Ventilation Systems Equipment For Health And Safety Near Marshall Islands
-
Manufactured by Hydroflux Pty Ltdbased in AUSTRALIA
The Hydroflux GT is a unique product that will remove grease, oils and solids from commercial kitchen wastewater to allow discharge of the wastewater to sewer. It offers a lower footprint than traditional DAF systems and utilises almost half the ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme WS GasPost Series toxic or combustible gas sensor/transmitter measures the concentration of the target gas in an enclosed area and transmits this value to the control panel via a 900MHz or 2.4 GHz wireless ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme Combustible gas sensor/transmitter measures the concentration of the target gas in an enclosed area and produces a proportional analog output signal. The Acme 40-ST Combustible Gas sensor is explosion-proof. The enclosure of the sensor/transmitter is an explosion-proof ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme Quadset Refrigerant Gas Monitor is designed to detect refrigerant leaks in enclosed areas. The Monitor utilizes a sophisticated NDIR sensor specific to any one of the commercially available refrigerants. It can monitor over a range of 0-1000ppm with a resolution threshold as low as 1ppm. The QuadSet can monitor up to four locations in one of two modes of operation, diffusion or ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme REF-IR-ST Sensor/Transmitter is designed to detect the presence of refrigerant leaks in enclosed areas. The REF-IR-ST series employs a high-precision NDIR sensor ideal for gas-specific and accurate measurements of the most commercially used refrigerants. With its 1PPM resolution, 0-1000PPM measuring range, and operating temperature and humidity characteristics, the REF-IR-ST far exceeds ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme TwinSet and its microprocessor-based system feature a high-quality stand-alone controller providing all the necessary hardware for the continuous monitoring of two gases in the following combinations: CO/CO, CO/CO2, CO/ NO2, CO/COMB. This unit is primarily geared towards providing alarm-activated relays for simple applications such as small parking ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme Volatile Organic Compounds Detector, REF-IR-ST Sensor/Transmitter, is designed to detect the presence of refrigerant leaks in enclosed areas. The REF-IR-ST series employs a high-precision NDIR sensor ideal for gas-specific and accurate measurements of the most commercially used refrigerants. With its 1PPM resolution, 0-1000PPM measuring range, and operating temperature and humidity ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme GasPost toxic gas sensor/transmitter measures the concentration of the target gas in an enclosed area and produces a proportional analog output ...
-
PremiumManufactured by Acme Engineering Prod. Ltd.based in CANADA
The Acme UniSet, with its microprocessor-based system, features a high-quality stand-alone controller providing all the necessary hardware for the continuous monitoring of a variety of toxic and combustible gases. This unit is primarily geared towards providing alarm-activated relays for simple applications such as small parking ...
-
Manufactured by P S Analytical Limitedbased in UNITED KINGDOM
The chloralkali industry produces chlorine and caustic soda for awide range of industrial uses. Caustic soda (NaOH) is the Chemical Industry’s most important alkali. There are three technologies used for the manufacture of caustic soda, namely, mercury cell, diaphragm cell and membrane cell. The mercury cell process is historically the oldest technique and predominates with over 350 plants ...
-
Manufactured by Dust Collection Services Pty Ltdbased in AUSTRALIA
The principle of wet scrubbing systems as a means of fume and dust extraction has been implemented for many years. Generally, it has been accepted that the collection efficiency in wet scrubber units is dependent on the energy applied to the particles by the scrubber action. For best efficiency, DCS uses a down flow venturi principle to promote turbulent contact and mixing of the water with the ...
-
Manufactured by Dust Collection Services Pty Ltdbased in AUSTRALIA
The well designed and engineered ducting system is a key part of an efficient and sustainable dust extraction system. There are numerous elements that need to be considered before installation of a ducting onto a dust extraction system. A ducting system can be connected to numerous hoods, machines or conveyors and a well-engineered system is ...
-
Manufactured by Rotork plcbased in UNITED KINGDOM
Rotork Instruments has been providing critical components and safety systems to the rail industry for over 20 years. They range from a simple manual system to an advanced full automated control ...
-
Manufactured by Muntersbased in USA
DF 2100 is a ready-to-install droplet separator for use in many application areas. It is available in various material combinations and configurations to fit a wide range of operating conditions. DF 2100 droplet separator provides high efficiency droplet separation and low pressure drop, even at high face velocity, for energy saving operation. The droplet separator can be configured to most ...
-
Manufactured by Muntersbased in USA
By installing the high efficiency EC motor known as ‘Munters Drive’ on the Euroemme® EC52 cone fans Munters has reached the highest level of efficiency and air flow. The electric motor Munters Drive bases its operating principle on Electronically Commutated technology (EC) and represents the latest solution in high efficiency electric motor, offering high performance and low ...
-
Manufactured by Muntersbased in USA
DF 2800 is a ready-to-install droplet separator for use in many application areas. It is available fit a wide range of operating conditions. DF 2800 droplet separator provides high efficiency droplet separation and extreme low pressure drop even at medium face velocities giving energy saving operation. The droplet separator can be configured to most individual performance and installation ...
-
Manufactured by Muntersbased in USA
The EXTRUdek water distribution system from Munters provides highly durable means of mounting 150mm thick CELdek® evaporative cooling pads and supplying water to the pads. Together these form an ideal complete system for incorporating evaporative cooling into the ventilation system of a structure. Corrosion of metal parts is a frequent problem amongst gutters used to mount evaporative cooling ...
-
Manufactured by Muntersbased in USA
DCF is a series of advanced tailor made ready-to-install air intake systems for use in many application areas. They provide excellent protection against all types of droplets as well as particle filtration throughout a broad range of face ...
-
Manufactured by Muntersbased in USA
DF 3800 is a ready-to-install droplet separator for use in many application areas. It is available in stainless steel and aluminium combinations and configurations to fit a wide range of operating conditions. DF 3800 droplet separator provides high efficiency droplet separation and extreme low pressure drop even at medium face velocities giving energy saving operation. The droplet separator can ...
-
Manufactured by Muntersbased in USA
DF 4800 is a ready-to-install droplet separator for use in many application areas. It is available in stainless steel and aluminum combinations and configurations to fit a wide range of operating conditions. DF 4800 droplet separator provides high efficiency droplet separation and extreme low pressure drop, even at medium face velocities, for energy saving ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you