Only show results in Massachusetts? Ok

Aerosol Monitoring Applications

  • Premium

    Low level measurement of VOCs and Terpenes close to the sea and the Landes Forest

    It has been established that organic aerosol (OA) makes up for a major fraction of fine particulate matter in all region of the atmosphere. This fraction accounts approximately for half of the total PM2.5 dry mass.1,2 Primary OA is directly emitted in the troposphere from anthropological and natural sources whereas secondary OA (SOA) is formed in-situ in the atmosphere from the oxidation of biogenic or anthropogenic gas-phase precursors and subsequent partitioning of the less volatile products into the particle...

    By Chromatotec Group based in Val de Virvée, FRANCE.

  • Premium

    Aeration and mixing technologies for oil and gas wastewater treatment

    As more hydraulic fracturing wells come into operation, the stress on surface water and groundwater supply increases. The expanding volume of wastewater created needs to be captured, disposed of, or recycled in an environmentally sustainable manner so the EPA continues to increase regulations. We will work with you to create a comprehensive solution to treat your wastewater, meet increasingly strict governmental regulations, and support long term water life cycle management.

    By Aeration Industries International (AII) based in Chaska, MINNESOTA (USA).

  • Premium

    Air quality monitoring

    To estimate the effects of aerosols on health and climate, it is essential to know their chemical composition. Sampling is done using two different types of aerosol collector. The first type are filter collectors that are based on the deposition of suspended particles on surfaces; the second type are powerful aerosol collectors.

    By Metrohm AG based in Herisau, SWITZERLAND.

  • Premium

    Aeration and mixing technologies for activated sludge systems

    The activated sludge process uses a mass of organisms to aerobically treat wastewater and is used to remove biodegradable organics from both municipal and industrial wastewaters.

    By Aeration Industries International (AII) based in Chaska, MINNESOTA (USA).

  • Premium

    Coriolis Air Sampler for Food/Pharma/Veterinary Industry

    Coriolis air sampler collects biological particles in the air for air quality control and monitoring in an industrial process

    By Bertin Instruments based in Montigny-le-Bretonneux, FRANCE.

  • Premium

    Coriolis Air Sampler for Research and Development

    Coriolis air sampler collects biological particles in the air for fundamental research on biological airborne particles

    By Bertin Instruments based in Montigny-le-Bretonneux, FRANCE.

  • Premium

    Meteorological sensors for dust monitoring

    Air is lifeblood. Daily we inhale approximately 15.000 liter. Still, the air contains invisible pollutants, which vary in its composition and concentration depending on the location. Especially the respirable particles with a diameter of less than 2.5 µm (PM 2.5) were considered to be particularly dangerous.

    By OTT HydroMet based in Kempten, GERMANY.

  • Premium

    Channel networks solutions for replacement of measurement with inverted syphon sector

    Rectangular concrete channel, approx. 2.5 x 2.5 m (w x h). Part filled. Impoundage shield installed later in the channel with inverted syphon and EMF DN 800.

    By NIVUS GmbH based in Eppingen, GERMANY.

  • Premium

    Particulate matter, halogens and aerosols

    Example: Production of anodes for aluminium smelters as well as electronic industry (TFT-LCD). Similar tasks: Carbon and graphite industry, smelting of aluminium, coating of metals.

  • Premium

    Air pollution, emission and process monitoring systems for chemicals

    ENVEA’s long standing involvement with manufactures of powdered chemicals such as TiO2 and carbon black has led to the development of a wide range of ambient, emission and process monitoring systems designed to overcome often challenging monitoring conditions including acidic condensation and potential contamination. Approved measurement and monitoring systems not only protect our environment by meeting and exceeding regulatory requirements but also provide valuable feedback on process performance providing...

    By ENVEA based in Poissy, FRANCE.

