Hydropower Equipment

351 Results found
Only show results in Virginia?
OK
  • Category: Energy & Renewables ×

  • Subcategory: Hydropower ×

Nautilus - Model T-ULH - Ultra Low Head Turbine

by Nautilus LLC     based in Greenfield, MASSACHUSETTS (USA)

The T Ultra Low Head turbine (T-ULH) is the most powerful open flume turbine built by Nautilus. This unregulated design produces from 500 watts to 3,300 watts with a head range from 1m to 3.7m. Often two or three units are installed to match streamflow variation or the T-ULH is installed in combination with the Regulated CMC. For large open flume ...

Turgo Impulse Turbines

by Gilbert Gilkes & Gordon Limited     based in Kendal, UNITED KINGDOM

The Turgo Impulse design is one of three options in the Gilkes range. It has been developed to be a simple impulse type machine with a higher specific speed than a Pelton. The design therefore allows a larger jet of water to be directed at an angle onto the runner. Covering the boundary between a Pelton and Francis machine, the Turgo turbines ...

Francis Impulse Turbines

by Gilbert Gilkes & Gordon Limited     based in Kendal, UNITED KINGDOM

The Francis Turbine is one of three options in the Gilkes range. Gilkes Francis Turbines are available as either horizontal or vertical units. The water enters the spiral, or scroll case, and is directed by a series of moveable guide vanes, or wicket gates, to the turbine runner. As the water passes through the runner it rotates and the water ...

Control and Automation Systems

by JLA & Co Sprl     based in Marchin (Belgique), BELGIUM

The “Automation & Control” department at JLA & Co is able to support you with the automation of your hydroelectric power plant, including:

HYDRO - Model 11K2AP - Submersible Electric Pump

by Hydropompe Srl     based in Ponte nelle Alpi - Belluno, ITALY

Submersible electric pumps suitable for the lifting of clear and dirty water. They are especially used in building yards and for pumping abrasive liquids. This is a high head pump.

Hydraulic Turbines

by ESPE Group     based in Grantorto (PD), ITALY

The hydraulic turbine is a machine that turns hydraulic energy into mechanical energy, with a conversion yield of approximately 90%. This mechanical energy is then converted into electrical energy by means of an alternator.

ACT - Spillway and Gate Handling at Hydroelectric Dams

by Advanced Crane Technologies LLC     based in Reading, PENNSYLVANIA (USA)

ACT provides corrosion resistant sheaves and blocks for gate handling at hydroelectric dams, stoplog handling beams, gate handling equipment, and gate hoist machinery as well as cranes. We can provide our customers products with coatings, and designed for immersion in water.

Kaplan Turbine

by ČKD Blansko Holding, a.s.     based in Blansko, CZECH REPUBLIC

Since 1904 CKD Blansko has manufactured more than 427 Kaplan turbines and they operate at 111 sites. Their total output amounts more than 5346 MW.  We provide horizontal or vertical, spiral or flume arrangement, bulb, pit or S-type with fixed or regulated blades and/or wicket gates. All types of Kaplan turbine used for operation within the ...

Hydropower screw

by REHART Group     based in Ehingen, GERMANY

As far back as 250 B.C., Archimedes discovered the principle of the screw named after him. It enabled water to be brought up to a higher level. At that time, it was a revolutionary invention for the irrigation and drainage of large fields. The transfer of energy used in Archimedes' screw pump was later reversed to create a system for generating ...

Kaplan Turbines

by VAPTECH Ltd     based in Sofia, BULGARIA

The axial turbines are designed for projects with low and very low heads with a strong flow variation. VAPTECH offers mainly the classic vertical shaft Kaplan turbine with 3 to 6 runner blades and with double regulation. For runner diameters up to 1400 mm we use a steel spiral casing and for bigger runner diameters we recommend a concrete spiral ...

