Monitoring & Testing Applications available in Central African Republic
-
Premium
Spectrometric Monitoring for Air and Water
Spectrometric monitoring offers a continuous operating measurement system for nuclide specific detection of low level gamma contamination in air and in ...
By Bertin Technologies based in Montigny-le-Bretonneux, FRANCE.
-
Premium
Emissions Monitoring for Power Plants
Opsis offers fully automated system solutions for continuous monitoring in power plants. The monitoring systems have been approved by the German TÜV and the U.S. EPA among ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Precipitation Measurement with GPRS Transmission for Channel Networks - Fix Installation Measurements
Investigation of precipitation volumes for billing purposes within a water association consisting of several communities. Setup of 7 precipitation measurement spots to detect stormwater volumes. Transmission of detected data to central access point via GPRS ...
By NIVUS GmbH based in Eppingen, GERMANY.
-
Premium
Wastewater Monitoring for Municipal WWTP - Real-time BOD, COD, TSS and more
Wastewater quality can change drastically and quickly – particularly in the case of industrial discharges – that generate shock loads within the wastewater treatment system. In addition to potential operational problems such as increased chemical and aeration demand, shock loads also have the potential to affect regulatory compliance if wastewater cannot be treated properly. Real Tech’s BOD/COD monitoring systems provide continuous online measurement of COD and/or BOD, which are the most relevant parameters to ...
By Real Tech Inc. based in Whitby, ONTARIO (CANADA).
-
Premium
Compressed air and industrial gases solutions for manufacturing of materials sector
Ensure and improve production capacity using a flow meter in the industry of materials manufaturing. A flow meter show you where, when and how much how you can optimize and thus save ...
By VPInstruments based in Delft, NETHERLANDS.
-
Premium
Respirometry system for anaerobic biochemical methane production
Anaerobic biodegradation tests – often referred to as Biochemical Methane Production (BMP) tests – involve addition of known amounts of a chemical or wastewater to anaerobic cultures. The quantity of methane production – relative to that from a control – indicates the biodegradation potential. This case study shows methane production for a Control reactor and three test reactors that were operated at 20-, 30- and 45-day retention times and received three doses of industrial wastewater. The ...
By Respirometer Systems and Applications, LLC (RSA) based in Fayetteville, ARKANSAS (USA).
-
Premium
Water level measurement for water monitoring consulting
By Sommer Messtechnik based in Koblach, AUSTRIA.
-
Premium
Air sampling & monitoring systems for defense/military sector
From portable hand held battery operated to rugged field deployable, military organizations worldwide rely of HI-Q air sampling systems & accessories during research, development, test and evaluation (RDT&E) and for reliable protection of personnel from Nuclear Biological Chemical Threats. HI-Q’s emergency response air sampling kits have offered the Defense & Military Industries a way of recognizing, determining and identifying the presence of harmful Biological & Nuclear ...
By HI-Q Environmental Products Company, Inc. based in San Diego, CALIFORNIA (USA).
-
Premium
Gas analyzers for odor monitoring
The odor market usually asks a spot measurement using dynamic olfactometry. This method uses human nose to quantify odor as global fingerprint. Chromatotec has developed a new solution for continuous monitoring as a complementary solution to the human nose. The vigi e-nose analyzer allows to monitor sulfurs compounds with speciation in addition to total VOC and odor index. Correlation with human nose according to EN 13725 method are defined site per ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
Emission control solutions for biomass dryers sector
The drying of biomass is common to many industries, including wood pellet making, panel boards and many others, from coffee to olive-oil or animal feed. Technologically, these industries operate drum / rotary dryers to dry biomass. It can be a raw-material or a fuel for the manufacturing process. The pellet making industry presents a typical general arrangement which is replicated in other industries. It includes a “dryer” cyclone after a rotary dryer which is heated by a furnace (generally burning ...
By Advanced Cyclone Systems, S. A. (ACS) based in Porto, PORTUGAL.
-
Premium
Gas analyzers for odor: bad smell
The aim: analysis of H2S ppb and mercaptans with the TRSMEDOR because of the bad smell of ...
By Chromatotec Group based in Val de Virvée, FRANCE.
