Monitoring & Testing Applications
-
Premium
Continuous emissions monitoring solutions for special applications CEM
OPSIS is a world-leading supplier of CEMS (continuous emissions monitoring systems) for various special applications in the industrial emissions sector. The OPSIS gas monitoring systems have been tested and approved by a range of international authorities, and has proven to have the best performance and longest calibration intervals. We specialise in the design and supply of high accuracy, low maintenance, cross-duct, non-extractive CEM systems. We also provide additional products and services, including dust and ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
ADVANCEES - High TDS Reduction - Custom skid-mounted water purification equipments
There are potential health effects caused due to high TDS content in drinking water. The hard water will taste bitter, salty, or metallic and may have unpleasant odors. High TDS water is less thirst quenching. High TDS interferes with the taste of foods and beverages, and makes them less desirable to consume. Some of the individual mineral salts such as Nitrates, Sodium, Sulfates, Barium, Cadmium, Copper and Fluoride that make up TDS pose a variety of health hazards such as causing stiffness in the joints, ...
By Advanced Equipment and Services, Inc based in Coral Springs, FLORIDA (USA).
-
Premium
Application package FLUXANA Cement, Raw Meal, Clinker
This application package is a 'ready to go' calibration kit for xrf instruments. It can, for example, contain all parts to perform a complete cement calibration: - Calibration set cement prepared from CRM as glass beads - Calibration work performed by FLUXANA expert 2 days on site - 2x drift monitors for xrf instrument - 2x control samples for validation - Flux FLUXANA application packages include always the sample preparation method. All packages are running in our application laboratory. You are always free to ...
By Fluxana GmbH Co. KG based in Bedburg-Hau, GERMANY.
-
Premium
Respirometry system for determination of biodegradation kenetics
Intrinsic kinetic tests involve adding relatively high concentrations of organic substrate to small concentrations of acclimated microorganisms so that the COD/VSS ratio typically is greater than 10. Kinetic parameters are then determined by non-linear modeling using well-known relationships between biological growth and oxygen ...
By Respirometer Systems and Applications, LLC (RSA) based in Fayetteville, ARKANSAS (USA).
-
Premium
Gas monitoring instruments and systems for engine emissions measurements
The exhaust gas from combustion engines is a complex mixture of gases and particulate matter. The composition of the gas may change rapidly. Multicomponent analysis of exhaust gases can be performed with a Gasmet™ FTIR Gas Analyzer with a response time (T90) of one second. The winning combination is the result using of a small volume gas sample cell, a powerful sample pump and a fast detector with liquid nitrogen cooling. The analyzer, sampling system and computer can be assembled on a cart for use in a ...
By Gasmet Technologies - a Nederman company based in Vantaa, FINLAND.
-
Premium
Flowing Waters - Special Constructions solutions for Contactless Flow Measurement on Fish Ladder
Application: Concrete intake channel. 3.0 x 2.0 m (w x h). Part filled. Gravel ...
By NIVUS GmbH based in Eppingen, GERMANY.
-
Premium
Indoor air quality treatment solutions for casinos and gaming sector
Casinos are invaded by offensive Odors such as: Smoke, Alcohol, Cooking, Spill, Body, Bacterial, Fungal, Mold, & mildew, etc. Casinos compete to attract clients and provide pleasant environments where customers will be comfortable staying for extended periods of time. Unfortunately, most ventilation systems only recirculate room air and remove large particulate matter such as dirt, dust, and lint. Unpleasant restaurant and bar odours are left free to recirculate in the air you breathe and could increase in ...
By Chemtronics Technologies (India) Pvt. Ltd. based in Mumbai, INDIA.
-
Premium
Separation Layer Measurement in Primary Clarifier solutions for Wastewater Treatment Plant - Preclarification
Application: Rectangular basin 30 m x 8.5 m with two outlet funnels. Basin depth 2.8 m. Funnel depth 5.8 ...
By NIVUS GmbH based in Eppingen, GERMANY.
-
Premium
Flame Photometer for Measurement of Sodium and Potassium in Cheese
Cheese was wet ashed with a combination of acid and a high temperature oven to form a dissolvable product ready for analysis via flame ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
-
Premium
Fence-Line Monitoring of Fugitive Emissions
The Opsis open path monitoring system is an excellent tool for monitoring air quality, fugitive emissions and gas leaks at industrial sites. By arranging monitoring paths strategically at locations outside the borderline of an industrial area, fugitive emissions and gas leaks will effectively be detected. By combining the measured gas data with meteorological parameters information such as where the pollution sources are located and the strength of the emissions can be calculated, using the EnviMan ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
NMR technology solutions for GMR Surface NMR instruments sector
Direct, Non-invasive Detection and Imaging of Groundwater to Depths of up to 500 feet (150 Meters). Surface magnetic resonance (also known as surface NMR, proton magnetic resonance and magnetic resonance sounding) is a powerful ground-based geophysical method used to non-invasively detect, measure and image groundwater. Vista Clara’s GMR and GMR-Flex multi-channel surface NMR instruments work by using the same physics as medical MRI. Surface magnetic resonance measures hydrogen protons in groundwater to ...
