Radiation Contamination Monitoring Equipment For Health And Safety Available In Oregon
-
PremiumManufactured by HI-Q Environmental Products Company, Inc.based in USA
VF’s line of Hand/Foot Contamination Monitors is used to measure the alpha, beta, and gamma contamination on hands and feet. Different types and thicknesses of smart scintillation detectors are used to determine the type of radiation measured and the efficiency of the detectors. Using dual phosphors, the discrimination of alpha from beta activity is ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS 802 consists of a real Thermo Fisher Mini Instruments 900 series with added electronics and cable connector so that it will operate with any STS simulated probe. This probe detects the gas given off by the STS simulant, which has been applied to the surface to be ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS smart interface box allows unmodified meters to be connected to a STS simulation probe. This means that meters do not have to be purchased solely for training purposes and that any of the same series meters can be used with the interface so that the simulator could be shared between end users. The interface box takes the existing cable from the host meter to the appropriate connector with ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS CM11 simulator is a fully functioning real Thermo CM11 that has been modified for use in nuclear contamination training. The unit retains its full range of functions but has additional electronics inside the meter and operates with a simulated STS BP19/DP11 style probe. The monitor which is used for verification of decontamination and identification of contaminated hands and clothing is ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS SPA6 probe is in cylindrical form, 67mm diameter, and 200mm long. It differs from other STS probes, in that it is a self contained detection and interface unit, and can therefore be connected direct to real ratemeters. It contains a six cell MN1500 battery pack which this gives about 10 to 15 hours of operation. The probe is designed to replicate the particular properties of radioactive ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS 44A is a replica of a real 44A probe , but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid simulant spray placed on surfaces and ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS 6150ADK probe is a large area probe, 150mm wide, and 200mm long. It differs from other STS probes, in that it is self contained detection and interface unit, and can therefore be connected direct to real ratemeters. It contains a six cell MN1500 battery pack which this gives about 10 hours of operation. The probe is designed to replicate the particular properties of radioactive surface ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS RadEye Simulation Probes consist of a simulated probe housing STS electronics and cable connector so that it will operate with a real Thermo RadEye SX meter. This probe detects the gas given off by the STS simulant, which has been applied to the surface to be monitored. This “radiation” may be detected by passing the probe close to and slowly over the surface, as would be ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS DP6 is a real Thermo probe , but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid simulant spray placed on surfaces and ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS HP260 is a replica of a real pancake probe , but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid stimulant spray placed on surfaces and ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS RadEye Simulation Probes consist of a simulated probe housing STS electronics and cable connector so that it will operate with a real Thermo RadEye SX meter. This probe detects the gas given off by the STS simulant, which has been applied to the surface to be monitored. This “radiation” may be detected by passing the probe close to and slowly over the surface, as would be done with a ...
-
PremiumManufactured by Bertin Technologiesbased in FRANCE
MiniTRACE CSDF is a unique multipurpose meter for contamination control, survey, dose rate and XRays radiation measurement. The MiniTRACE CSDF is a multipurpose instrument fulfilling the functions of a contamination, survey and dose rate meter. It is designed to improve the detection and the quantification of radiation contamination, making this a frontline tool in the protection against ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS Ludlum Model 3 is upgraded with added electronics and cable connector so that it will operate with any STS simulated probe. This probe detects the gas given off by the STS simulant, which has been applied to the surface to be monitored. This “radiation” may be detected by passing the probe close to and slowly over the surface, as would be done with a real probe when used by a ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS DP2 is a real Thermo DP2 probe, but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid simulant spray placed on surfaces and ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS SBM2D probe may be used with the Digital Canberra MIP10. The Probe has a standard 16 pin fischer connector that plugs directly into the probe port on the instrument. The SBM-2D probe is powered by the instrument and does not require batteries. The probe is automatically turned on when the probe is connected to the meter and the meter is powered on. It is required that the Meter is plugged ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS 43-5 is a real Ludlum probe, but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid simulant spray placed on surfaces and ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS 812 consists of a real Rotem Ram Gene with added STS electronics STS. The instrument detects the gas given off by the STS simulant, which has been applied to the surface to be monitored. This “radiation” may be detected by passing the instrument close to and slowly over the surface, as would be done with a real Ram Gene when used by a skilled operator. Too fast, or too far ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS EP15 is a replica of a real EP15 probe , but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid stimulant spray placed on surfaces and ...
-
PremiumManufactured by Bertin Technologiesbased in FRANCE
The SaphyRAD MS is a multiprobe survey meter with gamma dose rate measurement and contamination detection functions designed for military ...
-
PremiumManufactured by Safe Training Systems Ltd. (STS)based in UNITED KINGDOM
The STS AP3 is a real AP3 probe , but with a STS gas detection head rather than a real detector. STS electronics installed within the host instrument power the gas detection system and the signal generated is displayed on the host instrument as counts. The Probe detects the presence of the STS LS1 liquid simulant spray placed on surfaces and clothing. ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you