Only show results available in Virginia? Ok

Environmental Permits Applications

  • Airport Environmental Monitoring

    Water pollution from airport run-off is increasingly coming under public and government scrutiny. As environmental regulations tighten, the ability to monitor for aviation fuel contamination from runway run-off has become essential.

    Monitoring sites at airports can be extremely challenging often with no power or telephone lines available and with limited access for maintenance. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited for this application. Installed at various locations around the airport, deployed with it’s own integrated anti-biofouling system, utilising the GSM network, the monitoring sites send data to a secure ftp site, where any internet enabled device can access the data. In this way the systems act as any early warning system allowing any hydrocarbon discharge to be detected in real-time.

    Optional environmental monitoring features include remote control to allow the user to turn equipment on and off, change the sample rate and detection range. There is also a facility to allow SMS text and email alarm notifications triggered by user-defined set-points together with customised web pages, data displays and automated data downloads via an ftp server.

    Airport runoff can contain high concentrations of various pollutants, in particular polycyclic aromatic hydrocarbons (PAHs) and polychlorinated biphenyls (PCBs), the environmental levels of which have to be monitored. An understanding of the magnitude of contamination due to airport runoff water is important for the effective management of airport infrastructure. Chelsea’s robust UviLux Hydrocarbon Sensor with its low power consumption and high accuracy is ideally suited to the airport environment.

    By Chelsea Technologies Group based in West Molesey, UNITED KINGDOM.

  • Continuous Instream Monitoring

    Turbidity in natural waters is recognized as an important indicator of its environmental health, and because it's a good surrogate for suspended sediment, monitoring turbidity has always been the "holy grail" for hydrologists. But because of earlier technology, "turbidity" has traditionally been a "bad word". The DTS-12 turbidity sensor is the first sensor to make turbidity monitoring practical, and no longer difficult, inaccurate, expensive, or labor-intensive. Turbidity is the cloudiness or murkiness of water caused by suspended organic or inorganic materials. Turbidity in natural waters is recognized as an important indicator of its environmental health.

    By FTS based in Victoria, BRITISH COLUMBIA (CANADA).

  • Premium

    Measurement solution for acrylates speciation

    A customer had a requirement for continuous Ethyl Acrylate monitoring. The process operations emit multiple Acrylate species, all at low concentrations, but only Ethyl Acrylate being reportable to the EA under the terms of the IPC permit. A 204M FTIR analyser was deployed and a chemometric model was built specifically to target Acrylates, with the purpose of separating and accurately quantify the target Ethyl Acrylate species.

    By Protea Limited based in Middlewich, UNITED KINGDOM.

  • Air permit compliance

    A centralized solution for permit regulatory tracking against limits and obligations.

    By Perillon Software Inc. based in Acton, MASSACHUSETTS (USA).

  • Project Manager - Environmental Consulting

    Employee Type: Full-time Employee, open until filled Company: RTP Environmental Associates, Inc., Westbury, New York Req'd Education: Minimum B.S. Meteorology or closely related field Req’d Experience: Minimum 10 years environmental consulting and project management experience. We have a full-time environmental consulting career opportunity for a Project Manager in our Long Island (Westbury) office. RTP is a privately held, multi-disciplinary, full-service environmental consulting firm. We are seeking an experienced professional to join our team of highly experienced technical staff comprised of engineers, chemists, meteorologists, and scientists. RTP offers a work setting that allows room for growth and advancement. The successful applicant will have at least 10 to 15 years of environmental consulting experience as well as project management and marketing experience. The applicant must be well-versed in state and EPA regulations and understand the complexities associated with environmental compliance. The candidate must be motivated and growth oriented with the ability to attract and manage multi-disciplined projects. We are seeking an individual that can work independently and as part of a team. The individual should have progressive environmental experience and excellent communication, project management and client relation skills. The applicant will mentor staff and interact with clients and be an active participant in business development activities. The successful applicant must also have the ability to manage a heavy workload, conduct field work, travel and be on-call as needed. All applicants are required to have at least a B.S. in Meteorology or closely related field. RTP was founded in 1978; our years of experience provide us with excellent knowledge of the complex technical and regulatory issues involved in environmental permitting studies. Our professional staff provides our diverse client base with high quality, responsive and cost-effective consulting services. We offer excellent benefits and a competitive compensation program that rewards performance and results. Our comprehensive benefits program includes: medical and dental, 401k with company match, tuition reimbursement and much more.