  • Premium

    Odour nuisance assessment for agricultural facilities

    Assessment of odour impacts from agricultural facilities is increasingly required for planning and IPPC/EPR permitting. CERC carries out odour impact assessments to investigate odour nuisance complaints, to predict the likely impact of new and existing facilities, and to evaluate the impact and cost effectiveness of various odour control strategies. In order to carry out a robust assessment of odour impact, whether to evaluate a proposed facility or get to grips with an odour nuisance problem, it is important to...

    By Cambridge Environmental Research Consultants (CERC) based in Cambridge, UNITED KINGDOM.

  • Cleanroom Solutions from Concept Smoke Systems

    The correct functioning of HEPA filters is normally tested at the time of installation, as well as part of the routine maintenance programme. It is normally recommended that HEPA filters are checked at 14 month intervals or less, or immediately after filter changing. Where high efficiency filters are fitted, it is vital that the filter housing/sealing device does not allow particulate material to pass and thereby compromise the cleanroom environment that is being served. Testing is necessary since HEPA filters...

    By Concept Smoke Systems | Concept Engineering Ltd. based in Maidenhead, UNITED KINGDOM.

  • High performance separation system for alkylation unit

    The key aspects of an alkylation unit pertain to the amount of acid that needs to be made-up on a continuing basis.

    By Pentair Filtration Solutions, LLC based in Conroe, TEXAS (USA).

  • Particle measurement and sampling equipment for Air quality

    Dekati® Solutions for air quality particle measurements include both air quality monitoring and atmospheric aerosol research instruments. Our aerosol measurement solutions have been successfully used in various ambient aerosol research and monitoring areas for over 25 years and today, our instruments are used globally by thousands of customers both in research and industry to measure different properties of airborne particles

    By Dekati Ltd. based in Kangasala, FINLAND.

  • Laser Based Remote Sensing Instruments for Remote Visibility / Fog

    Aerosol LIDARs can provide visibility measurement, including Slant Visual Range (SVR - visibility up the glide slope), Runway Visual Range (RVR), and Vertical Optical Range (VOR - visibility at the decision point). LIDARs offer remote detection, augmenting current sensors wherever visibility is an issue, including for airports, ports, and oil platforms. Using the same principle, they are also capable of detecting incoming fog.

    By Raymetrics S.A. based in Athens, GREECE.

  • Aerosol and particle technology for automotive industry

    Especially in the field of automotive industry the application of modern particle measuring technology is essential in the domains of quality control and development.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Aerosol and particle technology for pharmacy industries

    In the field of inhalation research it is necessary to characterize unambiguously the inhalable aerosols regarding particle size distribution and concentration.

    By Palas GmbH based in Karlsruhe, GERMANY.

  • Calibration of online particle sensors and measuring systems

    Optical particle counter. Light scattering sensors (mass, size). Condensation particle counter (CPC, number). Scanning mobility particle sizer (SMPS, size, number). ELPI. Diffusion charging sensor (DC, active surface). Epiphaniometer (active surface). Aethalometer (BC, black carbon). Photoelectric aerosol sensor (PAS). Personal samplers for coulometric carbon analysis. Betameter (Mass). Referent material for EC and OC.

    By Jing Ltd. based in Zollikofen, SWITZERLAND.

  • Cloud and Aerosol Instrument for visibility and fog industry

    Diminished visibility is a major cause of traffic accidents on roadways and cancelled or significantly delayed flights at airports. The source of the deterioration in visibility is the presence of aerosol and cloud (fog) particles in sufficient concentrations to attenuate visible radiation. Mitigating the impact of limited visibility requires better understanding the optical properties of aerosols and fog and improved forecasting of such events in order for drivers to be forewarned and airports to better schedule...

    By Droplet Measurement Technologies (DMT) based in Longmont, COLORADO (USA).

  • Aerosol and particle technology for pressure & temperature industries

    The reproducibility of the devices has been approved by worldwide use. In order to avoid the condensation or vaporization of the particles during the particle measurement, the isothermal and isobaric particle generation and measurement is necessary.

    By Palas GmbH based in Karlsruhe, GERMANY.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you