Oil Combustion Articles

  • Tuning Your Boiler for EPA Boiler MACT Compliance

    The EPA’s Boiler MACT regulations are heating up. Boiler MACT is an EPA rule to limit hazardous air pollutants (HAP) from commercial and industrial boilers and process heaters. Originally proposed in 2011 as a mandate driven by the Clean Air Act,  the rules are Area Source Boiler MACT 40 CFR 63, subpart JJJJJJ for smaller boilers (stores, hotels, apartments, ...


    By Sierra Instruments, Inc.

  • Hurricane HR Cyclones to capture fine fly ash particulate enabling the use of wood waste fired thermal oil heater for Sonae Indústria - Case Study

    The company was forced to use a natural gas fired hot gas generator for drying fibre despite having the necessary amount of thermal energy available in the exhaust stream of a wood waste fired thermal oil heater. The problem of using the biomass thermal oil heater laid on the emission of fine burnt and unburnt particulate which were carried over with the dried fibre and finally deposited on the ...

  • Additives mixing effect fuel consumption

    Additives are an instrument of fuel operational development properties which can’t be provided with the previous stages of fuel producing. They lead to product correction, instead of participate in the main method of production. Their efficiency is caused by chemical structure, structure of a basic base, mutual influence and additives mixing process. Improvers which affect some parameters ...


    By GlobeCore GmbH

  • Client - Oil Refinery, Eastern Europe

    Project - Heavy Oil Pre-Heater As part of an overall facility upgrade this major oil refinery decided to seek ways of reducing its heavy oil pre-heating costs. A proposal was submitted that would enable waste heat from the refinery to be used as the source to safely pre-heat the stored heavy oil. The solution proposed the use of a gas to water recovery unit coupled to two heat pipe ...


    By Econotherm UK Ltd

  • Additives mixing effect fuel consumption

    Additives are an instrument of fuel operational development properties which can’t be provided with the previous stages of fuel producing. They lead to product correction, instead of participate in the main method of production. Their efficiency is caused by chemical structure, structure of a basic base, mutual influence and additives mixing process. Improvers which affect some parameters ...


    By GlobeCore GmbH

  • European Oil and Gas from Exploration to End User

    Made up of a team of senior specialists dedicated to innovation and dependability in the field of combustion technology; CS Combustion Solutions' (CS) staff use their 25 years of expertise in engineering, supplying and commissioning of vertical and horizontal combustors for a wide range of applications to find the best results for each individual requirement. "We are a company that specialises in ...

  • WIRAJASA Waste Oil Burner

    Brief description on our patented Waste Oil Burner that was introduced in 2008. This innovative device works on two key principles namely pre-heating of waste oil and application of super-heated water or sub-critical steam to enhance the oxidation of heavy oil. Heating capacity of this burner is adjustable starting from 700,000 BTU/hour to 1,400,000 BTU/hour is suitable for various thermal ...


    By CV Wirajasa Teknik Industri

  • 7 Questions You Should Ask a Waste Oil Furnace Salesperson Before You Buy

    As with any other business purchase, you should do your homework before making the decision to buy a waste oil furnace. Any open, honest salesperson from a reputable company will be happy to inform and educate you on what you can expect from installing a waste oil burner in your facility. Being in the know to make an empowered buying decision is your first step to gaining the cost-savings and ...

  • Biomass fired thermal oil heater case study

    This 12 MWth output Biomass Power Plant is one of the turnkey products of Biomass Power. The plant was fully commissioned in December 2006. The system has a capacity of 12 MW thermal output producing up to 10MWth of 300°C 10 Barg pressure hot oil, up to 10 tonnes per hour of steam and 2 MWth of 200°C hot air. This is all achieved from one grate heating three separate heat exchanges. The ...


    By Biomass Power Limited (BPL)

  • Update on the homeowner heating oil safety bill

    All homeowners in Massachusetts should be aware that on December 29, 2008, the State Senate enacted the long-awaited Homeowner Heating Oil Safety Bill as Chapter 453 of the Acts of 2008. It required homeowners to upgrade their existing oil heat supply line and insurance companies to offer coverage for a spill by July 1, 2010. On January 5, 2009, it was signed by the Governor. On June 30, 2010, a ...


    By Penney Engineering, Inc

  • No Safe Harbor: The shipping industry`s pollution problem

    DCBureau.org, an award-winning investigative journalism organization, has released a major three-part series exposing the heavy public health and environmental damage of the commercial shipping industry. No Safe Harbor: The Shipping Industry's Pollution Problem, written by environmental correspondent Adam Sarvana, shows how the industry has for years avoided regulatory scrutiny even as it has ...


  • Case study - Bakery ethanol

    Overview A bread and bun bakery was faced with installing air pollution control equipment to control the volatile organic compounds (VOCs) emitted during their baking process. The local regulatory agency requires bakeries that generate over 25 tons of ethanol per year to reduce emissions by 95% by installing control devices on their ovens. The airstream that needed to be treated included ...

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • A Pyrocleaning Furnace and Thermal Oxidizer System

    Abstract A Pyrocleaning Furnace and Thermal Oxidizer System which degreases metal components and comprises an oven, an oxidizer, a system gas supply means, a system gas exhaust means, and a first heat exchanger. The degreasing is accomplished by first transporting the metal components through the oven and exposing the oil coated metal components to hot gases which have a temperature above ...


    By Epcon Industrial Systems, LP

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you