    By RTP Environmental Associates, Inc. based in Green Brook, NEW JERSEY (USA).

  • Liquid and dry process silos for hydrofracking industry

    CST provides liquid and dry process silos and tanks for critical frac processes.

    By CST Industries Inc based in Gardena, CALIFORNIA (USA).

  • Wastewater Recycling

    TIGG’s activated carbon wastewater systems allow industry to meet environmental effluent requirements and discharge directly to POTWs or permitted surface waters. In some cases TIGG’s systems are used to recycle wastewater for non potable water applications to lessen demand on local water resources.

    By TIGG, LLC based in Oakdale, PENNSYLVANIA (USA).

  • Environmental data managament & compliance reporting for the manufacturing industry

    Environmental data allows organizations to manage and monitor their compliance with greenhouse gas regulations, the Clean Air Act, the Clean Water Act, the Resource Conservation and Recovery Act, and many others. Additionally, many companies must generate and report environmental data to uphold permits which allow them to conduct their business.

    By enVirSys LLC. based in Littleton, COLORADO (USA).

  • Removal of organic compounds & toxity for wastewater treatment industry

    Federal and State regulatory agencies are increasingly requiring additional water quality testing and controls of the toxicity of discharges to receiving streams. Granular Activated Carbon (GAC) helps meet these pollution regulations. If organic chemicals have been identified as contributing to discharge toxicity, Calgon Carbon Corporation can work with facilities, and their engineering firms, to help meet stringent criteria associated with their NPDES permit. GAC can be employed as a cost-effective treatment for removal of organic compounds and toxicity. Even in situations where activated sludge treatment or powdered activated carbon is used for primary wastewater treatment, post treatment with GAC may be necessary to achieve toxicity compliance.

    By Calgon Carbon Corporation based in Pittsburgh, PENNSYLVANIA (USA).

  • Premium

    Flow monitoring for quarry dewatering compliance

    A Greyline AVFM Area-Velocity Flow Meter monitors and data logs water discharged from the Bray Quarry to the South Raisin River. The Quarry is required to measure flow for environmental permit compliance.

    By Greyline Instruments Inc. based in Long Sault, ONTARIO (CANADA).

  • Premium

    ppm Measurement of Oil in Water for the Petrochemical Industry

    Measuring the oil content in water or soil is a specialty of Wilks Enterprise. InfraCal TOG/TPH Analyzers provide on-site ppm measurements to help ensure upstream or downstream wastewater complies with discharge permits to avoid potentially costly fines. There are over 3,000 InfraCal TOG/TPH Analyzers in operation today around the world measuring the oil and grease levels in produced water on drilling platforms, oil content in FRAC water, hydrocarbons in wastewater effluents from refineries, and TPH in soil at remediation sites.

    By Spectro Scientific based in Chelmsford, MASSACHUSETTS (USA).

  • Premium

    Environment health and safety software for the mining industry

    Intelex software addresses the unique needs of clients throughout the Mining industry. Our mining clients use Intelex to manage a wide range of activites, documents, tasks and data including MSHA requirements, permits, audits, ISO certifications, wastewater discharge, safety citations, and training all from a centralized, web-based portal.

    By Intelex Technologies Inc. based in Toronto, ONTARIO (CANADA).

  • Premium

    Environment health and safety software for the construction industry

    Intelex provides a complete set of software solutions designed to help organizations in the construction industry manage their operational, business and health and safety challenges with ease. Intelex solutions streamline key business processes and save time, money and resources while improving the safety and efficiency of any job site.

    By Intelex Technologies Inc. based in Toronto, ONTARIO (CANADA).