Trash-Rack Cleaning Machines

by CINK Hydro - Energy k. s.     based in Sadov, CZECH REPUBLIC

Trash-rack cleaning machines reliably remove deposited foreign bodies from the protective rack in front of the inlet openings and ensure unobstructed flow of water to the turbines. Depending on the scope of contamination, trash-rack cleaning machines secure high energy use of your hydropower station. In particular, in the autumn when leaves fall ...

Pelton Turbines

by Gilbert Gilkes & Gordon Limited     based in Kendal, UNITED KINGDOM

The Pelton Wheel maintains a high efficiency over a wide flow range. Whenever possible two or more jets are specified. This increases the high efficiency flow range. Every Gilkes turbine is designed to optimise your site conditions providing the best annual energy production figures. Pelton turbines are medium to high head free jet impulse ...

Hydroelectric

by Pr.En.AI. srl     based in Vicenza, ITALY

Hydroelectric plants exploit the kinetic energy of flowing water on different levels. The primary energy source is the sun that sets in motion the 'water cycle'. The movement and the weight of the water of a waterfall can be used to put in rotation of the blades connected to a transmission shaft (rotor) in turn connected to a dynamo. The concept ...

Model HS1000 - Tidal Turbines

by ANDRITZ HYDRO Hammerfest     based in Hammerfest, NORWAY

The HS1000 is a 1MW pre-commercial demonstrator deployed at the EMEC tidal test site in the Orkney Isles. The device is essentially a scaled up version of the HS300, with some changes made to accommodate the facilities at the EMEC tidal test site. The turbine is heavily instrumented and will serve as a platform for future research and development ...

Tocardo - Model T2 - Tidal Turbine

by Tocardo     based in Den Oever, NETHERLANDS

The T2 turbine is perfect for inshore and offshore tidal sites. The size and weight of the turbine are still limited compared to big 1 MW+ turbines, making it easier and cheaper to transport and install, which reduces project costs. Installing a 1 MW array of T2's will be cost competitive with a single 1 MW turbine, without the risks involved with ...

Hydropower

by SINOHYDRO CORPORATION     based in Beijing, CHINA

As the industry leader in the water resources and hydropower engineering sector, SINOHYDRO specializes in the design and implementation of complex industrial projects in the energy sectors, including dams, power stations, and transport and storage solutions to handover of turnkey projects. SINOHYDRO controls 70% domestic market share.The large and ...

FishFlow - Fish-safe Rotary Drum Screen for Water Intakes

by FishFlow Innovations     based in Medemblik, NETHERLANDS

Many industrial facilities extract water from lakes, rivers or coastal waters for cooling installations, hydropower or water supply. The entrainment of floating debris or fish can have adverse effects on industrial processes and cause fish mortality. The innovative rotary drum screen that has been developed by FishFlow Innovations effectively ...

Hidroturbin - Model Arvida™ - Hydroelectric Power Plants (HEPP)

by Hidroturbin     based in Çankaya/ANKARA, TURKEY

Hydroelectric power plants (HEPP) aim to generate electrical energy using the potential energy of the water. In order to generate energy, run-of-river plants separate river from its course and convey it by transfer structures in order to acquire desirable head then dispatch the water through pressured pipes (penstocks) to the turbines. This ...

Spire Metering - Model Regal Series RH40 - Handheld Ultrasonic Flow & BTU Meter

by Spire Metering Technology     based in Marlborough, MASSACHUSETTS (USA)

Spire Metering is proud to present the smallest yet powerful portable flowmeter /BTU meter on the market! Our innovation never stops! This Handheld Ultrasonic flow and BTU meter, RH40, is a revolutionary portable meter with numerous features and powerful functions. It is the most compact and mobile portable flow/BTU meter on the market. The meter ...

Hydro Control Cabinet

by Gedawin Novo Controls Inc.     based in Clayton, ONTARIO (CANADA)

Gedawin Novo Controls designs, manufactures and markets control and protection systems for the small hydroelectric generation industry. The Hydro Control Cabinet houses the NovoTAS-630 Turbine Automation and Protection System, local operator interface as well as all the interposing relays and terminal blocks to connect to the unit field sensors ...

Need help finding the right suppliers?

Let the XPRTs do the work for you