-
Premium
Air pollution, emission and process monitoring systems for chemicals
ENVEA’s long standing involvement with manufactures of powdered chemicals such as TiO2 and carbon black has led to the development of a wide range of ambient, emission and process monitoring systems designed to overcome often challenging monitoring conditions including acidic condensation and potential contamination. Approved measurement and monitoring systems not only protect our environment by meeting and exceeding regulatory requirements but also provide valuable feedback on process performance providing ...
By ENVEA based in Poissy, FRANCE.
-
Premium
Determination of 4-carboxybenzaldehyde & p-toluic acid in purified terephthalic acid according to ASTM D7881 & ASTM D7882 test methods
Introduction These test methods cover the determination of 4-carboxybenzaldehyde (4-CBA, 4-formylbenzoic acid) and p-toluic acid (p-TOL, 4-methylbenzoic acid) in purified terephthalic acid (PTA) by capillary electrophoresis (CE) with normal or reverse voltage mode and UV ...
By Lumex Instruments based in Mission, BRITISH COLUMBIA (CANADA).
-
Premium
Marine monitoring solutions for the SO2/CO2/NOx monitoring
Process control of a SO2 scrubber on a ship is a challenge due to wet and corrosive gases. In such environment, extractive gas sampling systems require high levels of maintenance in order to operate correctly. OPSIS monitoring system solves this by using an optical, non-contact, cross-duct technique. A light beam is sent across the duct or stack to be measured, and the captured light is sent through an optical fibre cable to an analyser. The analyser measures SO2, CO2 and NOx concentrations using UV and IR ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Fully-automated gas chromatographs solutions for stack emissions monitoring sector
Synspec GCs can also be used as continuous emission monitoring systems (CEMS). In general, emissions from stacks are in the higher ranges of concentrations to be measured. Synspec equipment, which is usually geared towards very low detection levels, can be tuned to the concentration ranges that are emitted at your production plant. Depending on the composition of the emissions a sample treatment might be ...
By Synspec BV based in Groningen, NETHERLANDS.
-
Premium
ADVANCEES - Ion Exchange Reduction Water treatment purification equipments
Ion exchange is an exchange of ions between two electrolytes or between an electrolyte solution and a complex. In most cases the term is used to denote the processes of purification, separation, and decontamination of aqueous and other ion-containing solutions with solid polymeric or mineralic ‘ion ...
By Advanced Equipment and Services, Inc based in Coral Springs, FLORIDA (USA).
-
Premium
Direct atomic absorption mercury determination in tissues and biological samples
INTRODUCTION Mercury and its compounds are highly toxic substances fo r humans. It occurs naturally and exists in various forms: elemental (or metallic); inorganic (e.g. mercuric chloride); and organic (e.g., methyl- and ethylmercury). These forms all have different toxicities and implications for health. Among naturally occurring mercury compounds, methylme rcury exerts a significant influence (neurotoxic action) on human ...
By Lumex Instruments based in Mission, BRITISH COLUMBIA (CANADA).
-
Premium
Flame Photometer for Determination of Na in Biodiesel using Dry Decomposition for Sample Preparation
The sample of biodiesel is weighed into a crucible and placed in a heating muffle furnace. Two temperatures are used in the heating program for the dry decomposition: the first temperature (250ºC) is maintained for 1 hour to dry the sample. After this the temperature is progressively elevated to 600ºC and maintained for 4 hours to eliminate the remaining organic material. ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Application package FLUXANA Continous Casting Powder
This application package is a 'ready to go' calibration kit for xrf instruments. Together with the company Stollberg, FLUXANA has developed a fused bead method for the product control of continuous casting (CC) powders. The general idea was a universal program which covers a wide product range and that is also able to control the used raw materials. The result was two different application packages each with a set of standards and a set of control ...
By Fluxana GmbH Co. KG based in Bedburg-Hau, GERMANY.
-
Premium
Recycling equipment for shredding electronic scrap (E-scrap)
Processing electronic scrap (E-Scrap or WEEE) presents special challenges. Computers, consumer electronics, and IT equipment need to be destroyed to extract recyclables or ensure the security and complete destruction of the product. Hard drives, tapes and data storage devices must be completely destroyed to provide data security. And, while many electronic scrap items do not require the specific size reduction that hard drives or other data storage devices require, all electronic scrap includes recoverable ...
By Granutech-Saturn Systems based in Grand Prairie, TEXAS (USA).
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you