By Vista Clara, Inc based in Mukilteo, WASHINGTON (USA).
-
Premium
Continuous emissions monitoring solutions for sulfuric acid production plants
The process control of a sulfuric acid plant needs good and reliable detection of gas phase sulfur dioxide (SO2). To measure SO2 is a challenge due to the corrosive environment and high concentration of SO2. Several places in the process needs to be monitored and to transport the sample gas is difficult. A large dynamic range is needed as the SO2 concentration can vary between 15% volume and a few mg/m3. Most systems installed need a lot of maintenance, sometimes as often as every ...
By OPSIS AB based in Furulund, SWEDEN.
-
Premium
Visual inspection solutions for automotive industry
In the automotive field, borescopes used for remote visual inspection, make it possible to investigate a variety of problems without tearing apart the entire engine block. This allows you to inspect the internal components of the engine for carbon deposits, wear and tear, to pinpoint sources of unwanted noise, identify corrosion and confirm component failure. Routine quality control inspections at the production stage should also occur frequently. Sites include fuel injector nozzles, cast cylinder heads and ...
By Fiberscope.net by Medit Inc. based in Winnipeg, MANITOBA (CANADA).
-
Premium
Environmental Data Monitoring Solutions for Indoor Air Quality
We spend almost 80% of our time indoors (houses, transport, work/school). Potential sources of pollution are numerous: building and furniture materials, human activity (smoking, cleaning products, DIY, kitchen), outside air and combustion devices. All these sources release different types of harmful chemicals: carbon monoxide, CO2, nitrogen oxides, sulfur oxides, volatile organic compounds (benzene, ketones). ECOMESURE offers instruments that measure the air quality in public areas such as stations, shopping ...
By Ecomesure based in Saclay, FRANCE.
-
Premium
Fully-automated gas chromatographs solutions for soil sanitation sector
Clean up of soil pollutants often involves the air extraction of the contaminated ground. By measuring the concentration of VOCs in the air, the progress of the cleaning process can be monitored and optimised. The robust Synspec analysers monitor the recovery process of the ...
By Synspec BV based in Groningen, NETHERLANDS.
-
Premium
Process instrumentation and analytics solutions for chemical industry
Few industries face requirements as extreme as the chemical industry. Operating in harsh environments calls for robust and high-quality equipment that enables efficient and fail-safe operation. With Siemens’ comprehensive instrumentation portfolio you can achieve just ...
By Siemens Industry, Inc. - Process Analytics based in Houston, TEXAS (USA).
-
Premium
Oil Spill Bioremediation
The OSEI Corporation manufactures a first response bioremediation product Oil Spill Eater II that has been used to clean up leaks around storage tanks from valve breaks, line breaks and small holes in tanks, as well as for tank sludge clean outs. OSE II has been cleaning up oil/hydrocarbon based spills including heavy oils, sludge, drilling mud, tailings as well as refined product since ...
By OSEI - Oil Spill Eater International, Corp based in Dallas, TEXAS (USA).
-
Premium
Trilite - Ion Exchange Resin for Pharmaceutical & Biotechnology
TRILITE® ion exchange resins and synthetic adsorbents can be used in various separation and purification processes for pharmaceuticals and food raw materials. Some representative examples are as ...
By Samyang Corporation based in Jongno-gu, SOUTH KOREA.
-
Premium
Application package FLUXANA Silicon Carbide
FLUXANA application packages include always the sample preparation method. All packages are running in our application laboratory. You are always free to send your samples for testing free of charge. If you combine our application packages with our sample preparation machines FLUXANA garanties the analytical performance of the package like a ...
By Fluxana GmbH Co. KG based in Bedburg-Hau, GERMANY.
-
Premium
Flame Photometer for Measurement of Trace Elements in Biodiesel
These methods are adapted from methods for the determination of sodium and potassium in fatty-acid methyl ester samples. The sample is diluted with an organic solvent (xylene, cyclohexane or petroleum ether) plus a stabiliser. The calibration standards which have a similar matrix to the prepared sample solutions, are prepared from sodium and potassium organometallic salts which are dissolved in a solution of xylene with a stabiliser. These European Standards specify a method for the determination of potassium of ...
By BWB Technologies Ltd. based in Newbury, UNITED KINGDOM.
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you