hazardous area monitor Articles

  • Area Monitoring: Diffusion Sampling

    Indoor and outdoor gas hazards that exist in open areas are usually monitored using diffusion-type sensors. A diffusion sensor has no active sample-drawing system; diffusion sensors rely on the ambient air movement and pressure to deliver the sample to the sensing element. Diffusion-type sensors are a reliable and cost-effective way to monitor open area gas hazards. When installing diffusion ...

  • INTRINSICALLY SAFE WIRELESS MONITORING AND CONTROL NODES ARE CERTIFIED WORLDWIDE FOR USE IN HAZARDOUS AREAS

    INTRINSICALLY SAFE WIRELESS MONITORING AND CONTROL NODES ARE CERTIFIED WORLDWIDE FOR USE IN HAZARDOUS AREAS DX99 FlexPower nodes from Banner Engineering are available in metal housing for gas and dust atmospheres A series of intrinsically safe wireless communication nodes certified for worldwide use in explosive gas or dust atmospheres is available from Banner Engineering. The nodes interface ...


    By Banner Engineering Corp.

  • Flammable Hazards

    Flammable Hazards The difference between a gas and a vapor is that vapors arise from liquids, whereas gases are normally in a gaseous state. Flammable vapors present additional sampling concerns (for example, we must prevent vapors from returning to the liquid state during sampling). The 3 Elements of Fire Three elements must be present for a flammable ...

  • The Area Source Mact/Gact Challenge

    Dozens of new federal rules, regulating over 180 Hazardous Air Pollutants for relatively small sources, present a new and unique challenge for the air pollution profession. Over the past two decades, a large number of federal regulations have been adopted to control Hazardous Air Pollutants (HAPs) originating from a wide range of source categories from the corner dry cleaner to petroleum ...

  • A Two Channel Gas Detector for Monitoring Hazardous Gases in the Workplace

    The potential for exposure to hazardous gases is a concern in many workplace environments. To ensure the safety of the workers, equipment, and the facility, areas presenting a gas hazard should be monitored by gas detectors. Commercial buildings that share a warehouse with manufacturing and/or service work in the back and offices in the front are a prime place for harmful gases and vapours ...

  • Toxic and Hazardous Materials in Electronics

    Untitled Document Introduction In October 2000 Environment Canada released a report called Information Technology (IT) and Telecommunications (Telecom) ...

  • Hazardous water pollution in China

    The people of the Sahecun village in China are currently suffering severe health problems due to dangerously hazardous water. The water pollution has been caused by heavy metal, which is a result of a lead mine that closed down more than ten years ago. Villagers of Sahecun are experiencing dreadfully painful swellings all over their bodies. The heavily polluted water is also causing all kinds of ...


    By Aquaread Limited

  • Paint booths, or areas using combustible gases: why a requirement for combustible gas monitor might be necessary

    Paint booths save time and ensure a smooth and professional application of paint in a range of industries, including automotive, aerospace, home decor, furniture, and more. Combustible gases and fluids in the paint booth environment can pose a health hazard if something goes wrong. Explore the hidden dangers of paint booth fluids and gases, and learn how a ...

  • Hazardous waste and not, Baioni-Dicatech system

    The identification, characterization and restoration of contaminated areas now represent a big environmental issue, both at European and national level. In the major industrialized countries the issue of contaminated land has come out in all its gravity in the late seventies when, against a widespread awakening of environmental consciousness, important pollutions events emerged. Consequently, in ...


    By Baioni Crushing Plants Spa

  • Preparing your company for a hazardous spill

    Documento sin título If a company ...


    By Verisk 3E

  • Ultrasonic algae control solutions to treat smaller water areas

    Algae has an import function in nature, it provides food and energy for animal life, and much of the earth’s oxygen. However, an excess of algae can be hazardous to both humans and animals. Research has demonstrated that ultrasound can be an effective method of controlling algal blooms. Ultrasonic algae control solutions: the differences There are various ...


    By LG Sonic

  • Hazardous Location LEDs in Chemical Manufacturing Facilities

    Employees inside chemical manufacturing plants are exposed to some of the most unforgiving work conditions in the industrial sector. This is because in such environments, workers are exposed to extreme temperatures, dust, volatile chemicals and invisible, explosive gases. Common protection methods against explosive risks include containment, segregation and prevention. Out of all the ...


    By Larson Electronics LLC

  • A Worker Exposed to Spray Resin: Hazardous Substances Case Study

    This case study demonstrates what you, as a worker, may expect when your employer takes various steps as required by the Hazardous Substances Compliance Standard (formerly the Regulation). Your work area will require an assessment of the risks it poses to your health, and you may have monitoring and health surveillance provided. These all produce factual data for control measures to eliminate ...


  • Kay Armstrong Corners the Market in Hazardous Waste Cleanups and Community Relations

    The Comprehensive Environmental Response, Compensation, and Liability Act of 1980 (CERCLA) created the Hazardous Substance Superfund. It was intended to be a short-term program that would spend $1.6 billion over five years to clean up 400 hazardous sites around the country. Instead, more than $17 billion has been spent and only 212 sites (15% of the 1,439 listed since its inception) have been ...


    By ARMSTRONG and Associates

  • Monitoring DMA level case study

    ABIC, a leading provider of veterinary products chooses MonoScan to monitor the level of DMA (Dimethylamine) tank in one of its plants located in Israel. ABIC, wholly owned by Teva Pharmaceutical Industries Ltd, is Israel's largest veterinary products manufacturer. The company produces a wide range of vaccines for poultry and livestock and other animals. ABIC's plants are equipped with ...

  • Workplace Monitoring: Who, What, When, Why, How?

    In my previous articles in this series for SHP readers, I have focussed on the need for current attitudes to general health and safety processes to change and emphasised the importance of regular monitoring. The best way to combat those ‘hidden killers’ and protect our workforces is to increase awareness of the benefits of regular monitoring and detection.  Employees then need to ...


    By Casella

  • The 5 Critical Components Of A Remote Level Monitoring System

    There are a lot of applications for remote level monitoring. Some of them have been around for a while, and the owners, operators, and engineers involved in purchasing remote systems are well versed in the options available and the cost associated. However, as more people learn about the technology and how it can benefit them, there are many who don’t understand what it takes to deploy ...

  • Officials Reduce Chlorine Hazard After EIS Exercise Reveals Potential Danger to Ft. Lewis` Neighbors

    Untitled Document The Challenge: Recently, the LEPC used EIS to ...


    By IHS Markit

  • PureAire Monitoring Systems Obtains UL/CUL Listings on All Oxygen Deficiency Monitors

      PureAire Monitoring Systems manufactures and distributes oxygen monitors for safety, and as of July 2013, most monitors now include UL/CUL listings.  Their monitors make sure oxygen remains at a safe and breathable level in areas that utilize gasses such as nitrogen, dry ice, helium, and argon. These gases, commonly known as cryogenic gases, can be hazardous or ...

  • How To Build A Low Maintenance Remote Level Monitoring System

    If you find yourself visiting a remote tank level monitoringsite for troubleshooting and maintenance too often, then you are losing out on the benefit of having a remote monitoring system. This can happen to you when your sensors and their systems are either inadequate or installed improperly. So ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you