Emissions Data Applications available in Italy
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Dried Milk
Dried milk was dissolved into an aqueous solution for analysis via flame photometry. The test solutions and reference solutions are measured directly following dilution with deionised distilled ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Potassium and Sodium in Wine
Wine is of particular interest nutritionally because it is typically low in sodium and relatively high in potassium. Sodium is the predominant cation in breakfast cereals, at levels reaching 8mg/g. Potassium and calcium also vary, particularly in wheat-based products and those enriched with milk products or calcium ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Determination of Sodium in Biodiesel by Flame Atomic
This method allows the analyte to be pre-concentrated in the final solution, decreases the volume of strong acid used in the dissolution stage and does not use organic ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Carbon footprinting calculations for environmental management
With its expertise in calculating and managing emissions data, CERC offers a range of services to assess greenhouse gas emissions, from determining the carbon footprint of a single industrial process, to compiling a greenhouse gas inventory for a whole geographical area. CERC uses methods and emission factors laid out by the Intergovernmental Panel on Climate Change (IPCC). Emissions from transport, industrial, heating and agricultural activities are calculated and stored using the EMIT software ...
By Cambridge Environmental Research Consultants (CERC) based in Cambridge, UNITED KINGDOM.
-
Premium
Flame Photometer for Determination of Na in Biodiesel using Dry Decomposition for Sample Preparation
The sample of biodiesel is weighed into a crucible and placed in a heating muffle furnace. Two temperatures are used in the heating program for the dry decomposition: the first temperature (250ºC) is maintained for 1 hour to dry the sample. After this the temperature is progressively elevated to 600ºC and maintained for 4 hours to eliminate the remaining organic material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Recommended Sample Handling Techniques & Considerations
Preparation of Glassware: Thoroughly clean and rinse all glassware with the supplied BWB Technologies deionised distilled water to ensure that it is clean and free of extractable sodium and potassium. Glassware should be acid cleaned and rinsed thoroughly in deionised double distilled water prior to use to avoid contamination from extractable metals under ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Fence-Line Monitoring of Fugitive Emissions
The Opsis open path monitoring system is an excellent tool for monitoring air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Flame Photometer for Measurement of Na, K and Ca in Plant Extracts
The most important ions which naturally occur in plant tissues are sodium, potassium, calcium, magnesium, nitrate, sulphate and phosphate. A sample of 5 g of oven-dried plant material contains on average, 25 mg calcium, 9 mg magnesium, 80 mg potassium and 3 mg sodium. The recommended method for the measurement of calcium is to precipitate the calcium as an oxalate, the precipitate is then dissolved and measurement taken from the resulting solution. Sodium and potassium may be measured directly following an ashing ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Potassium and Sodium in Bread
Bread contributes about one-sixth of daily salt intake and is used to improve flavour and texture. The amount of sodium in bread can differ significantly, depending upon brand and type of grain used, ranging from 592mg/100g to 748mg/100g. The level of sodium in bread is primarily due to the amount of salt added to the dough during manufacture. The amount of potassium is determined by the type of flour and the washing and bleaching operations during cereal processing. Bread does not make a significant contribution ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Calcium in Fresh Fruit
In most cases, it was found that flame photometry was well suited for the determination of sodium, potassium and calcium in fresh fruits, using the wet ashing technique as given below. There are significant differences in the composition between different varieties of the same fruit, although these differences are not usually considered to be nutritionally ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Continuous emissions monitoring solutions for palm oil plants
Make more out of your mill. OPSIS tested and approved monitoring systems provide cost-effective and reliable on-line monitoring of several gas compounds, such as both high and low concentrations of methane, moisture, carbon dioxide and hydrogen sulphide, at several ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Flame Photometer for Measurement of Trace Elements in Biodiesel
These methods are adapted from methods for the determination of sodium and potassium in fatty-acid methyl ester samples. The sample is diluted with an organic solvent (xylene, cyclohexane or petroleum ether) plus a stabiliser. The calibration standards which have a similar matrix to the prepared sample solutions, are prepared from sodium and potassium organometallic salts which are dissolved in a solution of xylene with a stabiliser. These European Standards specify a method for the determination of potassium of ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Low Concentrations of Sodium in Cement
This method allows the direct measurement of low levels of sodium without prior extraction procedures, which minimises possible sources of contamination. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Salinity in Processed Foods
Sodium chloride is an essential ingredient of all processed foods; it is needed to enhance flavour and increase shelf life. In many processed foods, additional sodium is added as a flavour enhancer; potassium and calcium are also naturally present but not normally used as processing ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Flame Photometer for Measurement of Lithium Sea Water
The effect of potential interference from other constituents of sea water was studied, including sodium, chloride and potassium. It was found that pre-concentration of the sea water was not necessary prior to analysis. A filtration of the sample was only necessary if sample contained suspended material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Environmental monitoring solution for extractive metallurgy sector
Extractive Metallurgy includes mineral processing, hydrometallurgy, pyrometallurgy, and electro metallurgy processes to separate commercially valuable metals from their ores. Mineral processing includes processes to break down the ore by crushing, grinding, sieving etc. which are often associated with dust generation. Hydrometallurgy involves aqueous solutions for leaching, precipitation, distillation, adsorption, and solvent ...
By Acoem Australasia based in Knoxfield, AUSTRALIA.
-
Intelligent compliance solutions for retail industry
Retailers are increasingly challenged with meeting EHS regulatory compliance obligations and an intense consumer demand for safer, more environmentally-friendly products. Nearly every aspect of a retailer's business is impacted by EHS compliance, which requires knowledge and expertise that is far from a core skill set possessed by most of a retailer's workforce. From sourcing products, to distribution and logistics, to employees handling regulated products, to the proper disposal of hazardous waste, a long list ...
By 3E - SDS and EHS Compliance Data Management Solutions based in Carlsbad, CALIFORNIA (USA).
-
Water Treatment Solutions for Nitrate Removal
Most nitrogenous materials in natural waters tend to be converted to nitrate, so all sources of combined nitrogen, particularly organic nitrogen and ammonia, should be considered as potential nitrate sources. Primary sources of organic nitrates include human sewage and livestock manure, especially from feedlots. The primary inorganic nitrates which may contaminate drinking water are potassium nitrate and ammonium nitrate both of which are widely used as fertilizers. According to the Toxics Release Inventory, ...
By ChartWater™ - A Chart Industries Company based in Duluth, GEORGIA (US) (USA).
-
Marine And Offshore Emissions Monitoring & Analysis
The need to demonstrate environmental responsibility is key for today’s marine and offshore industries. Fuels and exhaust gas emissions are subject to international, regional and national controls and Charterers, as well as the public, demand high standards of performance and ...
By Procal - Parker Hannifin Corp based in Peterborough, UNITED KINGDOM.
-
Gas Detection Solutions for GHG Monitoring
Most sources of fugitive emissions are from multiple points rather than single point sources. So, open path area or perimeter monitoring provides more meaningful fugitive emissions data than an array of point sensors or a program of grab sampling. Point measurements may underestimate emissions because of missing locations with high gas concentrations, or conversely overestimate because they are located in areas of high concentrations. Grab sampling programs typically check only a small percentage of potential leak ...
By Boreal Laser Inc. based in Edmonton, ALBERTA (CANADA).
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you