  • Erosion & sediment control solutions for wetlands

    The largest threat to wetlands is the risk of being flooded with sediment as a result of a poorly managed construction site. Most construction projects require erosion control to prevent damage to the wetlands.

    By Erosion Control Forum based in Bend, OREGON (USA).

  • Premium

    Odour nuisance assessment for industrial facilities

    Assessment of odour impacts from industrial facilities is increasingly required for planning and IPPC/EPR permitting.

    CERC carries out odour impact assessments to investigate odour nuisance complaints, to predict the likely impact of new and existing facilities, and to evaluate the impact and cost effectiveness of various odour control strategies.

    In order to carry out a robust assessment of odour impact, whether to evaluate a proposed facility or get to grips with an odour nuisance problem, it is important to establish a clear link between the operation of the plant, the resulting emissions and the odour impact.

    By Cambridge Environmental Research Consultants (CERC) based in Cambridge, UNITED KINGDOM.

  • Premium

    Very large waste gas volumes with low contaminant concentration

    The CTP desorption allows for an especially high concentration factor which, in turn, reduces the cost of ownership and permits an auto-thermal operation (additional burner switched off) even when the contaminant concentration is low.

  • Acid Regeneration Process

    Acid Regeneration Process The commercially most relevant field of application for HCl regeneration processes is the recovery of HCl from waste pickle liquors from carbon steel pickling lines. Other applications include the production of metal oxides such as, but not limited, to Al2O3 and MgO as well as rare earth oxides by pyrohydrolysis of aqueous metal chloride or rare earth chloride solutions. A number of different process routes are available. The most widely used is based on pyrohydrolysis and adiabatic absorption of hydrogen chloride in water, a process invented in the 1960s. However tightening environmental standards and stringent air permit policies render it increasingly difficult to establish new pyrohydrolysis based acid regeneration plants.

    By Insheng Engineering Co., Ltd based in Pingtung, TAIWAN.

  • Air Quality & Emission Management Issues

    • Development of documents substantiating the volumes of emissions of pollutants into the air from stationary sources for enterprises, organizations and private entrepreneurs; • Inventory of air pollutants emissions from stationary sources; • Preparing, maintenance support of documentation for receiving a Permit for Emissions of Pollutants into the Air from Stationary Sources (PEPASS) *, issued by the Departments of Environment and Natural Resources of the regional state administrations of Ukraine; • Development and registration of dust and gas cleaning equipment passports; • Monitoring of the dust and gas cleaning equipment effectiveness; • Quality control of the implementation of projects of Maximum Permissible Emissions (MPE); • Calculation of fees for environmental pollution (environmental tax) on the basis of amount of emission of pollutants into the air.

    By PP `Tehnologia O` based in Vinnytsia, UKRAINE.

  • Issues related to permitting of Special Water Use

    • Preparation and maintenance support of documentation for obtaining a Special Water Use Permit*, which is issued by the Departments of Ecology and Natural Resources of the regional state administrations of Ukraine; • Calculation of individual current standards (technological, balance sheet standards) of water consumption; • Help in execution of state statistical reporting forms: 7-gr (groundwater) and 2-TP (water industry); • Development of project of standards for maximum permissible discharges (MPD) of pollutants from reverse waters into water bodies.

    By PP `Tehnologia O` based in Vinnytsia, UKRAINE.

  • Pulsair`s industrial mixers for oil & lubiricants industry

    Pulsair Systems can custom design a system that mixes and blends tanks of virtually any tank size or configuration. No application is too large or too small. Our fast, efficient and economical Pulsair mixers can give you substantial savings on both electricity and compressed air. Our control systems can operate either single or multiple tanks. Whether it`s blending lubricants, mixing base stock and additives, thinning heavy emulsions or keeping storage tanks at a constant temperature, Pulsair Systems` technology has proven to be dramatically better. Our systems blends lubricants to specification usually within 30 minutes of adding all the ingredients used in your recipe. The result is a greater profit margin for you, the operator.

    By Pulsair Systems, Inc based in Bellevue, WASHINGTON (USA).

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you