Environmental Science Equipment For Environmental Management Available In Northwest Territories
-
ShowcaseManufactured by Gasmet Technologies - a Nederman companybased in FINLAND
Gasmet DX4015 is a portable FTIR gas analyzer for ambient air analysis. The key features of the Gasmet DX4015 include a high sensitivity sample cell for the lowest possible detection limits and a built-in-pump, which means that there is no need to use a separate sampling system. The analyzer can be powered with 12 VDC from for example an external battery, so it can easily be used in field ...
-
ShowcaseManufactured by Royal Eijkelkampbased in NETHERLANDS
Auger set for heterogeneous soils, standard set for augerings to a depth of 5 m. With unpainted augers for environmental ...
-
PremiumManufactured by Suzhou Jono Environmental Technology Co., Ltdbased in CHINA
The mobile trommel screen is used for solid waste screening such as MSW, construction and decoration waste.The mobile drum screen greatly expands the concept of screening operations.Its design tenet is to stand on your side and take the obstacles of operations caused by screening sites and environments as the primary problem, and provide you with efficient and low-cost project operation hardware ...
-
PremiumManufactured by Aralabbased in PORTUGAL
Environmental Rooms, specifically designed for the study of algae and marine organisms, offer accurate control of temperature, light, and other essential environmental conditions. These chambers come equipped with tanks, oxygenation accessories, and can be outfitted with state-of-the-art LED lighting to support comprehensive research on aquatic ...
-
PremiumManufactured by Eureka Water Probesbased in USA
The EasyProbe20 package includes: a multiprobe with the sensors for temperature, dissolved oxygen, conductivity, and pH in a 1.95” diameter; a selection of various lengths of underwater cable; weighted sensor guard, tool and maintenance kit, and a soft carrying ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
With these sets, with conical screwthread connection, undisturbed soil samples can be taken in a thin walled tube applying a stainless steel core sampler with sample tubes and cutting head. In soft soils the sampler is pressed into the soil, possibly using the push-/pull handle. In hard soils the sampler tube can be driven into the soil using the hammer with two nylon heads (shock-absorbing) or ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
In many land use systems all over the world soil deformation is a major problem due to increasing land use intensity. On arable soils machine traffic is continuously intensified with respect to load and wheeling frequency leading to (sub-)soil compaction and deeper soil degradation concerning hydrologic or pneumatic functions. Altered soil functions, in particular reduced hydraulic conductivities ...
-
PremiumManufactured by CETCObased in USA
Welcome to FulFill High-Filler Technologies, the breakthrough solution that is redefining high-filler. FulFill® is not simply a product, but a series of solutions designed to provide you with the ability to increase the amount of filler content in your paper by 1-10%, and beyond. More filler means less dependency on fiber, and that means substantial operational ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
With these sets, with bayonet connection, undisturbed soil samples can be taken in a liner applying a stainless steel core sampler with sample tubes and cutting head. In soft soils the sampler is pressed into the soil, possibly using the push/pull handle. The set contains, among other things: a hand auger for pre- and clean drilling of the bore hole, the core sampler with the sampler tubes, the ...
-
PremiumManufactured by Delta-T Devices Ltd.based in UNITED KINGDOM
The advanced WS-GP2 Automatic Weather Station is based on the powerful GP2 Data Logger. It is an ideal solution for research and environmental monitoring applications at remote and exposed sites. The WS-GP2 provides a highly rugged and flexible system – users can select the optimal combination of sensors, logger, power and ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Sediment core sampler type Beeker, rod operated, with closable cutting head and piston. Standard set for sampling and discharging core samples, length 1 m, in bucket or jars. Suitable for sampling submerged soils to a depth of 5 m of very watery sediment to non-consolidated sand. ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
A correctly dosed fertilization is a condition for high yield and good quality. From economic and ecological perspectives it is therefore necessary to check the state of the soil. After analysis of the samples taken with this set it is possible to determine a fertilization program. Two gouge augers have been included in the set for sampling top ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Using the Akkerman core sampler, samples are taken in stainless steel sampling tubes in auger holes or casing tubes (above as well as under the groundwater level, casing tubes with minimal diameter 100 mm) up to a maximum depth of 50 m. The Akkerman core sampler is used in combination with a tripod and hand winch. The sampling tube is beaten into the soil using a falling hammer. After sampling ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
The profile sampler allows taking of a sizeable and virtually undisturbed sample up to a depth of approximately 40 cm (10 cm wide and 5 cm across). All roots, up to a cross-section of 2 cm, are included in the sample. When sampling, both U-shaped gutters are pushed alternatingly into the soil, until the required depth is reached, after which one side of the handle is pulled sharply upwards and ...
-
PremiumManufactured by Brentwood Industries, Inc.based in USA
Our 2H Splash and Trickle Fills have been specially designed for medium to strongly polluted cooling water, the focus of the development being on a high stability as well as on easy and economical installation. Therefore these fills are built from mechanically joint grids and are easily cleaned. The 2H NET 150 grid packings are high-performance fills which provide an optimized pressure drop. We ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
In principle it is possible to design the soil water permeameters in any required size. The size is determined by the number of soil samples of which the saturated water permeability is to be determined simultaneously. Designs for 5 up to 25 soil sample rings can be supplied. The permeameters are available for soil sample rings with an external diameter of 53 or 60 ...
-
PremiumManufactured by Sauereisen Inc.based in USA
FibreCrete™ Chemical and Food Grade 204 is a fiber-reinforced and chemically- resistant epoxy lining system used to protect concrete and steel from chemical and physical abuse. The interlocking fiber matrix within FibreCrete™ systems contributes outstanding flexural and tensile strengths while significantly reducing permeability. FibreCrete™ may be used in many kinds of ...
-
PremiumDistributed by Interstate Products Inc. / Interstate Productsbased in USA
Economical and environmentally sound solution to metal polishing. Formulated as a light cream containing food grade ingredients. Removes tough, oil-based stains, water marks, spots, and stains from all metal surfaces. Odorless cream clings to vertical surfaces and is safe for use in confined areas such as elevators. Perfect for stainless steel surfaces that may contact water such as drinking ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
Eijkelkamp Soil & Water composed a prospecting kit for general geological surveys. The kit can be used for augerings in heterogeneous soils (agricultural and environmental soil research), to improve the mobility it comprises less different auger types. In this way it can be transported in a carrying bag. All augers, handles and extension rods are packed in a backpack. With this standard kit ...
-
PremiumManufactured by Royal Eijkelkampbased in NETHERLANDS
By applying the bi-partite root auger almost undisturbed, uniform soil samples can be taken in layers of maximal 15 cm. The bi-partite root auger consists of a bottom part fitted with an exchangeable drilling-crown and a short unscrewable top part (handle) with a beating ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you