machine produces clean electricity and offsets disposal costs. Disposal by gasification also has far lower particulate emissions than controlled burns and a lower carbon footprint than decomposition, since methane emissions from anaerobic decomposition are avoided. Decomposing wood reverts all of its carbon content to CO2, but gasification sequesters a portion of it as charcoal waste, usable as biochar.

    By All Power Labs based in Berkeley, CALIFORNIA (USA).

  • Premium

    High quality gas sensor solutions for landfill

    State-of-the-art systems enabling easy monitoring of CO2 and CH4 gases. Capped Landfill Sites produce a range of gases, mostly methane and carbon dioxide. Legislation requires that these gases are safely removed from beneath the cap to avoid a physical explosion due to the build-up of pressure beneath the cap. Safe disposal usually entails burning such as flare stacks, internal combustion engines or by processing to produce Methane gas fuel. For large sites with access to power distribution infrastructure internal combustion engines are used to generate electricity which is fed into the local electricity grid. All of the above safe disposal process require the measurement of the Methane content (and in many cases the CO2 concentration). Edinburgh Sensors provide gas sensors for both Methane and CO2 that can be integrated into landfill gas processing systems enabling easy monitoring of these gases.

    By Edinburgh Instruments Ltd based in Livingston, UNITED KINGDOM.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you